Phytec AK-035-1 Instruction Manual

AK-035-1

DSP Color CCD Board Camera

Instruction Manual

Edition Februar 2001

GB

A product of a PHYTEC Technology Holding company

AK-035-1

In this manual are descriptions for copyrighted products which are not explicitly
indicated as such. The absence of the trademark () symbol does not infer that a
product is not protected. Additionally, registered patents and trademarks are
similarly not expressly indicated in this manual

The information in this document has been carefully checked and is believed to be

entirely reliable. However, PHYTEC Meßtechnik GmbH assumes no responsibi­lity for any inaccuracies. PHYTEC Meßtechnik GmbH neither gives any guarantee
nor accepts any liability whatsoever for consequential damages resulting from the
use of this manual or its associated product. PHYTEC Meßtechnik GmbH
reserves the right to alter the information contained herein without prior
notification and accepts no responsibility for any damages which might result.

Additionally, PHYTEC Meßtechnik GmbH offers no guarantee nor accepts any
liability for damages arising from the improper usage or improper installation of
the hardware or software. PHYTEC Meßtechnik GmbH further reserves the right
to alter the layout and/or design of the hardware without prior notification and
accepts no liability for doing so.

 Copyright 2001 PHYTEC Meßtechnik GmbH, D-55129 Mainz. Rights ­including those of translation, reprint, broadcast, photomechanical or similar
reproduction and storage or processing in computer systems, in whole or in part ­are reserved. No reproduction may occur without the express written consent from
PHYTEC Meßtechnik GmbH.

EUROPE NORTH AMERICA

Address: PHYTEC Technologie Holding AG

Robert-Koch-Str. 39
D-55129 Mainz
GERMANY

Ordering
Information:

Technical
Support:

Fax: [phone] [phone]
Web Site: http://www.phytec.de http://www.phytec.com

[phone]

[e-mail]

[phone]

[e-mail]

PHYTEC America LLC
255 Ericksen Avenue NE
Bainbridge Island, WA 98110
USA

[phone]

[e-mail]

[phone]

[e-mail]

2nd Edition: February 2001

 PHYTEC Meßtechnik GmbH 2001 L-350e_2

1 Features:

- Board Size 32x32mm + 42x42mm Stack

- 1/3“ CCD Color DSP Camera

- High Sensitivity (0,25Lux at Max Gain +48dB)

- Y/C output as standard

- 3 types of External sync. selectable

- Digital Zooming available (Stand. 4x)

- Various mode setting available by Jumper Land

- RS-232C control available through R/C unit

external parameter control (optional):

In delivery condition the camera in automatik mode. It is not external
control necessary.
A separate connector (the cable is not provided with the camera, order
nr.: WK 031) control the camera parameters via an RS232 and PC.
The PC-software (Win9x/Win2000/WinNT, is included with the
cable) loads the settings up to the camera. The settings can be stored
permanently in the camera. The describtion of camera parameters are
in the software manual of control program.

Features

Figure 1: controlprogram for VCAM-1-series

© PHYTEC Meßtechnik GmbH 2001 L-350e_2 1

AK-035-1

2 Specifications (Factory setting mentioned in

Gothic letter):

Image sensor : 1/3” color CCD sensor (Sony ICX-059CK)
TV signal system : PAL
Effective pixels : 752 (H) x 582 (V)
Video Output : VBS (1Vpp, 75 Ohm), Y/C separate
Scanning System : 2 : 1 Interlace
Synchronization : Internal / External
External Sync. : VS/VBS or Sync. or HD/VD or Line Lock
Horizontal resolution : 450 TV lines or greater at Y-signal
Gamma correction : 0.45
Min. Illumination : Standard 0.5 Lux (at AGC=ON +39dB, F1.4)

: Minimum 0.25 Lux (at AGC=ON +48dB, F1.4)

S/N ratio : 50 dB or more (AGC= OFF)
AGC : 39 dB Max. (Analog 24dB + Digital 15dB)

: Selectable 8 modes by Jumper (Max. +48 dB)

Electronic Iris/Shutter : E. Iris ON:1/50-1/30,000sec., FL:1/120sec.,

: OFF:1/50sec., shutter speed settable by Jumper

White Balance : ATW ON (2600
BLC : OFF / ON (Center) selectable
Temperatures : 0 to +40 deg.C (-5 to +50 deg.C at working )
Storage-Temperatures : -25 to +60 deg.C
Standard Built-in Lens : Fixfocus f=5.6mm F3.0
Dimensions : 42(W) x 42(L) x 34(H) mm
Weigh : Approx. 35 g (with f=5.6mm lens)

o

K-9000oK) / OFF / selectable

2  PHYTEC Meßtechnik GmbH 2001 L-350e_2

3 Connector Pin Assignment

CN2 CN1

Connector Pin Assignment

JP2

JP1

JP3

11012

AK 035

CN 5:

1. white Y output

2. white C output

3. yellow IRIS output

4. blue SYNC / HD input (Ext. Sync)

5. black GND

6. blue Ext.-VD input (Ext. Sync)

7. black GND

8. white VIDEO (FBAS) output

9. black GND (DC)

10. red POWER input (DC +12V)

CN 7:

1. GND

2. Remote (RS-232)

© PHYTEC Meßtechnik GmbH 2001 L-350e_2 3

AK-035-1

Jumper-land Setting

Function
JP 1 AGC/Gain
JP 2 Shutter
JP 3 WB/BLC

JP 4 Dig. Zoom

Open factory set 22kOhm short
ON / +39dB OFF ON / +24dB
ON elec. Iris OFF 1/120s fixed ON 1/50s fixed
ATW ON
BLC OFF
Stop Tele side Wide side

ATW LOCK ATW ON

BLC ON

More adjustments are possible with resistors combinations in jumper
land (OEM).

The connector CN2 in front of the camera, is used for DC-controlled
IRIS (OEM).

4  PHYTEC Meßtechnik GmbH 2001 L-350e_2

Document: AK-035-1
Document number: L-350e_2, February 2001

How would you improve this manual?

Did you find any mistakes in this manual? page

Suggestions for Improvement

Submitted by:

Customer number:
Name:
Company:
Address:

Return to:

PHYTEC Technologie Holding AG
Postfach 100403
D-55135 Mainz, Germany
Fax : [phone]

© PHYTEC Meßtechnik GmbH 2001 L-350e_2

Published by

 PHYTEC Meßtechnik GmbH 2001 Ordering No. L-350e_2

Printed in Germany