PMC PM8313 Datasheet

PMC-Sierra,Inc.
M13 Multiplexer/Demultiplexer
PM8313
D3MX

FEATURES

• Integrates a complete M13 multiplexer/ demultiplexer in a single monolithic device.
• Integral framer supports the M23 or C­bit parity DS3 format with path maintenance datalink processing and bit-orie nted code support for Far-End Alarm and Control (FEAC) channel termination.
• Supports either the M12 or the G.747 formats to allow DS1 or E1 signals to be multiplexed into a DS3 signal.
• Allows the M12 stages to b e b yp ass ed allowing direct input of DS2 signals.
• Generates an interrupt upon detection of various a larms, events, or changes in status. Identification of interrupt sources, masking of interrupt sources, and acknowledgement of interrupts is provided via internal registers.
• Application-compatible with the PM4351 COMET T1 Transceiver, PM4341A T1XC T1 Transceiver, PM4344 TQUAD Quad T1 Framer, PM4388 TOCTL Octal T1 Framer, PM6341 E1XC E1 Transceiver, PM6344 EQUAD Quad E1 Framer, PM6388 EOCTL Octal E1 Framer, PM4314 QDSX Quad E1/T1 LIU, and the PM7344 S/UNI
®
-MPH.
Provides a generic 8-bit microprocessor interface for configuration, control, and status monitoring.
Low power 5 V CMOS technology.
Available in a high density (28 by
28 mm) 208-pin Plastic Quad Flat Pack (PQFP) package.

DS3 FRAMER SECTION

Detects/inserts DS3 Alarm Indication Signal (AIS) and Idle signal - operates correctly in the presence of 10-3 Bit Error Ratio (BER).
Extracts/inserts t he X, P,M, F,C an d th e stuff opportunity bits and serializes for optional external processing.
Extracts/inserts the C-bit parity mode path maintenance datalink and serializes for optional external processing.
Extracts/inserts the C-bit parity bit­oriented codes in the FEAC channel.
Detects and accumulates EXcessive Zeros (EXZ), Loss Of Signal (LOS), Line Code Violations (LCVs) P-bit, F-bit, or M-bit errors, C-bit parity errors and Far-End Block Errors (FEBEs).
Supports DS3 line loopback and DS3 diagnostic loopba ck mod es to ass ist in fault isolation.

M23 AND M12 MULTIPLEX/ DEMULTIPLEX SECTIONS

Supports combination of four DS1 bit streams or the combination of three E1 bit streams per G.747 into a single M12 stream.
Supports per-DS2 payload loopback requests via C-bits or microprocessor control.
Accumulates DS2 M-bit, F-bit, and G.747 framing bit/word error events.
Supports DS2 AIS assertion based on DS3 LOF, or under microprocessor control.
Supports DS2 tributary AIS activation/ deactivation in either directi on und er microprocessor control.
Inserts/detects per-DS1 payload loopback requests transmitted via C-bits.

APPLICATIONS

M23 or C-Bit Parity Format DS1 to DS3 Mux/Demux Equipment
Fractional T3 Access E quipment
DS2-to-DS3 Mux/Demux Equipment
DS1-to-DS3 Mux/Demux Equipment
Supporting G.747 Tributary Format

BLOCK DIAGRAM

TDLEOMI
TDLCLK/TDLINT
TDLSIG/TDLUDR
XBOC
Transmit
FEAC
TCLK
TPOS/TDAT
TNEG/TMFP
RCLK/VCLK
RPOS/RDAT
RNEG/RLCV
PMC-920522 (R10) © 1998 PMC-Sierra, Inc. October, 1998
B3ZS
Decode
B3ZS
Decode
RBOC
Receive
FEAC
XFDL
Transmit
HDLC
RFDL
Receive
HDLC
RDLCLK/RDLINT
TRAN
DS3 Transmit
Framer
FRMR
DS3 Receive
Framer
RDLSIG/RDLEOM
TOH
PMON
Perfor­mance
Monitor
Counters
TOHCLK
Tx
O/H
Access
ROCLK, RODAT,
RMFP, RMSFP,
TIMFP
Rx
O/H
Access
ROHP, ROHCLK
TOHFP
TICLK
RAIS, ROOF/
RLOS, REXZ,
ROHFP, ROH,
RRED, RFERF
TOHEN
MUX/DEMUX
Microprocessor
A[7:0]
D[7:0]
A8/TRS
GD2CLK
MX23
M23
MPIF
Interface
ALE
CSB
#1
TD1CLK4 TD1DAT4
MX12
M12
MUX/
DEMUX
DS2
FRMR
Framer
One of seven M12
#2 - #7
Remaining Six M12
RDB
INTB
WRB
RSTB
TD2CLK
RD1DAT[3:1] RD1CLK[3:1]
RD1CLK[3:1] RD1DAT[3:1]
RD1CLK4 RD1DAT4
TD1CLK[28:5] TD1DAT[28:5] RD1CLK[28:5] RD1DAT[28:5]
M13 Multiplexer/Demultiplexer

TYPICAL APPLICATIONS

DS3 TERMINAL MULTIPLEXER OR DIGITAL CROSS-CONNECT

DS3 Line
Interface Unit
(LIU)
M13 Multiplexer/Demultiplexer
PM8313
'0;
PM4388
TOCTL
Octal T1 Framer
PM4388
TOCTL
Octal T1 Framer
PM4388
TOCTL
Octal T1 Framer
PM4388
TOCTL
Octal T1 Framer
PM8313 D3MX
Synchronous
DS0
Backplane

HYBRID MULTIPLEXER-28xDS1 (ANSI FORMAT) OR 21xE1 (ITU G.747 FORMAT) TO DS3

Head Office: PMC-Sierra, Inc. #105 - 8555 Baxter Place Burnaby, B.C. V5A 4V7 Canada Tel: 604.415.6000 Fax: 604.415.6200
To order documentation, send email to: document@pmc-sierra.com or contact the head office, Attn: Document Coordinator
All product documentation is available on our web site at: http://www.pmc-sierra.com For corpo rate information, send email to: info@pmc-sierra.com
PMC-920522 (R10) © 1998 PMC-Sierra, Inc. October, 1998 S/UNI is a registered trademark of PMC-Sierra,
Inc.
Loading...