PMI Piranha Ravage User Manual

RAVAGE

INSTRUCTIONS FOR USE

The Ravage eForce grip frame is capable of high rates of fire and an agitating hopper such as an
Extreme Rage Overdrive, VL Revolution, Halo, or Evolution 2 is recommended for better performance.

RAVAGE BATTERY: T

or best long term battery life, repeat this process every time it is drained. You can also use a regular 9 volt battery with this frame if your rechargeable battery is dead or if you

F
want to play with the frame right away. You will need to remove the right grip panel when you need to replace it.

he Ravage comes with a 9 volt rechargeable battery. You must charge it for a full 22 hours before initial use since the it does not come fully charged.

WARNING: PMI RECOMMENDS USING THE 9V RECHARGEABLE BATTERY PROVIDED FOR OPTIMAL PERFORMANCE. DO NOT
USE THE BATTERY CHARGER WHEN USING ANY NON-RECHARGEABLE BATTERY.

Cocking Rod

PMI High Per

formance Barrel

On/Off Button

ON/OFF BUTTON: The on/off is the silver button

located on the left hand side of the gripframe. Push it once

Gas Thru Grip

and the red on/off indicator will then light up. Push the
on/off button again to turn it off. The frame should be left
off when not using the marker or you will drain the battery.

BURST BUTTON Pr

ess the Burst Button once to turn the marker on 3
Shot Burst. Press the Burst Button again to turn the frame to 6 Shot Burst.
Press the Burst Button again to turn the frame to 9 Shot Burst. Press the
Burst Button again to turn it back to semi-auto.

FULL AUTO BUTTON Pr

ess the Full Button once to tur

n the frame to

Full Auto. Press the Full Button again to turn it back to semi-auto.

eFORCE BATTERY The eForce frame comes with a 9 volt

rechargeable battery. You must charge it for a full 22 hours with the
marker turned off before initial use since it does not come fully
charged. For best long term battery life, repeat this process every
time it is drained. Y

ou can also use a regular 9 volt battery with this
frame if your rechargeable battery is dead or if you want to play
with the frame right away

ou will need to r

. Y

emove the right grip
panel when you need to replace it. A blinking on/off indicator light
means your eFor

ce frame needs to be char

ged right away

. Always

charge with the marker turned off.

Velocity

Adjustment

Screw

On/Off Indicator

Charge Port

10º Bottom Line

Adapter

SEAR RELEASE SLIDE: The sear release slide is located on the left

hand side of the Ravage grip frame. T

o reinstall the bolt/block/hammer

Drop Forward

Sear Release

assembly, push the sear release slide up before the hammer comes in con­tact with the sear. That will allow the bolt/block/hammer assembly to slide
easily into the marker

TOURNAMENT LOCK SWITCH The T

.

nament Lock Switch

our
enables you to play in a tournament or at a field that does not allow full
auto and burst modes by restricting the marker to semi-automatic only. All
eForce frames come with the Tournament Lock off so you can immediately
put the marker in full auto or burst mode. See Piranha manual (5.3) page
32 or Piranha manual (5.1) page 28.

WARNING: Never use water to clean the marker, or you run the risk of damaging the electronic trigger frame.

54

42

2

5

62

66

6

8

72

7

1

63

67

66

7

0

6

9

7

7

73

75

74

76

6

4

7

0

7

8

13

2

5

33

34

34

1

2

11

3

2

35

1

4

2

6

2

0

19

28

37

37

6

7

9

10

37

3

2

3

9

31

4

1

5

43

42

41

45

4

5

4

0

15

1

7

1

6

1

8

2

7

37

36

59

6

0

EXCL

USIVE!

1. Milled Receiver Body 71690

2. 9” Barrel 10124

3. ASA Slug 71670

4. Sight Rail 71680

5. Field Strip Pin

Assembly

6. Valve Body

7. Valve Cup Seal Assembly 10127
Valve Guide

9.

Assembly

10. Valve Spring 71597

11. Minlon Bolt 71668
Rear Block w/ Cushion 71662

12.
Minlon Cocking Rod

13.
Hammer

14.

15. Blue Hammer Spring 10351

16. ASA O-ring 10608

17. Spring Guide 10301

18. Vertical ASA Adapter 71520
Ball Detent Cap

19.
Ball Detent

20.

25. Velocity Screw 10026

26. Valve Set Screw 10513

27. ASA Screw 71580
Ball Detent Screw

28.
Sight Rail Screws

31.
Bolt Pin 10291

32.

33. Velocity Screw O-Ring 10460

34. Rear Block O-Rings 10260

35. Blue Hammer O-Ring 10129
Screen F

36.
Valve O-Rings 41010

37.

ilter

37. Gas Thru Grip O-Ring 41010

37. ASA Slug O-Ring 41010

10021
10027

10520

71669
10024

10101
10160

10180
20010

71667

39. Barrel O-Ring 10161

40. Gas-T

hru Foregrip 10788

41. 7" SS hose 47015

42. Bottom line SS screw 42016

43. 10˚ Bottom Line Adapter

42013

45. 90° Elbows 47000

54. Drop Forward 71242
Front Bolt O-Ring

59.

57738

60. Standard Cocking B/B/H Assembly 71297

61. eForce Polymer Double Trigger Frame Assembly59093
eForce Sear Release Slide 71585

62.
Grip

63.

rigger F

T

Rear

64.

65. Front eForce Trigger Frame Screw 71582

66. Grip Screws 10782

67. eForce Trigger 71586

68. eForce Sear 71591

rigger Spring 71587

T

orce

eF

69.

orce Sear/T

eF

70.

71. eForce Trigger/Spring Pin 71589

72. eForce Sear Spring 71590

73. eForce Board Screws 71592

orce Board Cover

eF

74.

orce Electronic Board 71594

eF

75.

eForce Solenoid 71595

76.

77. eForce Charge Port Cover 71596

78. 8.4V Rechargeable Battery 70181

70105

rame Screw 71583

rigger Pin 71588

71593