Planar AX4, AX5 Quick Reference Manual

AX4/AX5 Display Controller
Quick Reference
Windows XP Windows 2000
020-0494-00A.indd 1020-0494-00A.indd 1 6/19/06 3:31:13 PM6/19/06 3:31:13 PM
Check the system requirements and the safety precautions on page 3. Then follow this order of installation for the Dome display system.
1 Install the display controller into your computer. 2 Connect one or two displays to the display controller. 3 Install the display driver. 4 Con gure the display(s). 5 Install the Dome CXtra software. For more information, refer to the user’s manuals for the display and
the Dome CXtra software.
The port assignments for each display controller are provided in the following table.
Board Port Functionality
AX4 Top Single link
Bottom Single or Dual link
AX5 Top Single or Dual link
Bottom Single or Dual link
2
020-0494-00A.indd 2020-0494-00A.indd 2 6/19/06 3:31:14 PM6/19/06 3:31:14 PM
Before You Begin
Check that your system meets these requirements and runs one of these operating systems.
Board Display System Requirements Operating System
AX4 Dome P1/P2
Dome E2 Dome RE2 Dome E2c Dome RE2c
AX5 Dome E3
Dome RE3 Dome E3c Dome RE3c Dome E4c Dome RE4c
• Intel Pentium 4/Xeon; AMD Athlon 64/K7/XP or compatible
• PCI Express x16 lane slot
• 50 MB hard disk space
• 256 MB RAM
• CD-ROM drive
• Power supply, 350 watts or greater
Before disconnecting a peripheral or removing a component from the motherboard, wait 20 seconds after unplugging the power cord to avoid possible damage to the motherboard.
Wear an antistatic heel or wrist strap when installing the board to avoid damage to computer components.
Windows XP with SP2 or higher
Windows 2000 with SP4 or higher
Warning
Avertissement
Avvertenza
Advertencia
Warnung
Discharge your body’s static electricity by touching the power supply or the metal surface of the computer chassis.
020-0494-00A.indd 3020-0494-00A.indd 3 6/19/06 3:31:14 PM6/19/06 3:31:14 PM
3
Loading...
+ 5 hidden pages