Platinum Tools 100005 Specsheet
For use with EZ-RJ45®
Cat 5e & Cat 6 Connectors.
1. Strip off approximately
two inches of outer cable jacket.
2. Untwist & straighten wires.
Place in desired order.
See color code
wiring chart. (5)
EZ-RJ45®
Instructions
5. Double check wiring sequence now.
T568A/T568B Wiring
Wire # 1 2 3 4 5 6 7 8
T568A W/G G W/O BL W/BL O W/BR BR
T568B W/O O W/G BL W/BL G W/BR BR
PIN #1
6. Push the EZ-RJ45
®
connector into the EZ-RJ45®
Crimp Tool. Make sure the connector is fully
seated in crimp cavity.
7. Actuate the EZ-RJ45
®
Tool to crimp and trim
wires. Break off any remaining loose wires.
3. Trim wire ends so all
conductors are equal
length and uniform. Use
built in wire cutter in EZ-
®
Crimp Tool.
RJ45
4. Insert wires into the EZ-RJ45® Connector and
pull connector down over the cable jacket. Cable
jacket should seat snugly in rear of connector.
PIN #1
P/N 100044
EZ-RJ45® is a registered trademark of SullStar Technologies Inc..
Patented: 5,996,224, 6,017,237, 6,105,229. Patents insured.
P/N 100004
www.platinumtools.com
805.532.0145
© Platinum Tools, Inc. 2005
EZ-RJ45 IS Sheet half page.pub
Loading...