Platinum Tools 15030C, 15031C, 15032C User Manual

Fig-D

INSTRUCTION SHEET

COAX CABLE STRIPPING TOOL

P/N 15030, 15031, 15032

Hex wrench
(included), storage
on bottom of tool

Blade

Down

(-)

Adjust blade stripping
depth with Hex wrench as shown

Replacement Blades

for 2 Level Strippers

Order P/N 15038

Package of 4 Blades

Part number
15030 shown

Blade

Up
(+)

Fig-B

Visit our web site at http://www.platinumtools.com

INSTRUCTION SHEET

COAXIAL CABLE STRIPPING TOOL

15030

INSTRUCTIONS FOR USE

and all other 2 level strippers

Adjustable V-Block

Rotate for proper cable diameter

Blade roll pin

Fig-C

mm

inch

Tel: [phone] Fax: [phone]

Fig-A

V-Block Settings

• RG58 8

• RG59, 62 9

RG6, 6Quad 6

•

• Small OD D

Center Conductor

Dielectric

Stripping Dimensions

BC BD* BE AE

4 6 8 12

.157 .236 .315 .472

*Factory pre-set @ .236”

E-Series Strippers

Use caution blades are sharp!!

Step 2:
Slide tool off ca­ble while holding
closed as shown.

*

Shield

2 level

Step 1:
Insert cable in
tool as shown.
Rotate.

ADJUSTING TOOL

1. Set V-Block to proper cable type (see Fig-A) by sliding V-Block out of housing. Rotate to proper
setting and re-insert.

2. Adjust the blade stripping depth with the hex wrench as shown in Fig B. The Hex wrench is
stored in the bottom of the tool.

3. Stripping distance (see Fig D) or length of the exposed shield & dielectric can be adjusted. Push
out the blade roll pin (see Fig A) with the hex wrench. Use tweezers (not supplied) to reposition
the blade to the proper slot in bottom jaw housing as shown in Fig C.

IS 15030 B1 One Up.pub Date: 8.14.2003

Step 3:
Inspect the strip.

Factory pre-set for .236” (6 mm) strip length

IS15030B.pub

© 2003 Platinum Tools, Inc.