Plantronics SupraPlus CS351N, SupraPllus series Setup Manual
4 Easy Steps
The fastest way to set up your Plantronics
SupraPlus® Wireless Headset System
Plantronics SupraPlus Wireless SETUP GUIDE
Base Power
Adapter
SupraPlus
Wireless
Headset
Base
SupraPlus
Wireless
Headset
HL10
Automatic
Handset Lifter*
*Not included in all con gurations
2
Plantronics SupraPlus Wireless Setup Guide
HL10 Automatic
Handset Lifter
HL10
User Guide
PLANTRONICS SUPRAPLUS WIRELESS PACKAGE CONTENTS
SupraPlus Wireless With Automatic Handset Lifter** Adds:
Extender
Arm
Ringer
Microphone
Adapter for
Nortel i2004
Phones
HL10 Additional Parts Kit (if needed)
Please refer to the separate Safety Instructions for important product safety information prior
to installation or use of the product.
**Automatic Handset Lifter is bundled with certain SupraPlus Wireless con gurations and also available
separately.
Accessories are available separately.
Monaural
Noise-Cancelling
Headset*
Binaural
Noise-Cancelling
Headset*
R e m o v a b l e
Comfort Pad
A l t e r n a t i v e
Ear Cushions
Telephon e
Cord
A C C h a r g e r
Base
Setup Guide
4 Easy Steps
The fastest way to set up your Plantronics
SupraPlus
®
Wireless Headset System
Plantronics SupraPlusWirelessSG
*One model included in each package–all available models shown.
3
Questions? For fast, efficient Technical Support call: 800-544-4660 Ext. 5538
A. Adjust the Headband
1. To adjust the headband, lengthen or shorten
the band until it ts comfortably. The clickstop
feature keeps the headband securely adjusted.
Position the headset receivers so that the foam
cushions sit comfortably over the center of your
ears.
2. On models with only one receiver, position the
stabilizer T-bar above your ear.
3. For a tighter t, gently pull the opposite ends of
the headset inward as shown.
B. Adjust the Mouthpiece
1. Carefully bend and shape the boom with both
hands as shown. Avoid bending or twisting the
boom near the microphone or earpiece.
2. Position the clickstop turret and boom so that the
microphone is two nger-widths from the corner
of your mouth.
3. Make sure the front of the microphone faces your
mouth. If necessary, twist the micophone slightly
so it’s in the proper position. Do not use forceful
twisting motions or try to turn the microphone
completely around.
ADJUST FIT
STEP
1
2"
50.8mm
front back
A
B
1
2
3
1
2
3
4
Plantronics SupraPlus Wireless Setup Guide
STEP
2
CONNECT BASE TO DESK PHONE
Use Con guration A if:
You will use the Automatic Handset Lifter
or…
Your phone does NOT have built-in headset functionality (no Headset button).
Con guration A
2. Plug the short black Phone Cable that
is pre-installed on the Headset Base into
the now-open handset port [A] on the
desk phone.
1. Unplug the handset coil
cord from the desk phone
handset port [A], then plug it
into the handset port [B] on the
Headset Base.
A
A
Handset
Coil Cord
Handset
Headset Base
(bottom view)
B
It is important for correct and safe operation that the base cord is installed into the proper jack of
your telephone. Follow these instructions carefully, especially if your telephone has two jacks where
the handset was attached. Be sure to note or mark which jack was used for the handset.
5
Questions? For fast, efficient Technical Support call: 800-544-4660 Ext. 5538
Use Con guration B if:
You will NOT use the Automatic Handset Lifter
and…
Your phone has built-in headset functionality (a Headset button).
HANDSET port or HEADSET port?
You should only use the headset port if you will NOT be using the Automatic Handset
Lifter
AND you have a pre-programmed Headset button on your phone.
In this con guration you
MUST press both the Headset button on your phone
AND the Call Control Button on the headset to answer/end calls.
1. Plug the short BLACK Phone
Cable that is pre-installed on
the Headset Base into the
Headset port [C] on the
desk phone.
Con rm there is
a “HEADSET” button
on your phone
Con guration B
C
Headset Base
(bottom view)
Loading...