POLAR WEARLINK+
TRANSMITTER NIKE+
User Manual
ENGLISH
Polar WearLink®Transmitter Nike+
This user manual contains instructions for the
Polar WearLink transmitter Nike+. The heart
rate sensor is compatible with Nike + iPod,
Nike+ SportBand and Polar training computers
using GymLink technology, such as FT80,
FT60, RS300X, and CS400. For detailed list of
compatible products.
The latest version of this user manual can be
downloaded.
Please follow the pictures on the front cover.
Heart Rate Sensor Parts
1. The plastic electrode areas on the reverse
side of the strap detect heart rate. Picture
A1.
2. The connector sends the heart rate signal
to the receiving device. Picture A2.
WearLink heart rate sensors enable training in a
group without interference from other heart rate
sensors.
Wear the Heart Rate Sensor
1. Moisten the electrode areas of the strap.
Picture B1.
2. Attach the connector to the strap. Picture
B2.
3. Adjust the strap length to fit tightly but
comfortably.
1
4. Tie the strap around your chest, just below
the chest muscles, and attach the hook to
the other end of the strap. Picture B3.
5. Check that the moist electrode areas are
firmly against your skin and that the Polar
logo of the connector is in a central and
upright position. Picture B4.
Detach the connector from the strap and rinse
the strap under running water after every use.
See detailed washing instructions in the Caring
for Your Heart Rate Sensor section.
Linking the Heart Rate Sensor with Nike +
iPod
Nike + iPod -compatible heart rate sensors are
sold separately from the Nike + iPod Sport Kit
and the Nike + iPod sensor. Nike + iPod
compatible heart rate sensors can be used with
iPod nano (5th generation or newer).
Before using the heart rate sensor for the first
time, you must link it to your iPod nano
receiver:
• iPod nano (5th generation or newer):
Connect your Nike + iPod receiver to your
iPod nano, choose Nike + iPod > Settings >
Heart Rate Monitor > Link, and follow the
on-screen instructions.
Unlinking the heart rate sensor:
• iPod nano: Choose Nike + iPod > Settings >
Heart Rate Monitor > Unlink, and follow the
on-screen instructions.
Linking the Heart Rate Sensor with Nike+
SportBand
Nike+ SportBand -compatible heart rate sensors
are sold separately from the Nike SportBand.
Before using the heart rate sensor for the first
time, you must link it to your Nike+ SportBand:
2
1. Wear the heart rate sensor. Make sure there
are no other shoe sensors or heart rate
sensors nearby.
2. Press and hold the TOGGLE button on the
Nike SportBand for 3 seconds. A blinking
Link message appears on the SportBand
display, followed by OK.
For more information on the Nike+ SportBand,
see the complete manual available at
nikeplus/downloads.
Caring for Your Heart Rate Sensor
The heart rate sensor is a high-tech instrument
that should be handled with care. Follow the
caring instructions to ensure reliable
measurement and to maximize the life span of
the heart rate sensor. The following instructions
will help you fulfill guarantee obligations.
Connector: Detach the connector from the strap
after every use and dry the connector with a soft
towel. Clean the connector with a mild soap and
water solution when needed. Never use alcohol
or any abrasive material (eg. steel wool or
cleaning chemicals).
Strap: Rinse the strap under running water after
every use and hang to dry. Clean the strap
gently with a mild soap and water solution when
needed. Do not use moisturizing soaps, because
they can leave residue on the strap. Do not
soak, iron, dry clean or bleach the strap. Do not
stretch the strap or bend the electrode areas
sharply.
Dry and store the strap and the connector
separately, to maximize the heart rate sensor
battery lifetime. Keep the heart rate sensor in
a cool and dry place. Do not store the heart rate
sensor wet in non-breathing material, such as a
sports bag, to prevent snap oxidation. Do not
expose the heart rate sensor to direct sunlight
for extended periods.
3
Check the label on your strap to see if it is
machine washable. Never put the strap or the
connector in a dryer!
Service
During the warranty period, service the product
at an authorized Polar Service Center only. The
warranty does not cover damage caused by
unauthorized service. See Limited International
Polar Guarantee.
Batteries
To change the battery yourself, follow the
instructions below, and see the markings on the
connector and picture C on the front cover of
this user manual.
1. Using a coin, open the battery cover by
turning it counterclockwise to OPEN.
2. Insert the battery (CR 2025) inside the
cover with the positive (+) side against the
cover. Make sure the sealing ring is in the
groove to ensure water resistance.
3. Press the cover back into the connector.
4. Use the coin to turn the cover clockwise to
CLOSE.
When changing the battery, make sure the
sealing ring is not damaged, in which case you
should replace it with a new one to ensure the
water resistance of the connector.
Battery kits with sealing rings are available at
Polar retailers and authorized Polar Service
Centers. In the USA and Canada, sealing rings
are available at authorized Polar Service Centers
only.
Keep batteries away from children. If
swallowed, contact a doctor immediately.
Batteries should be disposed of in compliance
with local regulations.
4
Precautions
For allergy information, see the listed materials
in Technical Specifications. Avoid skin
reactions by wearing the heart rate sensor over a
shirt, moistened under the electrodes.
The combined impact of moisture and intense
abrasion may cause a black color to come off
the heart rate sensor’s surface, possibly
staining light-colored clothes. If you use
perfume or insect repellent on your skin, you
must ensure that it does not come into
contact with the heart rate sensor.
Using Your Heart Rate Sensor in a Water Environment
Polar WearLink transmitter Nike+ may be used
when swimming, but interference may occur for
the following reasons:
• Sea- and pool water are very conductive, and
electrodes may short-circuit, preventing ECG
signals from being detected by the heart rate
sensor.
• Jumping or sharp muscle movement may
shift the heart rate sensor so the ECG signals
cannot be detected.
• The ECG signal strength is individual and
depends on tissue composition.
Technical Specifications
Battery type:
Battery sealing ring: O-ring 20.0 x 1.0 Material FPM
WearLink Nike+
battery life:
Operating
temperature:
Connector material Polyamide
Strap material 38% Polyamide, 29%
CR 2025
600 h
14 °F to 122 °F/ -10 °C to +50 C
Polyurethane, 20% Elastane,
13% Polyester
5
Limited International Polar Guarantee
• This guarantee does not affect the
consumer’s statutory rights under applicable
national or state laws in force, or the
consumer’s rights against the dealer arising
from their sales/purchase contract.
• This limited Polar international guarantee is
issued by Polar Electro Inc. for consumers
who have purchased this product in the USA
or Canada. This limited Polar international
guarantee is issued by Polar Electro Oy for
consumers who have purchased this product
in other countries.
• Polar Electro Oy/Polar Electro Inc.
guarantees the original consumer/purchaser
of this device that the product will be free
from defects in material or workmanship for
two (2) years from the date of purchase.
The receipt of the original purchase is your
•
proof of purchase!
• The guarantee does not cover the battery,
normal wear and tear, damage due to
misuse, abuse, accidents or non-compliance
with the precautions; improper maintenance,
commercial use, cracked, broken or
scratched cases/displays, armband, elastic
strap and Polar apparel.
• The guarantee does not cover any damage/s,
losses, costs or expenses, direct, indirect or
incidental, consequential or special, arising
out of, or related to the product.
• Items purchased second hand are not
covered by the two (2) year warranty, unless
otherwise stipulated by local law.
• During the guarantee period, the product will
be either repaired or replaced at any of the
authorized Polar Service Centers regardless
of the country of purchase.
Guarantee with respect to any product will be
limited to countries where the product has been
initially marketed.
6
Loading...