Planex Communications GW USFANG300 User Manual
Quick User Guide of GW-USFang300
Notice.........................................................................................................................2
Installing the software of USB dapter………………………………….3
Configuring your wireless network (with Wireless Utility) ......5
1
Notice
Please notice and cooperate while using this product based on the statement below.
a. FCC Section 15.105
This equipment has been tested and found to comply with the limits for a lass B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different f rom that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
b. Please keep 20cm distance away from the antenna while using this product.
c. Please don’t let this product co-exist or operate with any other transmitter while
using it.
d. FCC Part 15.19
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may
cause undesired operation
e. FCC Part 15.21 information to user
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
2
Installing the software of USB Adapter
1. Select the setup file to install. The setup program will detect user’s
language automatically.
2. The setup program will install the driver and utility to computer. Please
click the “Next” button to continue.
3. The software installation should begin. This may take a few minutes.
3
Loading...