Page 1
Installation and
Operation Manual
TSMS2150-4A
3x4 Satellite IF Multiswitch
Operation
Manual
Rev. 03/04
Ph: 800-421-6511
www.picomacom.com
TSMS2150-4A Manual.qxd 4/1/04 3:36 PM Page 1
Page 2
TSMS2150-4A
Descriptions
3x4 Satellite IF Multiswitch
2
Rev. 03/04
Ph: 800-421-6511
www
.picomacom.com
Pico Macom’s TruSpec™TSMS2150 series of professional-grade satellite multiswitches
are used in applications that require satellite IF distr
ibution from 950-2150MHz, including
residential and MDU installations requiring high return loss ports. The advanced circuit
design incor
por
ates a pin diode matrix to route any of the inputs to any of the outputs
by utilizing the 13-14V Right-Circular/Vertical or 17-18V Left-Circular/Horizontal switch-
ing control supplied b
y the satellite receivers, thus eliminating digital artifacts that result
from mechanical relay switching. Separate built-in amplifiers for satellite and VHF/UHF
signals compensate for insertion loss. The
TSMS-2150 series multiswitches, used with
the e
xter
nal po
w
er supply
, will supply po
w
er to the LNB’s reducing heat build up within
the multiswitch and prolong the life of the unit. The
TSMS-2150-4A 3x4 satellite multi-
switch routes input signals from a single satellite with 2 LNB inputs (950-2150MHz) and
an off-air TV antenna input (40-806MHz) to 4 receiver outputs by means of receiver
gener
ated v
oltage 13-14/17-18VDC
.
3x4 Satellite IF Multiswitch
TSMS2150-4A
Wideband frequency range 40-2150MHz
High performance SMD multi-layered
printed-circuit board design ensures
high port-to-port isolation to provide
spurious carrier protection and to
minimize undesired channel interaction, reducing picture distortion
High output return loss ports specifically
designed for MDU networks and multiplesubscriber applications reduces microreflections, improves data recovery and
lowers harmonic distortions
Simple F-type connector interface
design provides 2 LNB and 1 TV antenna
inputs routed to 4 outputs
High-performance PIN diode matrix
reduces polarity transfer time and digital
artifacts providing consistent picture
quality
Antenna signal combines with satellite on
output, eliminating external combining,
reducing cost and clutter
Compatible with most DTH Satellite
ser
vices providing 2 polarities selected
by receiver
-supplied voltage
13-14V/17-18VDC
500mA DC Power pass-through
reduces cost by providing the satellite
receiver a path to power the LNB
Built-in low-distortion amplifier
compensates for insertion loss reducing need for external amplification
Heavy-duty nickel-plated diecast housing
for maximum corrosion resistance
Epoxy-sealed backing prevents moisture migration
Precision machined threads ensure
secure port-to-connector interface for
improved connectivity
Available external UL approved power
supply to reduce heat buildup increas
-
ing unit life
TSMS2150-4A Manual.qxd 4/1/04 3:36 PM Page 2
Page 3
TSMS2150-4A
Installation/Specifications
3
Rev. 03/04
Ph: 800-421-6511
www.picomacom.com
3x4 Satellite IF Multiswitch
Specifications
Input Frequency:
LNB 1 and 2: 950-2150 MHz
TV Antenna: 40-860 MHz
Output Frequency:
Satellite Receiver
950-2150 MHz
Television Antenna 40-860 MHz
Insertion Loss:
950-2150 MHz: 5 dB max.
40-860 MHz: 0 dB max.
Isolation:
Input-Input >28 dB
Output-Output >25 dB
Cross Polarization:
950-1750 MHz: >25 dB
1750-2150 MHz: >20 dB
DC Passing Capacity:
Satellite: 500 mA
TV Antenna: none
Dimensions: 4.34˝(L) x 3.6˝(W) x 0.83˝(H)
Weight : 0.55 lbs.
Connectors: “F” type
Channel Loading Specifications
Ordering Information
TSMS2150-4A 3x4 Multiswitch
Max. Input
Level
T
otal # of
Channels
Output
Level
7
30 dBmV
30 dBmV
24
15 dBmV
15 dBmV
A. Install the switch as shown.
B. All of the RF connections must use 75 ohm coaxial cables.
C. Connect each output of the multiswitch to the input of a TSDM-2150
TV/Satellite Splitter
.
D. Connect the TV output port of the TSDM-2150 to the UHF/VHF RF
input of the TV.
E. Connect the SA
T output port of the TSDM-2150 to the RF input port
of a satellite receiver.
F. Each of the satellite receivers can select programs in either right hand
or left hand circular polarity. To select a RHCP a 13/14 DC switching
voltage is used and to select a LHCP a 17/18 DC switching voltage
is used.
Installation
TSMS2150-4A Manual.qxd 4/1/04 3:37 PM Page 3
Page 4
TSMS2150-4A
Warranty
Limited Warranty
Pico Macom warrants to the original purchaser that all of its new products are of sound design, quality materials and workmanship at the time of manufacture
and will be free from related defects for one year from the original purchase date. Pico Macom will repair or, at its discretion, replace without cost to the original
purchaser, the product which, upon inspection by Pico Macom, appears to be defective or not conforming to factory specifications. Pico Macom will cover the cost
of parts, labor, and return freight from factory.
Five-Year Limited Warranty
Most products designated as “Headend Electronics” are further covered by an extended 4-year period beyond the expiration of the original 1-year warranty, for a full
5-year period. Qualified equipment requiring factory repair during the extended 4-year period is covered under our re-cer tification program. Re-certification fees
under this program shall not to exceed 20% of the product’s List Price and whenever possible, Pico Macom will attempt to upgrade performance to the latest
impro
ved specification.
Warranty Limitations
This warranty excludes coverage of damage or inoperability resulting from (1) use or installation other than in strict accordance with Pico Macom’s written instructions, (2) disassembly or repair by someone other than Pico Macom or a Pico Macom authorized repair center, (3) misuse, misapplication or abuse, (4) alteration,
(5) lack of reasonable care or (6) wind, ice, snow, rain, lightning, power surges, or any other weather conditions or acts of God. Pico Macom’s warranty with respect
to third-party proprietary sub-assembly modules and/or private-label products are limited to the duration and terms of third-party vendors’ warranty. Pico Macom
shall in no event and under no circumstances be liable or responsible for any consequential, indirect, incidental, punitive, direct or special damages based upon
breach of warranty, breach of contract, negligence, strict tort liability or otherwise or any other legal theory, arising directly or indirectly from the sale, use, installation or failure of any product acquired by buyer from Pico Macom. This limited warranty extends to the original purchaser. Pico Macom reserves the right to modify
or discontinue this warranty at Pico Macom’s sole discretion without notification. No other warrantees are expressed or implied.
Uptime Loaner Program
Our Uptime loaner program is designed to provide domestic users of our headend products and commercial systems the best possible support and service. This
program is established to minimize downtime resulting from equipment failure in critical service situations. We offer this program free-of-charge (excluding freight)
to qualified purchasers within the warranty period. The program provides a free equipment loan of like qualified equipment enabling seamless operation for the time
required to repair and return the unit.
The process is simple.
Call our Customer Ser
vice desk requesting a return-merchandise-authorization (RMA) number for the failed equipment and ask for a loaner
unit. We will issue an invoice for the List Price of the loaner unit plus shipping costs. When you receive the loaner unit, pack the failed unit in the loaner unit’s box
and ship it freight prepaid to Pico Macom for repair. When you receive the repaired unit, a new RMA number will be provided in the box. Carefully pack the loaner
unit and affix the ne
w RMA n
umber on the bo
x and ship it bac
k to us f
or full credit excluding shipping costs.
To qualify for the program, you must have current open-terms with us and in good standing. We must receive your failed unit within one week after the loaner unit
is shipped to you, and must likewise receive the loaner unit within one week after the repaired unit is shipped back to you. Daily rental fees not to exceed 10% of
the equipment’s List Price will apply beyond one week after the loaner or repaired unit are shipped to you. Other limitations may apply, so please call us for additional information on qualifying equipment and procedures. Pico Macom reserves the right to modify or discontinue the Uptime Loaner Program at any time, and at
its sole discretion.
Damage or Shortage Claims
Our shipping staff carefully pac
ks and ships y
our orders in compliance with common carr
iers’
requirements
.
Please make note of any obvious damage or shortage
on the freight bill or carrier’s receipt next to your signature. The carrier’s agent must too sign acknowledging the loss. Failure to do so may result in the carrier’s
refusal to honor the claim.
Please open y
our order immediately upon receipt to chec
k f
or concealed damage and compare the pac
king list to the items shipped.
If
damaged, keep the original shipping cartons for possible inspection by the carrier.You must report claims for loss or damage within 3 days of delivery, while claims
f
or erroneous charges or pr
ice corrections m
ust be presented within 30 da
ys of in
voice date.
Returning Shipped Items
To return any shipped items, including those shipped for warranty repairs or credit, call our Customer Service desk to request a Return Merchandise Authorization
(RMA) number. Please reference the original invoice number and purchase date, and product serial number (if any). Be certain to mark the RMA number on the
package boldly and legibly. Unless we specify a different carrier, please ship your returned items to us via UPS freight prepaid and fully insured. If returned for
credit, we will promptly process your request upon receipt of your return order.
Our Return Policy: Your Satisfaction Guaranteed
Our goal is y
our complete satisf
action. If for any reason, our products were not quite what you anticipated, simply call your customer service rep and
we will be happy to assist you in replacing or returning the order.You may return current, non-discontinued items for full credit for up to 30 days from
invoice date. Our requirements are simple: Excepting defective items, the products must be returned in their original packaging and in re-salable
condition. Restocking fees may otherwise apply beyond this period or if products are not returned in their original condition. Please contact your
customer service rep for more information.
4
Rev. 03/04
Ph: 800-421-6511
www
.picomacom.com
TSMS2150-4A Manual.qxd 4/1/04 3:37 PM Page 4
Loading...