PMC PM4354 Datasheet

Four Channel Combined E1/T1/J1 Transceiver/Framer
PM4354
COMET-QUAD

FEATURES

• Monolithic device that integrates four T1/E1 framers and line interfaces for shorthaul and longhaul app lic at ions.
• Provides digitally programmable longhaul and shorthaul pulse templates and line build out.
• Meets or exceeds T1/J1 and E1 shorthaul and lo nghaul network ac cess specifications including ANSI T1.102, T1.403, T1.408, AT&T TR 62411, ITU­T G.703, G.704 as well as ETSI 300­011, CTR-4, CTR-12 and CTR-13.
• Provides encoding and decoding of B8ZS, HDB3 and AMI line codes.
• Provides receive equalization, clock recovery and line performance monitoring.
• Provides transmit and receive jitter attenuation.
• Provides four full-featured HDLC controllers, each with 128-byte transmit and receive FIFO buffers.
• Provides a two-frame payload slip buffer to allow independent backplane and line timing.
• Automatically generates and transmits DS-1 performance report mes sages to ANSI T1.231 and ANSI T1.408 specifications.
• Provides PRBS generators and detectors on each tributary for error testing at DS1, E1 and N x 64 Kbit/s rates as recommende d in IT U-T O.15 1 and O.152.
• Provides an 8-bit microprocessor bus interface for configuratio n, cont rol, and status monitoring.
• Uses line ra te system clock.
• Provides an IEEE P1149.1 (JTAG) compliant test access port (TAP) and controller for boundary scan test.
• Implemented in a low power 2.5/3.3 V CMOS technology.
• Available in a hi gh density 208-pin fin e pitch PBGA (17 mm by 17 mm) package.
• Provides a -40 °C to +85 °C industrial temperature operating range.

RECEIVER

• Typical signal recovery of up to -43 dB at 1024 kHz (E1) and up to -44 dB at 772 kHz (T1/J1).
• Guaranteed minimum signal recovery of -32 dB at 1024 kHz (E1) and
-36 dB at 772 kHz (T1/J1) using PIC-22 gauge cable emulation.
• Frames to DSX/DS-1 signals in SF, and ESF formats.
• Frames to ITU-T G.704 basic and CRC-4 multiframe formatted E1 signals. The framing procedures are consistent with ITU-T G.706 specifications.
• Frames to TTC JT-G704 multiframe formatted J1 signals. Supports the alternate CRC-6 calculation for Japanese applications. Frames in the presence of and detects the Japanese yellow alarm.
• Tolerates more than 0.4 UI peak-to­peak, high frequency jitter as required by AT&T TR 62411 and Bellcore TR­TSY-000170.
• Provides programmable in-band loopback activate and deactivate code detection.

BLOCK DIAGRAM

TxTIP1[1:4] TxTIP2[1:4]
TxRING1[1:4] TxRING2[1:4]
TxCM[1:4]
XCLK
CTCLK
RSYNC
TDO
TCK TMS
TRSTB
RxTIP[1:4]
RxRING[1:4]
RVREF[1:4]
TDI
XLPG
Transmit LIU
JTAG
Test Access
Port
RLPS
Receive LIU
TJAT
Digital Jitter
Attenuator
CSD
Clock
Synthesis and
Distribution
TOPS
Timing
Options
CDRC
Clock and
Data
Recovery
One of Four
T1/J1 or E1
Transceiver/Framers
XIBC
Inband
Loopback
Code
Generator
XPDE
Pulse
Density
Enforcer
Performance
RJAT
Digital Jitter
Attenuator
PMON
Monitor
Counters
T1-XBAS/E1-TRAN
Basic Transmitter,
Frame Generation,
Alarm Insertion, Signaling Insertion, Trunk Conditioning
TDPR
HDLC
Transmitter
T1-APRM
Auto
Performance
Response
Monitor
ALMI
Alarm
Integrator
IBCD
Inband
Loopback Code
Detector
PDVD
Pulse Density
Violation Detector
Tx-ELST
Transmit
Elastic
Store
TPSC
Per-DS0
Controller
XBOC
Bit Oriented Code Dector
RDLC
HDLC
Receiver
RBOC
Bit Oriented Code Dector
T1/E1-FRMR
Frame Align-
ment, Alarm
Extraction
FRAM
Framer RAM
SIGX
Signalling
Extractor
Rx-ELST
Receive
Elastic Store
PRBS
Pattern
Generator/
Detector
RPSC
Per-DS0
Controller
BTIF
Backplane
Transmit
System
Interface
MPIF
Micro-
processor
Interface
BRIF
Backplane
Receive
System
Interface
BTCLK[1:4] BTSIG[1:4] BTFP[1:4] BTPCM[1]/CASBTD
BTPCM[2:4]
CCSBTD MVBTD
A[10:0] RDB WRB CSB ALE INTB RSTB D[7:0]
PIO
CMV8MCLK
CMVFPC CMVFPB
BRCLK[1:4] BRSIG[1:4] BRFP[1:4]
BRPCM[1]/CASBRD BRPCM[2:4]
CCSBRD/
MVBRD
PMC-2000091 (r3) PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMERS INTERNAL USE © Copyright PMC-Sierra, Inc. 2001
PM4354 COMET-QUAD
Four Channel Combined E1/T1/J1 Transceiver/Framer
Provides diagnostic, line and per-DS0 payload loopbacks.
Extracts up to three HDLC links to an H-MVIP Bus to support the D-c ha nne l, for ISDN Primary Rate Interfaces, and the C-channels, for V5.1/V5.2 interfaces. Detects the V5.2 link identification signal.

TRANSMITTER

Generates DS X-1 shorthaul and DS-1 longhaul pulses with programmable pulse shape compatible with AT&T, ANSI and ITU requirements.
Generates E1 pulses compliant to G.703 recommendations.
Provides line outputs that are current limited and may be tristated for protection or in redundant applications.
Provides a digital phase locked loop for generation of a low jitter transmit clock complying with all jitter
attenuation, jitter transfer and residual jitter specifications of AT&T TR 62411 and ETSI CTR 12 and CTR 13.
Provides a FIFO buffer for jitter attenuation and rate conversion in the transmit path.
Supports unframed mode and framing bit, CRC, or data link by-pass.
Allows insertion of framed or unframed in-band loopback code sequences.
Allows insertion of a data link in ESF mode. Optionally inserts a datalink in the E1 national use bits.
Inserts, from an H-MVIP bus, up to three HDLC links to support the D­channel, for ISDN Primary Rate Interfaces, and the C-channels, for V5.1/V5.2 interfaces.
Transmits TTC JT-G704 multiframe formatted J1 signals. Supports the alternate ESF CRC-6 calculation for Japanese applicati on s.
TYPICAL APPLICATIONS
3G WIRELESS BASESTATION CONTROLLER
Modem Card
PM7350
S/UNI-DUPLEX
Supports transmission of the alarm indication signal (AIS) and the yellow alarm signal. Supports Japanese yellow alarm generation.
Provides ESF bit-oriented code generation.

APPLICATIONS

Wireless Base Trans ceiver Station and Digital Loop Carrier (DLCs).
Enterprise Router.
DSLAM.
APON Optical Network Unit (ONU).
Integrated Access Device (IAD).
Voice Gateway.
Channel and Data Service Units
(CSU/DSU).
Digital Private Branch Exchanges (PBX).
Test Equipment.
Fabric Backplane
MODEMS
WAN Interface Line Card (Protect)
WAN Interface Line Card (Working)
E1/T1/J1x4
E1/T1/J1x4
PM4354
COMET-QUAD
PM4354
COMET-QUAD
PM7341
S/UNI-IMA-8
INTEGRATED ACCESS DEVICE
E1/T1/J1 x 4
to PBX, Video,
CODEC
Head Office: PMC-Sierra, Inc. 8555 Baxter Place Burnaby, B.C. V5A 4V7 Canada Tel: 604.415.6000 Fax: 604.415.6200
LAN
PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMERS INTERNAL USE
MAC
To order documentation, send email to: document@pmc-sierra.com or contact the head office, Attn: Document Coordinator
PM7328
S/UNI-ATLAS-
1K800
PM4354
COMET-QUAD
PM7366
FREEDM-8
AAL2 MUX
PM7329
S/UNI-APEX-
1K800
PM73124
AAL1gator-4
Voice
Processing
with AAL2
FR/ATM & AAL5
SAR
PM7351
S/UNI-
VORTEX
UTOPIA L2/ Any-PHY UTOPIA L2
Modem Card
PM7350
S/UNI-DUPLEX
PM7351
S/UNI-
VORTEX
Modem Card
PM7350
S/UNI-DUPLEX
PM7329
S/UNI-APEX-
1K800
PM7328
S/UNI-ATLAS-
1K800
All product documentation is available on our web site at: http://www.pmc-sierra.com For corpo rate information, send email to: info@pmc-sierra.com
PM7340
S/UNI-IMA-8
MODEMS
MODEMS
PM4354
COMET-QUAD
x 2
RF Card
PM7815
PALADIN-15
E1/T1/J1 x8
to ATM WAN
PMC-2000091 (r3)
© Copyright PMC-Sierra, Inc. 2001. All rights reserved. August 2001. S/UNI is a registered trademark and AAL1gator-4, Any-PHY, FREEDM-8, SPECTRA-155, FREEDM-32, COMET-QUAD, and PMC-Sierra are trademarks of PMC-Sierra, Inc.
RF
Loading...