IEEE 802.3af
4-Port Power over Ethernet Injector Hub
POE-400
User’s Manual
- 1 -
Trademarks
Copyright PLANET Technology Corp. 2006.
Contents subject to revision without prior notice.
PLANET is a registered trademark of PLANET Technology Corp. All other trademarks belong to their respective
owners.
Disclaimer
PLANET Technology does not warrant that the hardware will work properly in all environments and applications,
and makes no warranty and representation, either implied or expressed, with respect to the quality, performance,
merchantability, or fitness for a particular purpose.
PLANET has made every effort to ensure that this User’s Manual is accurate; PLANET disclaims liability for any
inaccuracies or omissions that may have occurred.
Information in this User’s Manual is subject to change without notice and does not represent a commitment on
the part of PLANET. PLANET assumes no responsibility for any inaccuracies that may be contained in this User’s
Manual. PLANET makes no commitment to update or keep current the information in this User’s Manual, and
reserves the right to make improvements to this User’s Manual and/or to the products described in this User’s
Manual, at any time without notice.
If you find information in this manual that is incorrect, misleading, or incomplete, we would appreciate your
comments and suggestions.
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the Instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
CE Mark Warning
This is a Class B product. In a domestic environment, this product may cause radio interference, in which case
the user may be required to take adequate measures.
WEEE Warning
To avoid the potential effects on the environment and human health as a result of the presence of
hazardous substances in electrical and electronic equipment, end users of electrical and electronic
equipment should understand the meaning of the crossed-out wheeled bin symbol. Do not dispose of
WEEE as unsorted municipal waste and have to collect such WEEE separately.
Revision
PLANET IEEE 802.3af Power over Ethernet Injector Hub User’s manual
FOR MODEL: POE-400
REVISION: 1.0 (DECEMBER.2006)
Part No.: EM_POE400v1 (2080-A31120-001)
- 2 -
TABLE OF CONTENTS
1. INTRODUCTION.......................................................................................................................................... 4
1.1 C
HECKLIST
1.2 A
BOUT THE POWER OVER ETHERNET INJECTOR HUB
1.3 F
EATURES
1.4 S
PECIFICATION
1.5 P
RODUCT OUTLOOK
2. HARDWARE INSTALLATION...................................................................................................................... 6
2.1. Before Installation................................................................................................................................ 6
2.2 POE-400 and POE-152S, the IEEE 802.3af Injector / Splitter and equipment installation ................. 7
3. TROUBLESHOOTING .................................................................................................................................. 8
APPENDIX A NETWORKING CONNECTION.................................................................................................. 9
A.1 S
WITCH‘S
A.2 RJ-45
................................................................................................................................................ 4
................................................................................... 4
................................................................................................................................................. 4
.......................................................................................................................................... 5
................................................................................................................................... 5
RJ-45 P
CABLE PIN ASSIGNMENT
IN ASSIGNMENTS
................................................................................................................... 9
........................................................................................................... 9
- 3 -