Page 1
NEW:
PIEGA PS 101
Technical information
The PS 101 subwoofer was developed with special consideration for outstanding Hi-Fi acoustic
qualities. That is why the highly efficient bass reflex design with two 22 cm LDB bass drivers was
chosen. The drivers are state of the art and are remarkable for their extremely low-loss suspension
and very rigid membrane, which functions as a piston. The very powerful drive ensures the correct
Thiele/Small parameter, great efficiency, and low distortion.
The subwoofer is attractive because of its airy, extremely precise deep bass playback with fantastic
dynamics and perfect impulse reproduction. This is particularly important during music playback,
allowing a great combination with even the highest-quality PIEGA Hi-Fi loudspeakers.
The simple cubic design in elegant aluminium allows the subwoofer to remain integrated and
inconspicuous in a wide variety of environments. What is not inconspicuous at all is its powerful
sound that stands up to both challenging music and home cinema operation.
PIEGA SA
Bahnhofstrasse 29
CH-8810 Horgen, Switzerland
www.piega.ch www.facebook.com/PiegaSwitzerland
Page 2
Equipment
2 22 cm LDB bass
Connection
LFE, Line In, Hi Level
Technical Data
Recommended amplifier output Integrated amplifier
300 watts (peak)
150 watts (RMS)
Sensitivity Variable
Impedance -
Frequency range 28 Hz – 3 dB / variable
Dimensions (H x W x D) 42 x 36 x 40 cm
Weight 25 kg
Design principle Active bassreflex subwoofer
Design variants Silver varnish cabinet, speaker cover silver.
Optional: Black varnish cabinet, speaker cover
black. White varnish cabinet, speaker cover
white.
PIEGA SA
Bahnhofstrasse 29
CH-8810 Horgen, Switzerland
www.piega.ch www.facebook.com/PiegaSwitzerland
Page 3
Terminal fields
1
HIGH PASS
2
OUTPUT
3
INPUT
4
LFE
5
HIGH-LEVEL INPUT
6
LEVEL
7
CROSSOVER
8
PHASE
9
AUTO ON
Low frequency effect input
This input bypasses the internal low-pass filtering.
That means that the cross-over function 7 is not
active.
This input should be used only with a
corresponding subwoofer output (AV receiver sub
output).
These terminals for connecting amplified music
signals allow loudspeaker cables to be used with
and without banana plugs.
Use this knob to control the subwoofer volume.
The “HIGH PASS” switch allows filtering of the LINE
output 2 for the satellite high pass. You can select
60, 80, or 100 Hz, depending on the size of your
loudspeaker.
Line output for the satellite with high pass filter.
Line input
Stereo music signal input for subwoofer.
Use this knob to set the subwoofer upward limit
frequency.
Use this switch to set the subwoofer to “In phase”
or “Out of phase”. Depending on the type of
loudspeaker used, there is either phase
cancellation (less keynote) or phase correctness
(normal keynote) between the subwoofer and
loudspeaker at the 0 setting.
Use this switch to activate the standby automatic
mode so that the subwoofer switches on
automatically when a signal is received and then
back off when the signal ends. In the ON position,
the subwoofer remains on.
PIEGA SA
Bahnhofstrasse 29
CH-8810 Horgen, Switzerland
www.piega.ch www.facebook.com/PiegaSwitzerland
Loading...