Planar CET User Guide

022-1057-00 REV A

NOTES:

1. REFER TO PLANAR SYSTEMS DOCUMENT 023-0281-00 FOR QUALITY INSPECTION PROCEDURES AND DEFECT STANDARDS.

2 NOTE 1 DOES NOT APPLY IN THE 4mm PERIMETER SURROUNDING THE EDGE.

3 THE VIEW SIDE OF THE GLASS IS MARKED WITH A BLUE DOT AS SHOWN. WHEN INSTALLING THE VANDAL GLASS, ENSURE THE BLUE DOT IS ORIENTATED IN CORNER AS SHOWN OF THE VIEW-SIDE OF THE GLASS. IF INSTALLED INCORRECTLY, THE DISPLAY WILL APPEAR PURPLE IN COLOR.

4. GLASS CONFORMS TO UL1950.

THIS DRAWING CONTAINS INFORMATION PROPRIETARY TO PLANAR SYSTEMS, INC., ANY REPRODUCTION IN PART OR WHOLE WITHOUT THE WRITTEN PERMISSION OF PLANAR SYSTEMS IS PROHIBITED. THIS DRAWING IS SUPPLIED FOR INFORMATION, IDENTIFICATIO N, ENGINEERING, EVALUATION, AND/OR INSPECT ION PURPOSES ONLY AND MAY NOT BE USED AS BASIS FOR THE MANUFACTURING OF PRODUCTS OR THE FURNISHING OF SERVICES TO PLANAR SYSTEMS OR TO ANY THIRD PARTY UNLESS AUTHORIZED IN WRITING BY PLANAR SYSTEMS.

REV

REF

A - FIRST RELEASE

ECO-1320 UPDATE VIEW ORIENTATION NOTE 06/17/03

ECO-1392

CORRECT GLASS THICKNESS, DOT LOCATION

DESCRIPTION

REVISIONS

DATE

05/20/03

07/30/03 RD

REV BY

CHK BY

PD -

255.5

333.1

6.80±0.35

VIEW SIDE

ANTI-REFLECTIVE COATING

VIEW SIDE

UNLESS OTHERWISE SPECIF IED

DIMENSIONS ARE IN MILLIMETERS.

TOLERANCES:

X = .XX =

ANGLES =

.X =

DIMENSIONING AND TOLERANCING PER

ASME Y14.5M-1994

THIRD ANGLE PROJECTION

ENGR BY

PETER DRACH

DRAWN BY

PETER DRACH

CHECKED BY

.35

USED ON

MATERIAL

FINISH

LC15.ANN.1000 (1002301)

CLEAR FLOAT GLASS

(2 LAMINATED SHEETS)

06/06/03

TITLE

PLANAR SYSTEMS 1400 NW COMPTON DRIVE BEAVERTON, OR 97006 USA

SPEC-PROD, CET.15.NA

SIZE PART NO. DRAWING NO. REV

997-2698-00 C

SCALE SHEET

1:2.5

021-0170-00

DO NOT SCALE

1 OF 1