Page 1
Z4CX Z5CX
Z65CX Z46CX
Z57CX Z69CX
Coaxial Speakers
Z
Page 2
PHOENIX GOLD
FULL RANGE COAXIAL SPEAKERS
SPECIFICATION
Z4CX Z5CX Z65CX
Peak Power (watts) 120 Watts 140 Watts 160 Watts
Rated Power (watts 30 Watts 35 Watts 40 Watts
Frequency Response 44Hz-24KHz 41Hz-24KHz 35Hz-24KHz
Impedance 4 Ohm 4 Ohm 4 Ohm
Sensitivity 83dB 85dB 85dB
Cone Material Polypropylene Polypropylene Polypropylene
Tweeter PEI PEI PEI
Mounting Depth 43mm (1-11/16”) 44mm (1-3/4”) 46mm (1-13/16”)
Mounting Diameter 103 mm (4-1/16”) 118mm (4-5/8”) 126mm (5”)
Z46CX Z57CX Z69CX
Peak Power (watts) 120 Watts 140 Watts 220 Watts
Rated Power (watts 30 Watts 35 Watts 55 Watts
Frequency Response 43Hz-24KHz 35Hz-24KHz 28Hz-24KHz
Impedance 4 Ohm 4 Ohm 4 Ohm
Sensitivity 83 dB 85dB 87dB
Cone Material Polypropylene Polypropylene Polypropylene
Tweeter PEI PEI PEI
Mounting Depth 50mm (2”) 56mm (2-1/4”) 70mm (2-3⁄4”)
Mounting Diameter 142mm x 89mm
(5-9/16” - 3-1/2”)
181mm x 128mm
(7-1/8” - 5 1/16”)
155mm x 222mm
(6-1/8” - 8-3/4”)
INSTALLATION GUIDELINES
Ensure the audio system is turned o before making any connections to the amplier, speakers
or source unit. Failure to do so could result in permanent damage to the audio system.
When wiring the speakers ensure that the wire is protected from sharp objects and always use
rubber grommets when wiring through metal panels. Ensure all terminals and connections are
protected from the vehicle chassis and from each other as failure to do so could result in
permanent damage to the audio system.
When connecting the speakers to the source unit or ampliers ensure you connect the positive
and negative output wire from the source unit to the corresponding speaker terminals. This will
ensure the audio system will be in phase.
1. Ensure there is adequate clearance and depth for the speaker to be mounted.
2. Use the supplied template to mark out & cut the correct diameter hole.
3. Drill four holes for the mounting screws.
4. Separate the grille from the frame
5. Insert the speaker and grille and ax with the screws provided
6. Complete installation by replacing the grille into the grille frame.
Page 3
CONTENTS OF BOX
2 x PHOENIX GOLD COAXIAL SPEAKERS
2 x PHOENIX GOLD SPEAKER GRILLES
1 x MOUNTING TEMPLATE
8 x MOUNTING SCREWS
1 x USER MANUAL
NOTE:
Speaker wire is not included with any
PHOENIX GOLD Coaxial Speaker set,
please use the existing speaker wire from
your vehicle or replace with higher quality
speaker cable.
WARNING
Do not drill mounting holes with speaker
in place as this could allow drill shavings to
damage the voice coil and void your warranty.
WARNING:
Audio Systems can produce sound levels over 135dB. Continuous exposure to sound pressure levels over 100dB
may cause permanent hearing loss. Please watch for emergency vehicles as warning signals may not be heard.
Page 4
Designed and Engineered in the UK
Made in China
Phoenix Gold
A Division of AAMP of America
15500 Lightwave Drive,
Suite 202, Clearwater, FL33760
info@phoenixgold.com
www.phoenixgold.com
Loading...