Planar PQ1910M User Manual

PQ1910M
LCD Monitor

USER’S GUIDE

www.planar.com

2

The information contained in this document is subject to change without notice. This
document contains proprietary information that is protected by copyright. All rights are
reserved. No part of this document may be reproduced, translated to another language or
stored in a retrieval system, or transmitted by any means, electronic, mechanical,
photocopying, recording, or otherwise, without prior written permission. Windows is a
registered trademark of Microsoft Inc. Other brand or product names are trademarks of
their respective holders.

3

4

TABLE OF CONTENTS

FOR YOUR SAFETY

For Your Safety -------------------------------------------------------------------------------------6

GENERAL NOTES

1. Introduction--------------------------------------------------------------------------------------8

1.1 General Information

1.2 Features

1.3 Check List

2. Installation --------------------------------------------------------------------------------------9

2.1 Installing the base

2.2 Installing the monitor

2.3 Self test pattern

2.4 Adjusting picture

3. Operation of the Monitor -----------------------------------------------------------------11

3.1 Power on/off switch

3.2 Power LED indicator

3.3 OSD control keys

3.4 Safety mode

3.5 Timing guide

3.6 Plug & Play

3.7 Power management

3.8 Volume adjust

4. Specifications ---------------------------------------------------------------------------------17

5. Simple Troubleshooting -------------------------------------------------------------------18

5

FOR YOUR SAFETY

Before operating the monitor, please read this manual thoroughly. This manual should be
retained for future reference.

FCC Class B Radio Frequency Interference Statement
WARNING: (FOR FCC CERTIFIED MODELS)

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy, and if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.

However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY AND MUST BE
RECYCLED OR DISPOSED OF ACCORDING TO LOCAL, STATE OR
FEDERAL LAWS. FOR MORE INFORMATION, CONTACT THE ELECTRONIC
INDUSTRIES ALLIANCE AT WWW.EIAE.ORG
DISPOSAL INFORMATION CHECK WWW.LAMPRECYCLE.ORG.

NOTICE:

1. The changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

2. Shielded interface cables and AC power cord, if any, must be used in order to comply

with the emission limits.

3. The manufacturer is not responsible for any radio or TV interference caused by

unauthorized modification to this equipment. It is the responsibilities of the user to
correct such interference.

WARNING:

To prevent fire or shock hazard, do not expose the monitor to rain or moisture.
Dangerously high voltages are present inside the monitor. Do not open the
cabinet. Refer servicing to qualified personnel only.

6

. FOR LAMP SPECIFIC