Phonak DigiMaster 5000, DigiMaster 7000 Installation Instructions Manual

1

Installation instructions

Dynamic SoundField

V4.00/2011-09/visu’l/© Phonak AG/All rights reserved/page 1/7

Follow these installation instructions carefully to make sure your Dynamic SoundField system is properly installed.

Dispose of the packaging material as per local regulations.

The following materials are included (if any are missing, contact your local Phonak dealer):

DigiMaster 5000/7000 package

B DA KC

Wall support (1x)

B

Array fixation (1x)

C

Power adapter and power cable
(delivered in separate packages)

OPTION

DigiMaster
loudspeaker (1x)

A

Torx-screws (4x)

Anchors (4x)

Clamps (2x)

D

K

Torx screwdriver T20 (1x)
and hex wrench 5 (1x)
and hex wrench 6 (1x)

Hex-screws (2x)

2

Installation instructions

Dynamic SoundField

V4.00/2011-09/visu’l/© Phonak AG/All rights reserved/page 2/7

Optional: Stand plate package

F G H

Optional: Stand tube package

I

Stand plate (1x)

F

Tube connection (1x)

G

Screw and washer M8 (1x)

H

Stand tube (1x)

I

3

Installation instructions

Dynamic SoundField

V4.00/2011-09/visu’l/© Phonak AG/All rights reserved/page 3/7

The following tools are required for the
installation:

To mount the loudspeaker on the floor stand:

Hex wrench 5* 
Hex wrench 6* 

To mount the loudspeaker on the wall:

Drill with 5mm bit 
Spirit level 
Pencil 
Torx screwdriver T20* 
Hex wrench 5* 

*included in the packaging

1. Selecting the right location

1) Identify an open and safe place, ideally in front of the class,
e. g. on the right or left side of the Smartboard or blackboard.

DigiMaster 5000

DigiMaster 7000

DigiMaster 7000