Planet Technology POE-152 User Manual

IEEE 802.3af

Power over Ethernet Injector

POE-152

User’s Manual

- 1 -

Trademarks

Copyright  PLANET Technology Corp. 2006.
Contents subject to revision without prior notice.
PLANET is a registered trademark of PLANET Technology Corp. All other trademarks belong to their respective
owners.

Disclaimer

PLANET Technology does not warrant that the hardware will work properly in all environments and applications,
and makes no warranty and representation, either implied or expressed, with respect to the quality, performance,
merchantability, or fitness for a particular purpose.

PLANET has made every effort to ensure that this User’s Manual is accurate; PLANET disclaims liability for any
inaccuracies or omissions that may have occurred.

Information in this User’s Manual is subject to change without notice and does not represent a commitment on
the part of PLANET. PLANET assumes no responsibility for any inaccuracies that may be contained in this User’s
Manual. PLANET makes no commitment to update or keep current the information in this User’s Manual, and
reserves the right to make improvements to this User’s Manual and/or to the products described in this User’s
Manual, at any time without notice.

If you find information in this manual that is incorrect, misleading, or incomplete, we would appreciate your
comments and suggestions.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the Instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.

CE Mark Warning

This is a Class B product. In a domestic environment, this product may cause radio interference, in which case
the user may be required to take adequate measures.

WEEE Warning

To avoid the potential effects on the environment and human health as a result of the presence of

hazardous substances in electrical and electronic equipment, end users of electrical and electronic

equipment should understand the meaning of the crossed-out wheeled bin symbol. Do not dispose of

WEEE as unsorted municipal waste and have to collect such WEEE separately.

Revision

PLANET IEEE 802.3af Power over Ethernet Injector User’s manual

FOR MODEL: POE-152

REVISION: 1.0 (DECEMBER.2006)

Part No.: EM_POE152v1 (2080-A31120-001)

- 2 -

TABLE OF CONTENTS

1. INTRODUCTION.......................................................................................................................................... 4

1.1 C

HECKLIST

1.2 A

BOUT THE POWER OVER ETHERNET INJECTOR

1.3 F

EATURES

1.4 S

PECIFICATION

1.5 P

RODUCT OUTLOOK

2. HARDWARE INSTALLATION ..................................................................................................................... 6

2.1 B

EFORE INSTALLATION

2.2 POE-152,

2.3 POE-152

2.4 C

ONNECT WITH

3.TROUBLESHOOTING................................................................................................................................... 9

APPENDIX A NETWORKING CONNECTION ............................................................................................... 10

A.1 S

WITCH‘S

A.2 RJ-45

................................................................................................................................................ 4

..........................................................................................4

................................................................................................................................................. 4

.......................................................................................................................................... 5

................................................................................................................................... 5

............................................................................................................................... 6

THE INJECTOR INSTALLATION

AND

POE-152S,

IEEE 802.3

RJ-45 P

CABLE PIN ASSIGNMENT

IN ASSIGNMENTS

THE

AF DEVICES

IEEE 802.3

................................................................................................................. 10

...................................................................................................... 7

AF INJECTOR AND SPLITTER INSTALLATION

...................................................................................................... 8

......................................................................................................... 10

................................ 7

- 3 -

1. INTRODUCTION

1.1 Checklist

Thank you for purchasing our POE-152 IEEE 802.3af Power over Ethernet Injector, your Power over Ethernet
Injector package shall contains following contents:

Check the contents of your package for following parts:



Power over Ethernet Injector x1



User's manual CD x1



Power Adapter x1



Power cord x 1

If any of these pieces are missing or damaged, please contact your dealer immediately, if possible, retain the carton
including the original packing material, and use them against to repack the product in case there is a need to return it to
us for repair.

1.2 About the Power over Ethernet Injector

The POE-152 is an IEEE 802.3af Power over Ethernet Injector that provides DC 48V over Ethernet cables. The POE-152
IEEE 802.3af Power over Ethernet Injector inserts DC Voltage into Cat.5 cable, allowing the cable between the Injector
(POE-152) and Splitter (POE-152S-5V/12V) to transfer data and power simultaneously. The maximum distance between
the Injector (POE-152) and Splitter (POE-152S-5V/12V) is 100 meters. With POE-152 being installed, it combines the
Ethernet digital data with power over the twisted pair cables as an IEEE 802.3af Power over Ethernet Injector. And the
IEEE 802.3af Power over Ethernet splitter shall separate the digital data and the power into two outputs.

Unlike existing Power over Ethernet Injector, except the 10/100Mbps Fast Ethernet connection ability, the POE-152 also
provide 1000Mbps Gigabit Ethernet connection ability.

With IEEE 802.3af Power over Ethernet devices being installed, the system administrator only has to use a single RJ-45
Ethernet cable to carry both power and data to each device. Besides, to connect through POE-152 and
POE-152S-5V/12V, you could also have benefits including cost saving, easy for networking planning and higher reli­ability. What’s more, upon any IEEE 802.3af devices being installed, the POE-152 or together with POE-152S-5V/12V
can make the connection while migrating or splitting the power and the Ethernet digital packets, such as connecting the
POE-152 to an IEEE 802.3af complied devices, AP or IP phone.

1.3 Features



Complies with IEEE 802.3af Power over Ethernet, IEEE 802.3/802.3u /802.3ab 10/100/1000Base-T



Provides DC 48V power over RJ-45 Ethernet cable to device with Ethernet port



LED indicators power input indication



Distance up to 100 meters



Auto-detect of POE IEEE 802.3af equipment, protect devices from being damaged by incorrect installation



Works with EIA568, category 5, 5e or 6 ,2/4-pair cables for 10Base-T or 100Base-TX and 1000Base-T



EMI standards complies with FCC, CE class B

- 4 -