MANUAL
Operation manual: For the first time to use (Or Replace the battery)Need to
frequency bind
Take out the remote control, install the battery
Long press on the frequency key 2-4 seconds, Indicator light will flash
Turn on the power of the car, Indicator light flashes to long lighting, then
frequency bind succeed
If the frequency bind failed (Indicator light flashes) , remove the battery and
repeat steps 1~3
remote control without operation after 10 seconds, Indicator light will off into
power saving mode
Button Description: △ forward ▽backward ◁ turn left ▷turn right
S: Speed P: Open door / Close door
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void th e user's authority to operate the
equipment.
Loading...