Planet Audio PCD4895 Users Manual

INSTALLATION

USING THE

DETACHABLE

FRONT

PANEL

Removing

1.

Before

RELEASE

panel.

2.

Insert fingers into
right side of the frame

remove

remove the frame from the left side.)

3.

Then insert the levers supplied
unit into
unit
Pulling the levers
remove the unit from the dashboard.

the

unit

removing the bezel. press the

button to remove the front

the

groove

and

pull out to

the

as

frame. (You

the

grooves

shown

in

figure until they click.

at

both sides

makes

can

also

it possible to

in the

with

of

DIN

REAR-MOUNT

Installation

sides

Fastenlng
mounting bracket.

I

Select a position where
holes of the bracket and
holes

(are

2 places on

the

the

Use either truss screw

flush surface screw (4
depending
holes in the bracket.

2.

Screw

3.

Factory radio mounting bracket

4.

Dashboard

Note:

mounting bracket are not used

REAR-MOUNT.

using

the

of

the unit.

of

fitted),

The

I

the

unit to

the main unit become aligned

and

tighten the

each

on

the shape

or Console

trim

plece.

(Method

screw holes

the

factory

the

screw

the

screw

screws

side.

(5 x 5mm)

x

5mm),

of

the

backstrap, and

B)

on

radio

screw

for

or

the

at

DETACHING

To slide

the

When the front panel
position, press

the

front
of

Pressing the
will cause

For safekeeping, store the front panel
in the
immediately after being removed.

down

OPENlEJECT

rear

of

of

the

the

panel

supplled protective

THE

FRONT PANEL

the

front panel,

button.

is

the

the front panel toward the

unit,

the

release

and

bracket.

OPEMIEJECT

pull the panel out

front panel to slide

Protectrve

press

in the

DOWN

button

button again

case

Case

on

up.

To

Reinstall

1.

When

DOWN position, insert the front
panel into

OPEN

Button

2.

When
position,
panel in

push

the other side inlo the

bracket, until

Front

3.

Note

that

tock

In

controls
work and
display

OPEN

front panel again.

the

Front

the panel

to

the

insert

its

Panel

position properly,

and

may

button and

bracket

the

bracket. Press

slide

up.

panel is

proper

if the front panel fails

some

in

one

side of the

position,

you

hear amclick"

functions

segments

be

rn~ssing. Press

then

the

may

reinstall

Panel

Is in the

UP

and

some

not

of

LCD

the
the

to

Front

Panel