User Manual
Introductions before use and
activation process
1.Take out original insoles from running shoes.；
2.Replace them with the podoon insoles；
3.Put on the running shoes with podoon insole, and
mark time for 2 seconds to activate podoon insoles.
Install podoon App on your phone
Please scan the QR codes below to
download podoon app；
iOS Android
Connect the podoon insole to
your mobile phone
Sign in
connect insole
䰲
Register and log in to podoon App, follow instructions
to searchfor and connect to your Podoon insoles,
and give your smart device a unique name.
Ready to roll
1.Podoon insoles allow offline use and they will record
steps of walking and running daily, as well as duration
of walking, running, standing and sitting. When Podoon
insoles are connected to podoon App, data will be
automatically synchronized with the Podoon App
走 跑
站 坐
2. Connect Podoon insoles to podoon App and click on
‘start running’ bef0re running, then more foot gait
data like foot strike, contact time, etc. will be available,
which could reflect gait intuitively.
connect insole
䰲
Strart
running
Daily maintenance
1.Manual cleaning and
natural drying
Precautions
1.Do not machine wash
60℃
3.Do not place podoon
insoles at a temperature
higher than 60 degrees
celsius.
2.If the insoles are wet or
sweaty, please take out
the insoles to dry cleaning,
be sure to dry thoroughly
before using again
2.Do not soak.
4.Do not do intense
exercise while wearing
podoon insoles, like
basketball, football, ect.
5.Do not twist or wring.
6.Avoid contacting with
chemicals ike gasoline,
paint, detergents and
other chemical substances
Basic parameters
Product Name
Main material
Size
Weight
Battery capacity
Battery type CR2032 button cell
Battery life
Data transmission
mode
Bluetooth chip NORDIC nRF51422
Communication
distance
podoon pressure sensitive Insoles
EVA A6
35-45（EURO）
net weight:59.7g(EURO 35),
82.0g(EURO 45)
220mAh
Working mode support for 18 months,
sleep mode to standby for 3 years.
Bluetooth4.0
8m-12m(in an open area)
Sensor type
Water proofing
grade
OTA firmware
upgrade
Device Support
Thin film pressure sensor
IP67
support
Requires Android 4.4 or later which
supports Bluetooth 4.0; requires IOS 7.0
or later. Compatible with iphone4S/5/5S/
5C/6/6Plus/6S/6SPlus/5SE
podoon insoles Malfunction list
Malfunctions
Malfunctions in manual
Unable to synchronize with the specified device
Fracture due to structure or material of products
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
reception, which can
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced technician for help.
This device complies with part 15 of the FCC Rules. Operation is
subject to the fo
1) This device may not cause harmful interference, and
2) This device must accept any interference received,
including interference that my cause undesired operation.
MODIFICATION: Any changes or modifications not expressly
approved by the grantee of this device could void the user’s authority
to operate the device.
llowing two conditions:
be determined by turning the equipment
Wechat service number
Visit www.podoon.cm
or call 400－668－6683
for more information.
Loading...