Playskool Bedtime Wishes Gloworm 23393 Instruction Manual

Thank you for purchasing this lovable friend!

™

™

BIRTH +

23393

Bedtime Wishes

Bedtime Wishes

TTOO UUSSEE

NOTE: This product is shipped in "demo"
mode. Open seam on back and slide switch to
"play" for full use at home.

Your child’s BEDTIME WISHES GLOWORM
friend eases the transition to bedtime with a
friendly, glowing face and special wish that
rhymes. All it takes is a gentle squeeze to
bring this lovable character to life.

PLAY

DEMO

PLAY

DEMO

P
L

A
Y



DEMO

TTOO RREEPPLLAACCEE LLIIGGHHTT BBUULLBB

PR-3 or PR-7 (max 1.2W) bulb required. (Light
bulb should be replaced by an adult.)

1. Open seam on back. Untie laces and remove
electronic unit.

2. Loosen and remove screws from lens cover.
Remove lens cover, and pull out and discard
old bulb.

3. Insert a PR-3 or PR-7 (max 1.2W) light bulb into
bulb compartment. Place lens cover back on
electronic unit and retighten screws. Test to
be sure unit works by pressing activation bar.

4. Place electronic unit in the toy with the bulb
toward the head and the activation bar
facing tummy. Fit lace through tab on each
side of unit and tie to other lace. Close
seam.

WWAASSHHIINNGG IINNSSTTRRUUCCTTIIOONNSS

(DO NOT WASH TOY WITH ELECTRONIC
UNIT INSIDE!)

Open back, untie laces and remove electronic
unit. Place the toy in pillow case and tie end
closed. Machine wash in cold water, gentle
cycle, mild detergent, NO BLEACH. Tumble dry
in pillow case on low heat setting. After the
toy is dry, distribute filling evenly throughout
body. (During washing, filling may bunch up.)
Place electronic unit in the toy with the bulb
toward the head and the activation bar facing
tummy. Fit lace through tab on each side of
unit and tie to other lace. Close seam.

TTiieess

TTiieess