Phoenix TIGER 3 Instruction Manual

Wingspan : 1500mm (59.2 inch)

Length : 1250mm (49.2 inch)

Weight : 2400gr - 2600gr

Engine : 40 - 46 two stroke / 52 four stroke

Radio : 4 channel / 4 servos standard

g

We wish you many enjoyable flights with your plane and one again thank you for your choosing a Phoenix Model products.

Instruction Manual

nstruction Manual

KIT CONTENTS: We have organized the parts as they come out of the box for better identification
during assembly. We recommend that you regroup the parts in the same manner. This will ensure you
have all of parts required before you begin assembly

AIR FRAME ASSEMBLIES

(2) Wing
(1) Fuselage
(1) Horizontal
(1) Vertical
(1) Instruction manual

main gear assembly

(2) Main gear
(2) 60mm wheel
(4) Collar
(4) 3mm x 4mm screw
(4) Nylon clasp
(8) 3mm x 12mm screw

nose gear assembly

(1) Nose gear

(1) 60mm wheel
(2) Collar
(2) 3mm x 4mm screw
(1) Steering arm

elevator control system

(1) Clevis

(1) Nylon clasp
(1) Nylon control horn
(2) 2mm x 16mm screw

rudder control system

(1) Clevis
(1) Nylon clasp
(1) Nylon control horn
(2) 2mm x 16mm screw

aileron control horn

(2) Clevis
(2) Nylon clasp
(2) Nylon control horn
(2) 2mm x 180mm wire metal pushrod

engine mount

(4) 3mm x 20mm screw
(4) Lock washer

FUel TANK

(1) Fuel tank
(1) Clunk
(1) 110mm silicone tube
(1) Stopper
(1) 160mm x 250mm foam

miscellaneous items

(1) Dihedral
(1) Spinner
(1) Trim tape 25mm x 600mm
(2) 4mm x 30mm screw
(2) Washer
(2) Metal connector
(1) Servo box

KIT CONTENTS

tiger 3

Instruction Manual

10 11

1 2 3

4 5 6

7 8 9

12

13 14 15

1. Joining the wing halves.

2. Installing the aileron servo and linkage.

Draw a center line. Remove the covering. Glue the wing joiner to the wing, using

the epoxy glue.

Apply the epoxy into the wing section. Glue the wing by epoxy. Apply the trim tape to the center section

on the top and the bottom of the wing
where they join.

Servo box. Glue the two hard wood by C.A glue. Mark the shape of the servo box to the

wing.

Remove the covering. Glue the servo box by C.A glue. Install and secure the aileron servo.

Install the two nylon control horn.

Install the clevis to the aileron pushrod.

Attach the clevis to the control horn.

Center line

Hard wood

Servo box

Nylon control horn

Metal pushrod

Clevis

Clevis

Control horn

tiger 3

Instruction Manual