Plumbline Progetto Series, Progetto TONDO, Progetto QUADRO Installation Instructions Manual

INSTALLATION INSTRUCTIONS

TONDO HEATED TOWEL LADDERS
QUADRO HEATED TOWEL LADDERS

This appliance MUST be installed in accordance with the relevant wiring rules and
regulations and in particular those regulations which cover installation of appliances
and accessories in damp situations such as bathrooms, showers, laundries
and other areas with xed water containers. It is to be tted in accordance with
applicable Australian/New Zealand standards (AS/NZS).

This Class 1 Appliance Requires Earthing

Special purpose tools are required for the replacement of the power supply cord and
element. Contact an Authorised Service Agent for service.

Electrical

Wattage = 80W, 105W, 95W, 120W, 158W, 130W, 150W
Power Supply = 230 - 240 Volts. 50Hz. Single Phase
Ingress Protection Rating: IP45 Double Insulated

Cleaning

The Heated Towel Rail is best wiped down from time to time with a damp cloth.

Do Not Use Any Abrasive Or Corrosive Cleaners.

SAFETY INFORMATION

Please read these instructions carefully and keep them handy for future reference.

• This appliance is used for warming and drying towels, therefore it is hot to touch.
Young children or inrm persons should be supervised when the product is
working and ensure that they do not touch the appliance.

• The appliance will feel hotter to touch during warmer periods because of the
rise in ambient temperature. Also the insulation effect of towels will cause the
operating temperature to increase slightly.

• The appliance should be installed so that switches and other controls cannot be
touched by a person in the bath or shower.

• This appliance is ONLY used for warming and drying towels, DO NOT use it for
any other purpose.

• To avoid danger this product MUST NOT be used to carry towels or any other
articles that have been in contact with oil, petroleum based products or dry
cleaning uids.

• Make sure the voltage complies with the specication on the rating label, or
elsewhere in these instructions.

• For your safety and others, make sure the electrical work is done by an authorized
person according to AS/NZS3000:2000 Wiring Rules and Regulations.

• DO NOT immerse in any liquid.

• DO NOT allow the power cord to contact with the hot surface when it is working.

• If the product does not work well or is damaged, it must be xed or replaced by
the manufacturer, its service agent or similarly qualied persons.

• WARNING: The bottom rail of this product MUST be installed at least 600mm
above the oor in order to avoid risk of harm to young children.

INSTALLATION

This towel rail is unique in the exible way you can connect to the power supply. The
electrical connection can be made through either the lower left or right legs. This
connection can be either directly wired through the wall or via the cord and plug
supplied.

Note: The heated towel rail must be installed by a professional service agent or
qualied person. Make sure you have read the safety information before installing.
Make sure there is enough space for your heated towel rail according to its real size
and there is no direct contact with other objects.

There are two methods of installation: