Planet Technology FGSW-2402S User Manual

Trademarks

PLANET is a registered trademark of PLANET Technology Corp. All other trademarks belong to their respective owners.

Disclaimer

PLANET Technology does not warrant that the hardware will work properly in all environments and applications, and makes no warranty and representation, either implied or expressed, with respect to the quality, performance, merchantability, or fitness for a particular purpose.

PLANET has made every effort to ensure that this User’s Manual is accurate; PLANET disclaims liability for any inaccuracies or omissions that may have occurred.

Information in this User’s Manual is subject to change without notice and does not represent a commitment on the part of PLANET. PLANET assumes no responsibility for any inaccuracies that may be contained in this User’s Manual. PLANET makes no commitment to update or keep current the information in this User’s Manual, and reserves the right to make improvements to this User’s Manual and/or to the products described in this User’s Manual, at any time without notice.

If you find information in this manual that is incorrect, misleading, or incomplete, we would appreciate your comments and suggestions.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the Instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

PLANET Smart Switch series

CE Mark Warning

This is a Class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Revision

PLANET Switch User's Manual FOR MODELS: FGSW-2402S Part No.: EM-FG24V1

FGSW-2402S User's Manual

TABLE OF CONTENTS

1. INTRODUCTION..................................................................1

1.1 CHECKLIST.......................................................................1

1.2 ABOUT THE SWITCH..........................................................1

1.3 F

EATURES

1.4 SPECIFICATIONS...............................................................3

2. HARDWARE DESCRIPTION...............................................7

2.1 FRONT PANEL...................................................................7

2.1.1 LED indictor for whole switch...................................8

2.1.2 LED indictor for 10/100Base-TX port.......................8

2.1.3 LED indictor for modules..........................................8

2.1.4 Reset button.............................................................9

2.2 R

EAR PANEL

2.3 HARDWARE INSTALLATION...............................................10

2.3.1 Switch Placement...................................................10

2.3.2 Network Installation................................................12

3.CONFIGURATION..............................................................15

3.1 CONNECT TO PC............................................................15

3.2 MAIN MENU....................................................................16

3.3 SUBMENU: (1) DEVICE CONFIGURATION..........................17

3.4 S

UBMENU

3.5 SUBMENU: (3) PORT STATISTICS.....................................19

3.6 SUBMENU:(4) PORT-BASED VLAN CONFIGURATION.........21

3.7 SUBMENU: (5) PORT TRUNK CONFIGURATION..................22

3.8 SUBMENU: (6) PORT MIRROR CONFIGURATION................23

3.9 SUBMENU: (7) SYSTEM...................................................24

3.10 SUBMENU: (8) PASSWORD............................................25

4. SWITCH OPERATION.......................................................27

4.1 ADDRESS TABLE.............................................................27

4.2 LEARNING.......................................................................27

4.3 FORWARDING & FILTERING .............................................27

4.4 S

TORE-AND-FORWARD

4.5 AUTO-NEGOTIATION........................................................28

........................................................................2

....................................................................9

:(2) P

ORT CONFIGURATION

...................................................27

.............................18

PLANET Smart Switch series

5. TROUBLESHOOTING.......................................................29

APPENDIX A..........................................................................31

A.1 SWITCH’S RJ-45 PIN ASSIGNMENTS ...............................31

A.2 10/100MBPS, 10/100BASE-TX......................................31

A.3 RJ-45 CABLE PIN ASSIGNMENT........................................32

FGSW-2402S User's Manual

This page intentionally left blank!

PLANET Switch series

1. INTRODUCTION

1.1 Checklist

Check the contents of your package for following parts:

FGSW-2402S.

l User's manual. l Power cord. l

19” rack mount brackets.

l RS-232 cable.

If any of these pieces are missing or damaged, please contact your dealer immediately. If possible, retain the carton including the original packing material, and use them against to repack the product in case there is a need to return it to us for repairing.

1.2 About the Switch

With two open slots available for fiber or copper Gigabit modules, the FGSW-2402S can accelerate your Cat5 backbone to 10 times the performance of existing 100 Megabit without re-wiring your cabling infrastructure. The optional Gigabit modules can be Gigabit fiber-optic, (SX or LX) and also Fast Ethernet fiber-optic up to 10 kilometers away. Powered by a non-blocking 9.6Gbps backplane, the FGSW-2402S simplifies the task of upgrading your LAN to cater for increased bandwidth demand.

Equipped with a console interface the Gigabit Smart Switch can be programmed for basic switch management functions such as bandwidth provision, port status configuration, VLAN parameters, port-trunking, and port monitoring.

The switch is suitable for the following applications:

Workgroup switch:

By installing a Gigabit copper NIC such as PLANET’s ENW-9601T (32/64-bit PCI Gigabit Ethernet Adapter), upgrading your workgroups or servers from Ethernet or Fast Ethernet to Gigabit Ethernet is simple, ensuring compatibility for current and future networks and protecting your network investment.

FGSW-2402S User's Manual

Department Switch:

With a proven Gigabit Ethernet Interface, there has never been a better time to connect your workgroups to the backbone using the 4-pair CAT 5/5e UTP cables that already exist in your building. IEEE802.3x flow-control is enabled to ensure high performance Gigabit trunking (up to 4Gbps bandwidth) without any loss of network packets. The choice of Gigabit fiber optic modules includes LX to extend network reach where required.

MTU Switch:

In an MTU/MDU application, the advanced functionality of the FGSW-2402S eliminates traditional problems associated with the use of Ethernet. Users can be segregated with advanced VLAN functionality and the unique ‘MTU switch mode’ to enhance security, and bandwidth managed with tiered bandwidth provision and control using configurable 9 levels of upstream/downstream restriction. This, couple with the flexible 100FX, 1000SX/LX/T module options make the FGSW-2402S one of the best and most cost-effective MTU switch solutions for Multi-tenant service providers.

1.3 Features

Complies with the IEEE802.3, IEEE802.3u, IEEE802.3z and

IEEE802.3ab Gigabit Ethernet standard

w 24 (10/100 Mbps), 2-open slots (10/100/1000Mbps)

Ethernet Smart Switch

w 9.6 Gbps switching fabric, true non-blocking switch

architecture, wire-speed forwarding

10Base-T/100Base-TX ports provide auto-negotiation for

speed and duplex mode selection

w Gigabit Ethernet Module slot support for 10/100/1000Mbps

copper interface, 1000Base-SX/LX or 100Base-FX optic interface.

Prevents packet loss with back pressure (half-duplex) and

802.3x PAUSE frame flow control (full-duplex)

w High performance Store and forward architecture,

broadcast storm control, runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth

PLANET Switch series

w 8K MAC address table, automatic source address learning

and ageing

w 6 Mbit shared data memory buffering w Console interface for switch basic management and setup w Nine levels (3%, 6%, 9%, 12%, 20%, 40%, 60%, 80%, Full

Speed) of configurable symmetric or asymmetric bandwidth provision on each port

w Supports MTU Switch mode to prohibit all 24 ports from

communicating each other but only to 25th or 26th module port

w Support 8-group port-based VLAN w Support 4 trunks per switch, each aggregates up to 8

100Base-TX ports into a 1600 Mbit/s (full-duplex) or 2 1000Base-T/SX/LX ports into a 4000 Mbit/s fat-pipe

Port mirroring allows monitoring of the traffic across any

port in real time

1.4 Specifications

Hardware Specification

Ports 24 10/100Base-TX RJ-45 Auto-MDI/MDI-X ports

2 open slot 1 RS-232 DB-9 male

Dimensions 430 x 200 x 44 mm

1U height

Weight 2.8 kg (5.5 lb) Power Requirement 100~240 (±10%) VAC, 50-60 (±3) Hz Power Consumption /

Dissipation Maximum Current

(@110/240VAC)

40 Watts maximum / 136 BTU/hr maximum

0.15A/0.10A

FGSW-2402S User's Manual

Back pressure for half duplex, IEEE 802.3x for full

MTU VLAN Supported (1~25 uplink to 26, or 1~12

Switch Processing

Store-and-forward

Scheme Address Table 8K entries, auto learning/ageing Queue Buffer 6Mbit shared buffer Flow Control

duplex

Packet Control Runt & CRC filtering, Broadcast storm control

Power, Ready

LED indicators

LNK/ACT, 100, FDX/COL for each port 1000,100,10(FX), FDX/COL, TX, RX for modules

Switch Management

System management Console port Aging Time 1~999 seconds, disable Broadcast Storm

Disable, 6%, 20%

Control Port Configuration Enable/Disable port

10/100/Full/Half/Auto-negotiation Enable/Disable Flow Control Nine levels (3%, 6%, 9%, 12%, 20%, 40%, 60%,

80%, Full Speed) for transmitting (TX) and receiving (RX) rate

Port Statistics Show each port’s statistics data VLAN

uplink to 25 and 13~24 uplink to 26) Up to 8 port-based VLAN groups

Link Aggregation 4 trunks support per switch

Up to 8 10/100 ports or 2 Gigabit ports per trunk

Port Mirroring Mirroring single port’s traffic

PLANET Switch series

Standards Conformance

CE Mark EN50081-1, EN55022 Class A;

Emissions FCC Class A, VCCI Class A, CISPR 22 Class A Safety CSA/NRTL (C.22.2.950, UL1950), TÜV/GS

Immunity EN60555-2 Class A, EN60555-3 Temperature Standard Operating: 0~50ºC (32~122ºF)

Humidity 5% to 95% (Non-condensing) Standards IEEE 802.3 (Ethernet), IEEE 802.3u (Fast

EN50082-1, IEC 1000-4-2/3/4/6

(EN60950)

Storage -40~70ºC (-40~158ºF)

Ethernet), IEEE 802.3ab, IEEE802.3z (Gigabit Ethernet), IEEE8023x (flow control)

FGSW-2402S User's Manual

This page intentionally left blank!

PLANET Switch series

+ 27 hidden pages