Page 1
Quick Start User Guide
Supra
®
Telephone
Headsets
© 2002 Plantronics, Inc. All rights reserved.
Plantronics, the logo design, the Plantronics and logo design combined,
and Supra are registered trademarks of Plantronics Inc. in the United States
and various other countries. The clear color and curvature of the voice tube,
and Quick Disconnect are trademarks of Plantronics Inc.
Printed in USA. 61981-01 (07-02)
WELCOME
to hands-free communications from
Plantronics.
With a Plantronics headset, you will
experience a level of comfort and on-the-job
freedom you may never have felt before.
To obtain maximum performance, please
open this guide and follow the quick start
directions to setup and operate your
headset. After you have followed steps
1–6, this side of the guide may be helpful.
345 Encinal Street
Santa Cruz, California 95060
(800) 544-4660
www.plantronics.com
F53N
F53
FCC Requirements—Part 68
This equipment complies with Part 68 of the FCC rules. On the baseline
underside is a label that contains, among other information, the FCC regis-
tration number and ringer equivalence number (REN) for this equipment.
If requested, this information must be provided to the telephone company.
The telephone company may make changes in its facilities, equipment,
operation or procedures that could affect the operation of the equipment.
If this happens, the telephone company should provide you advance
notice in order for you to make the necessary modifications to maintain
uninterrupted services.
If you experience problems with your headset, please refer to the warranty
section for information on warranty and repair service. If the problem is
causing harm to the telephone network, the telephone company may
request that you remove the equipment until the problem is resolved. In
extreme cases, the telephone company may be forced to disconnect your
service before notifying you of the problem.
FCC REGISTRATION INFORMATION
Maintenance Hints for Optimum Performance
■
Replace ear cushion every six months
■
Clean cable with a moist cloth once a month
■
Replace voice tube every six to nine months
Callers cannot hear me
■ For Voice Tube Model F53 determine if the voice tube
is clogged or positioned improperly.
Note: To wash a clogged voice tube: Gently rinse
warm water through the voice tube for a minute then
manually swing or shake it to dry.
■ For Noise-Canceling Model F53N
make sure the
microphone is facing your mouth and positioned
properly.
I cannot hear callers
■
Verify that the Quick Disconnect is connected.
■
Make sure the headset is positioned properly.
For warranty and service information in Japan contact your local distributor.
WARRANTY AND SERVICE
TECHNICAL SUPPORT
For technical support in Japan dial 001 800 544 46600 or contact
your local distributor.
Our Technical Assistance Center telephone numbers are subject to
change without notice at any time, please visit our website at
www.plantronics.com for updated contact information.
For information on accessories visit our website at www.plantronics.com,
or contact your local distributor.
MAINTENANCE/TROUBLESHOOTING
www.plantronics.com/japan/jpn/
F53 QS (61981-01) 7/17/02 4:52 PM Page 2
Page 2
Quick Start User Guide
Supra
®
Telephone
Headsets
© 2002 Plantronics, Inc. All rights reserved.
Plantronics, the logo design, the Plantronics and logo design combined,
and Supra are registered trademarks of Plantronics Inc. in the United States
and various other countries. The clear color and curvature of the voice tube,
and Quick Disconnect are trademarks of Plantronics Inc.
Printed in USA. 61981-01 (07-02)
WELCOME
to hands-free communications from
Plantronics.
With a Plantronics headset, you will
experience a level of comfort and on-the-job
freedom you may never have felt before.
To obtain maximum performance, please
open this guide and follow the quick start
directions to setup and operate your
headset. After you have followed steps
1–6, this side of the guide may be helpful.
345 Encinal Street
Santa Cruz, California 95060
(800) 544-4660
www.plantronics.com
F53N
F53
FCC Requirements—Part 68
This equipment complies with Part 68 of the FCC rules. On the baseline
underside is a label that contains, among other information, the FCC registration number and ringer equivalence number (REN) for this equipment.
If requested, this information must be provided to the telephone company.
The telephone company may make changes in its facilities, equipment,
operation or procedures that could affect the operation of the equipment.
If this happens, the telephone company should provide you advance
notice in order for you to make the necessary modifications to maintain
uninterrupted services.
If you experience problems with your headset, please refer to the warranty
section for information on warranty and repair service. If the problem is
causing harm to the telephone network, the telephone company may
request that you remove the equipment until the problem is resolved. In
extreme cases, the telephone company may be forced to disconnect your
service before notifying you of the problem.
FCC REGISTRATION INFORMATION
Maintenance Hints for Optimum Performance
■
Replace ear cushion every six months
■
Clean cable with a moist cloth once a month
■
Replace voice tube every six to nine months
Callers cannot hear me
■ For Voice Tube Model F53 determine if the voice tube
is clogged or positioned improperly.
Note: To wash a clogged voice tube: Gently rinse
warm water through the voice tube for a minute then
manually swing or shake it to dry.
■ For Noise-Canceling Model F53N
make sure the
microphone is facing your mouth and positioned
properly.
I cannot hear callers
■
Verify that the Quick Disconnect is connected.
■
Make sure the headset is positioned properly.
For warranty and service information in Japan contact your local distributor.
WARRANTY AND SERVICE
TECHNICAL SUPPORT
For technical support in Japan dial 001 800 544 46600 or contact
your local distributor.
Our Technical Assistance Center telephone numbers are subject to
change without notice at any time, please visit our website at
www.plantronics.com for updated contact information.
For information on accessories visit our website at www.plantronics.com,
or contact your local distributor.
MAINTENANCE/TROUBLESHOOTING
www.plantronics.com/japan/jpn/
F53 QS (61981-01) 7/17/02 4:52 PM Page 2
Page 3
TELEPHONE HEADSETS
Quick Start Operation
The Supra F53 is a headset with a voice tube while the
Supra F53N is the same headset with noise-canceling
microphone instead of a voice tube.
1 Identifies the components of both headsets
1.1 Adjustable Headband
1.2 Stabilizer T-Bar
1.3 Cushioned Receiver
1.4 Clothing Clip
1.5 Quick Disconnect™
1.6 Quick Disconnect to Modular Cord
1.7 Voice Tube
1.8 Noise-Canceling Microphone
2 Supra and Supra NC
Position the ear cushioned receiver (1.3) over the center of
your ear.
3 Connecting the headset
The headset cable is terminated with a standard modular
connector.
To use your headset, simply insert the connector into the
headset receptacle in the base unit.
4 Adjusting the voice tube
With one hand, hold the capsule securely against your
head. With your other hand, pull out or push in the voice
tube and rotate the tip so it is two finger widths away from
your face at the corner of your mouth.
5 Adjusting the noise-canceling microphone
5.1 Adjusting the microphone boom
To adjust, carefully shape the boom with both hands as
shown.
Do not bend or twist the boom within 1.5 cm of the
microphone or capsule. Avoid repeated twisting of the
boom.
1.3
1.2
1.4
1.1
1.8
1.2
1.1
1.3
1.4
1.5
1.5
1.7
SUPRA® F53
SUPRA
®
F53N
50.8
mm
6.1
6.2
5.1
5.2
5.3
1.6
1.6
5.2 Position the noise-canceling microphone
Position the microphone approximately 1.5 cm from your
face in front of the corner of your mouth. A protective
windscreen covers the microphone . Do not use your headset
without it. Replacement windscreens are available from your
Plantronics supplier.
5.3 Ensure you speak into the front of the microphone
Make certain to speak into the front of the microphone.
You may need to rotate the microphone toward your lips.
Temporarily remove the protective windscreen in order to
determine which side is the front of the microphone.
Do not force the microphone arm beyond its limits.
6 Clothing Clip and Quick Disconnect
6.1 Adjusting the Clothing Clip
Use the Clothing Clip to keep the headset properly seated,
free from the weight of the cord. Attach the Clothing Clip to
your clothing at a comfortable level.
To adjust the clip position on most models, squeeze the cord
retainer button and slide the cord through to provide
sufficient slack so that head movements do not disturb the
headset.
6.2 Quick Disconnect
Supra headsets are equipped with a Quick Disconnect
module that allows you to leave your work area to perform
other tasks without removing your headset.
Before attempting to use your headset, be sure that the two
Quick Disconnect halves are connected.
SUPRA F53/F53N
®
F53 QS (61981-01) 7/17/02 4:52 PM Page 1
Loading...