Page 1
–
TMS Quick Reference Guide
Alarm LEDs*
LEAK – In-Tank / Sensor GAL – Gross Volume (Gallons)
Net Volume (with ºF LED on)
SP1 – Above 95% (High High) %GAL – Percent of Capacity
SP2 – Above 90% (High) ULL – Ullage Vol (Gallons, Default 90%)
SP3 – Below 20% (Low) IN – Product Level (Inches)
Water Level (with “u” symbol, inches)
WATER – Above 2” ºF – Product Temperature (ºF)
Audible Alarm
Acknowledgment
To silence an alarm,
press any of the right
three buttons. The visual
indicator will remain
active as long as the
alarm condition persists.
A theft alarm can only
be silenced by pressing
the ACKNOWLEDGE
pushbutton located on
the inside of the front
door.
Display Mode LEDs
Visual Alarm
Acknowledgment
The only visual alarms
that can be cancelled
are failed in-tank leak
test and no monthly intank leak test. These
visual alarms are
deactivated by pressing
the ACKNOWLEDGE
pushbutton located on
the inside of the front
door. All other visual
alarms are persistent
Front Panel Buttons
PAPER FEED PRINT MODE TANK SELECT TEST
Press to advance Press for Current Press to display tank name. Press to select tank Press to test
paper Inventory / Sensor Press and hold until beep Press and hold until display and
Status report to select display mode beep for autoscan horn
STEP
Current Inventory / Sensor Status Report:
Press PRINT button.
GROUP SELECT EDIT
* If an alarm LED is blinking, an active tank alarm is present on a tank(s) not currently being displayed. When
an alarm LED is on continuously, it applies to the currently displayed tank. Note that this alarm may apply to
more than one tank, which can be determined by viewing each tank with the TANK SELECT button.
Site Name
Site Location
TMS Quick Reference.doc Page 1 of 2 July 1, 2009
Tech Support Phone
Emergency Phone
Page 2
L
E
G
E
N
D
Print Log Procedure
Press and release. Press and hold
until second beep.
Inventory
Inventory
InventoryInventory
Flashing Display
1.
While holdin
2.
EDIT EDIT
g the TEST button, hold the MODE button until is displayed, then release buttons.
Log
Log
LogLog
,
Enter Access Mode
Log
Print Log(s)
Inventory
Inventory
InventoryInventory
Log
LogLog
rEturn
Events
ALarms
LIne Leak
Leak Hist
tank Leak
selected log
Water
,
or
Orders
tHefts
saLes
deLivery
Inventory
Inventory
Inventory
InventoryInventory
,
xxxxxxxxxxxxxxxxxxx xxxxxxxx
xxxxxxxxxxxxxxxxxxx xxxxxxxx
xxxxxxxxxxxxxxxxxxx xxxxxxx
xxxxxxxxxxxxxxxxxxx xxxxxxxx
xxxxxxxxxxxxxxxxxxx xxxxxxx
xxxxxxxxxxxxxxxxxxx xxxxxxxx
PRINT
,
xxxxxxxxxxxxxxxxxxx xxxxxxx
xxxxxxxxxxxxxxxxxxx xxxxxxxx
xxxxxxxxxxxxxxxxxxx xxxxxxxx
xxxxxxxxxxxxxxxxxxx xxxxxxx
xxxxxxxxxxxxxxxxxxx xxxxxxxx
xxxxxxxxxxxxxxxxxxx xxxxxxx
xxxxxxxxxxxxxxxxxxx xxxxxxxx
Note: the list of logs may vary with the version of firmware in the TMS.
3.
Return
Return
Return Return
STEP EDITEDIT
Return Log
Return Return
or EDIT
Return
Return
Return Return
,
,
,
TMS Quick Reference.doc Page 2 of 2 July 1, 2009
Return to Normal Display Mode*
selected log
Log
LogLog
normal mode
selected log
,
Log
Log Return
LogLog
,
*Return to normal tank gauging
display mode may also be achieved
by allowing console to timeout for
four minutes with no pushbutton
activity.
Loading...