Plantronics AUDIO 910 User Manual
USE R GU ID E
Plantronics . a U D i o ™ 910
BLUE TOOTH® HEADSE T SySTEm
0 0 0
TABLE OF CONTENTS PACKAGE CONTENTS
Package Contents 3
Features 4
Charging 5
Powering 6
Pairing 7
Installing PerSonoCall Software 9
Adjusting Fit 12
Using Your Headset 14
Indicator Lights 17
Troubleshooting 18
Technical Assistance 20
Regulatory Notices 20
Warranty 21
Headset
Voyager 510
(Front and Side View)
3 Ear Tips
(Small, Medium, Large)
Headset USB Charging Cable
PerSonoCall
Software CD
USB Bluetooth Adapter
BUA-100
®
REGISTER YOUR PRODUCT ONLINE
Visit www.plantronics.com/productregistration to register your product online
so we can provide you with the best possible service and technical support.
Please refer to the separate Safety Instructions booklet for important product safety
information prior to installation or use of the product.
3
FEATURES CHARGING
Horizontal Boom
Adjustment
Call Control
Button
Charge
Connection
Noise-Canceling
Microphone with
WindSmart® Technology
Power/Mute Button
Listen Volume
Adjust Button +/-
Ear Tip
Pairing/Connect
Button
Indicator Light
USB Charging
Before using, you must first charge your headset. The indicator light flashes red while
charging and turns solid blue when the headset is fully charged.
20 minutes = minimum charge
3 hours = full charge
NOTE: Do not use headset while charging and do not connect the charger while headset is in use.
4 5
POWERING PAIRING
Powering Headset
Press and hold the power/mute button
for three seconds to turn the headset
on or off.
The indicator light flashes blue when the
headset is on.
The indicator light will flash red when
the battery becomes low.
Powering USB Bluetooth Adapter
Pairing Headset with Bluetooth Phone
Before using your headset for the first time, you must pair it with your Bluetooth phone or
device. Be sure the headset is fully charged. For set up and pairing instructions with Bluetooth
devices other than mobile phones, please consult your Bluetooth device user guide.
Turn on both devices.
1. Simultaneously press the listen volume
adjust button marked + (volume up)
and the call control button. Release the
buttons when the indicator light begins
to flash red then blue.
2. While the headset is flashing red and
blue, use the phone menu to search
for Bluetooth devices and select “510
Plantronics”.
3. When prompted for passkey enter
0000. The headset will flash blue when
paired successfully.
The USB Bluetooth adapter is automatically powered on upon inserting into the USB port
of the computer. If your USB port on the computer is hard to access, you can use the USB
extension cable.
NOTE: The USB Bluetooth adapter is automatically active with the current paired headset upon
powering on.
6 7
Loading...