Planar PT1945S, PT1945R, PT1945RW User Manual

PT1945R / PT1945RW / PT1945S Touch Screen LCD Monitor

USER’S GUIDE

www.planartouch.com

The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be reproduced,translated to another language or stored in a retrieval system, or transmitted by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission. Windows is a registered trademark of Microsoft, Inc. Other brand or product names are trademarks of their respective holders.

The test results show that this device meets the FCC rules. Those limits are set to protect residential areas from the devices with harmful emission. This device will produce, use and radiate radio frequency energy. In addition, failure to follow the user’s manual to install or use this device might produce harmful interference with radio communication. Not withstanding the foregoing, it does not guarantee that this type of harmful interference does not occur in some special installations. The interference caused by this device to the reception of radio or television signals may be veriﬁ ed by turning it on and off. Any changes or modiﬁ cations to this TFT LCD would void the user’s authority to operate this device.

Important Recycle Instructions:

Lamp(s) inside this product contains mercury. This product may contain other

electronic waste that can be hazardous if not disposed of properly. Recycle or dispose in accordance with local, state, or federal laws. For more information, contact the Electronic Industries Alliance at WWW.EIAE.ORG. For lamp speciﬁ c disposal information check WWW.LAMPRECYCLE.ORG.

For more information on how to recycle your product, please visit WWW.PLANARSYSTEMS.COM/GREEN.

Table of Contents

Usage Notice

Precautions ............................................................................................................................ 1

Introduction

About PT1945R/PT1945RW/PT1945S ................................................................................. 2

Touch Screen for PT1945R/PT1945RW/PT1945S .. ....................................................... 2

Package Overview ...................................................................................................... 3

Installation

Product Overview ....................................................................................................... 4

Front View .............................................................................................................. 4

PT1945R/PT1945S Bottom View ............................................................................ 4

PT1945RW Bottom View ........................................................................................ 4

Start Your Installation .................................................................................................. 5

Connecting the Display (Figure 8.1) ............................................................................. 7

(Figure 8.1) ............................................................................................................ 8

Kensington Security Slot ............................................................................................. 9

VESA Mount Your Monitor ..........................................................................................10

Remove the Deskstand ..........................................................................................11

User Controls

Side Panel Controls ...................................................................................................12

How to Use the OSD Menus .......................................................................................13

On-Screen Display Menus ..........................................................................................14

Appendix

Troubleshooting .........................................................................................................15

Warning Signal ..........................................................................................................16

No Signal ...............................................................................................................16

Going to Sleep .......................................................................................................16

Out of Range .........................................................................................................16

Product Dimensions ...................................................................................................17

Compatibility Modes ...................................................................................................19

PT1945R/PT1945S ..................................................................................................19

PT1945RW..............................................................................................................20

Touch Screen Driver Installation ................................................................................21

PT1945R/PT1945RW/PT1945S Optional Calibration Tool Install ..................................21

PT1945R/PT1945RW/PT1945S Install Instructions .................................................22

Product Registration and Technical Support ...............................................................24

Usage Notice

f ﬁ

cause elec

! Warning - To prevent the risk o

this product to rain or moisture.

! Warning - Please do not open or disassemble the product as this ma

tric shock.

re or shock hazards, do not expose

Precautions

Follow all warnings, precautions and maintenance as recommended in this user’s manual to maximize the life of your unit.

Do:

• Turn off the product before cleaning.

• Touch screen surface may be cleaned using a soft clean cloth moistened with mild window glass commercial cleaners or 50/50 mixture of water and isopropyl alcohol.

• Use a soft cloth moistened with mild detergent to clean the display housing.

• Use only high quality and safety approved AC/DC adapter.

• Disconnect the power plug from AC outlet if the product is not going to be used for an extended period of time.

Don’t:

• Do not touch the LCD display screen surface with sharp or hard objects.

• Do not use abrasive cleaners, waxes or solvents for your cleaning.

• Do not operate the product under the following conditions:

- Extremely hot, cold or humid environment.

- Areas susceptible to excessive dust and dirt.

- Near any appliance generating a strong magnetic ﬁ eld.

- In direct sunlight.

Introduction

About PT1945R/PT1945RW/PT1945S

The PT1945R/PT1945RW/PT1945S is a 19" ﬂ at panel screen with an active matrix, thin-ﬁ lm transistor (TFT) liquid crystal display (LCD).

Features include:

• Direct Analog signal input

• Active matrix TFT LCD technology

• PT1945R/S - 1280 x 1024 SXGA resolution

• PT1945RW -1366 x 768 WXGA resolution

• 19" viewable display area

• PT1945R/S - 31.47 ~ 80 KHz horizontal scan

• PT1945RW - 31.47 ~ 60.02 KHz horizontal scan

• 56 ~ 75 Hz high refresh rate

• PT1945R/S - 0.294mm x 0.294mm pixel pitch

• PT1945RW - 0.3mm x 0.3mm pixel pitch

• Auto adjustment function

• Multilingual OSD user controls

• Kensington security slot

• 100 mm VESA mount

• Removable base for ﬂ exible mounting solutions.

• PT1945R/PT1945RW - 5-wire resistive touch screen with dual RS-232 Serial/USB controller.

• PT1945S - SAW touch screen with dual RS-232 Serial/USB controller

• Build-in audio-1W x 2

Touch Screen for PT1945R/PT1945RW

• Analog 5-wire resistive touch screen for ﬁ nger and stylus input

• Surface: Anti-glare treatment

• Interface: Dual RS-232 Serial/USB controller

• Transmittance: 82%±5%

• Driver: Windows® 7, VISTA, XP, 2000, ME, 98, NT 4.0, CE, XP Embedded, Linux, Apple® Mac OS

Touch Screen for PT1945S

• Surface Acoustic Wave (SAW) touch screen for ﬁ nger and stylus input

• Surface: Anti-glare treatment

• Interface: Dual RS-232 Serial/USB controller

• Transmittance: 92±5%

• Driver: Windows® 7, VISTA, XP, 2000, ME, 98, NT4.0, CE, XP Embedded, Linux, Apple® Mac OS

Package Overview

LCD Display

USB Cable ( A to B)

DC Power Supply

(for PT1945RW only)

xxxxxxxxx

USER’S GUIDE

www.planartouch.com

User’s Guide

Power Cord

RS-232 Cable

Touch Screen Driver Installation CD-ROM

Screw

VGA Signal Cable

Audio-in Cable

Landing Strip

Installation

Product Overview

• Front View

PT1945R/PT1945S

• PT1945R/PT1945S Bottom View

AC IN

AUDIO

VGA

POWER SWITCH

• PT1945RW Bottom View

DC IN VGA

AUDIO

RS-232

USB

PT1945RW

RS-232

USB

EARPHONE

POWER SWITCH

Start Your Installation

K K

Please follow these instructions so that you can hookup the cables to associated connector.

1. Lay the LCD ﬂ at on an even surface.

2. Move the stand into position as seen in the step 2 diagram.

3. Remove the cable cover as seen in the step 3 diagram.

4. Connect the cables to the appropriate connectors as seen in the step 4 diagram. Use step 4-1 diagram if using the RS-232 serial connector. Use the step 4-2 diagram if using the USB connector.

5. Position all cables under the cover lip as seen in the step 5 diagram.

6. Re-attach the cable cover . Remove the screw (CBM M3x6) from the accessory box, and insert the screw into the cable cover and monitor as seen in the step 5 diagram.

PT1945R/PT1945S

Step 2

Step 2 Step 3

Step 4-2Step 4-1

Power

Step 5

VGA

Audio

RS-232

Power

VGA

Audio

USB

PT1945RW

Step

Step 2

Step 2 Step 3

Step 4-1

Step 5

Power

VGA

Audio

RS-232

Step 4-2

Power

VGA

Audio

USB

+ 19 hidden pages