PMC-Sierra PM5347 User Manual

PMC-Sierra,Inc.
Li
Sid
155 Mb/s SATURN User Network Interface for WANs
PM5347
S/UNI-155-PLUS

FEATURES

• Monolithic SATURN®-compatible Asynchronous Transfer Mode (ATM) network interface.
• Implements the ATM transmission convergence (TC) sublayer for ATM according to ATM Forum specifications and ITU-T recommendations using the SONET/SDH 155.52 Mb/s format. Also implements ATM Forum specified “Mid-range PHY” rates of 51.52, 25.92 and 12.96 Mb/s.
• Includes on-chip clock recovery and clock synthesis at all rates. Clocking can be bypassed for use with external clock sources. Operates in master or slave (loop timed) timing modes.
• Provides TTL-compatible inputs and outputs. Provides differential pseudo­ECL-compatible serial line side inputs.
• Supports Fiber Optic, Unshielded Twisted Pair and Shielded interfaces.
• Processes all SONET/SDH UNI overhead.
• Provides access to section and line datalinks and all additional transport and path overhead to allow additional external processing for full SONET/ SDH Network-Node Interface (NNI) compliance.
• Provides synchronous 8-bit or 16-bit SCI-PHY™ system side interface with 4-cell deep FIFO buffers in transmit and receive paths with parity support.
• Inserts and extracts ATM payloads using cell delineation.
• Provides a generic 8-bit microprocessor bus interface for configuration, control, and status monitoring.
• Software-compatible with the PM5345 S/UNI-155™, PM5346 S/UNI-155­LITE™ and the PM5355 S/UNI-622™.
• Provides a standard 5-signal P1149.1 JTAG test port for boundary scan board test purposes.
• Low power, +5 V CMOS technology.
• Packaged in a 208 pin (28mm x 28mm) PQFP with 0.5mm pin pitch.
• Industrial temperature range operation (-40°C to +85°C).
• Counts received cells written into the receive FIFO, received HCS errored cells that are discarded, and received HCS errored cells that are corrected and passed through the receive FIFO.

TRANSMIT SECTION

• Counts transmit cells read from the transmit FIFO.
• Inserts a register programmable path signal label (C2).
• Inserts path B3, path FEBE indications, line B2, line FEBE indications, and section B1 to allow performance monitoring at the far end.
• Optionally inserts the 16- or 64-byte section trace (J0) sequence and the 16 or 64 byte path trace (J1) sequence from internal register banks.
• Optionally inserts an externally generated section user channel (F1), order wire channels (E1, E2) and the DCC channels (D1-D3 and D4-D12) via serial interfaces.
• Optionally inserts path AIS, path RDI, line AIS, and line RDI.
• Optionally inserts register programmable APS (K1, K2) and synchronization status (Z1) bytes.

RECEIVE SECTION

• Filters and captures the automatic protection switch channel (K1, K2) bytes in readable registers and detects APS byte failure.

BLOCK DIAGRAM

ne
e
TSDCLK,TOWCLK
TSD,TSOW,TSUC
TLDCLK
TLAIS
Transmit
Processor
Receive
Processor
LOF
LOS
RSDCLK,ROWCLK
TLRDI
TTOH
TTOHFP
TTOHCLK
TLD,TLOW
Tran spo rt
O/H
Extract
Transm it Line O/H
Processor
Section
Trace
Buffer
Receive
Line O/H
Processor
Transport
O/H
Extract
LAIS
LRDI
RTOH
RLDCLK
RLD, RLOW
RSD,RSOW,RSUC
TRCLK+/-
TXD+/-
TXC+/-
RXDO+/-
RXD+/-
ALOS+/-
RRCLK+/-
TATP
Clock
Recovery
SIPO
Clock
Recovery
SIPO
FLO
LF+/-
TBYP
RATP
Section O/H
Section O/H
RBYP
• Extracts the 16- or 64-byte section trace (J0) sequence and the 16- or 64­byte path trace (J1) sequence into internal register banks.
• Extracts the DCC channels (D1-D3 and D4-D12) for optional external processing.
• Detects Loss Of Signal (LOS), Out Of Frame (OOF), Loss Of Frame (LOF), line Alarm Indication Signal (AIS), line Remote Defect Indication (RDI-L), Loss Of Pointer (LOP), path AIS, path RDI (RDI-P) and Loss Of Cell Delineation (LCD).
• Counts received section B1 errors, line B2 errors, line FEBEs, path B3 errors and path FEBEs for performance monitoring purposes.

APPLICATIONS

• ATM Switching Systems
• ATM Access Systems
• LAN Switches, Hubs and Routers
• ATM Test Equipment
• SONET or SDH ATM Interfaces
System Side
TOHFP
GTOC LK
TPOH
TPOHFP
TPOHCLK
TTOHEN
GTOC LK
ROHFP
RTOHFP
GROCLK
RTOHCLK
TPOHEN
Path O/H
Extract
Transm it
Path Overhead
Processor
Path Trace Buffer
Receive
Path Overhead
Processor
Path
O/H
Extract
LOP
RPOH
RPOCLK
RPOHFP
PRDI
TPAIS
TPRDI
Input/Output Port
PYEL
POP[3:0]
PIP[3:0]
Parallel
Transmit
ATM
Cell Processor
Receive
ATM
Cell Processor
Microprocessor
LCD
A[7:0]
D[7:0]
Interface
ALE
CSB
WRB
TCP
TGFC
Transmit
ATM 4 -Ce ll
FIFO
Receive
ATM 4 -Ce ll
FIFO
RDB
RSTB
TDO
XOFF
JTAG Test
Access Port
RCP
INTB
TDI
TCK
TMS
TRSTB
TSOC
TDAT[15:0]
TXPRTY[1:0]
TCA
TWRENB
TFCLK
Drop Side
I/F
RSOC
RDAT[15:0]
RXPRTY[1:0]
RCA
RRDENB
RFCLK
BUS8
TSEN
RGFC
PMC-930909 (R7) PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMERS’ INTERNAL USEã 1998 PMC-Sierra, Inc. October,
PM5347 S/UNI-155-PLUS
155 Mb/s SATURN User Network Interface for WANs

TYPICAL APPLICATION

155 Mb/s ATM SWITCH PORT INTERFACE

Reference
Clock
TRCLK+/-
E/O
RRCLK+/-
O/E
ALOS+/-

STS-3C/STM-1 OVERHEAD BYTE USAGE

A1
Transm it
Overhead
Insert
TXD+/-
RXD+/-
Transmit
Alarm Insert
Signals
PM5347
S/UNI-155-PLUS
155 Mb/s SATURN™ User Network Inter-
Receive
Overhead
Extract
face for WANs
Receive
Alarm Detect
Signals
C1/J0
Microprocessor Bus for Configu-
ration, Status, and Control
C1C1
TCA
TXPRTY[1:0] TDAT[15:0]
TSOC
TWRENB
TFCLK
RCA
RXPRTY[1:0]
RDAT[15:0]
RSOC
RRDENB
RFCLK
J1
Transmit
ATM
Process
Receive
ATM
Process
Switching
Network
Head Office: PMC-Sierra, Inc. #105 - 8555 Baxter Place Burnaby, B.C. V5A 4V7 Canada Tel: 604.415.6000 Fax: 604.415.6200
B1
D1
H1
H1 H1 H2 H2 H2 H3 H3 H3
B2
B2 B2
D4
D7
D10
K1
D5
D8
D11
Z1
F1
D3
K2
D6
D9
D12
M1 E2
Transport Overhead SOH
To order documentation, send email to: document@pmc-sierra.com or contact the head office, Attn: Document Coordinator
All product documentation is available on our web site at: http://www.pmc-sierra.com For corporate information, send email to: info@pmc-sierra.com
B3
C2
G1
Z5
Path Overhead POH
PMC-930909 (R7) ã 1998 PMC-Sierra, Inc. October, 1998 SATURN, SCI-PHY, S/UNI-155, S/UNI-155-LITE, S/UNI-155-PLUS, and
S/UNI-622 are trademarks of PMC-Sierra, Inc.
PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMERS’ INTERNAL USE
Loading...