Phoenix Dufour 450 Perse Technical Information

Perse

Dufour 450, built 2013

Technical Information

C a b i n s : 4

H e a d s : 2

M a x . P a x : 8

L . O . A . : 1 3,50 m

B e a m : 4 ,34 m

D r a f t : 2 ,20 m

E n g i n e : V ol vo 55 HP

W a t e r t an k: 570 l

F u e l t a n k: 250 l

B a t t e n e d Main sail: 43,5m² (2013)

G e n oa : 5 5 m ² ( 2 0 13 )

S t ee r i n g w h e e l s : 2

G e n na k e r

Transmitter, depth-sounder

First aid kit

Sea cock cooling water for
engine and fuel emergency
stop

Sea cock, shower and
toilet, waste tank

Gas valve

Windlass main fuse
behind panel

Gas bottles in cockpit

Water heater

Sea cock wash-bowl, toilet

battery main switch

Water tank switch

Bowthruster

Bowthruster fuse

Chart plotter outside

Sea cock shower

Contents

1 Electro-Panel

1.1 Panel

1.2 Panel fuses + shore power display

1.3 Windlass fuse

1.4 Inverter / battery main switch

2 Valves

2.1 Diesel valve emergency stop

2.2 Gas valve for cooker

2.3 Gas valve outside

3 Sanitary & waste tank

3.1 Toilet

3.2 Seacocks

3.3 Waste tank

3.4 Water tank switch

4 Engine & Motor panel

4.1 Engine room

4.2 Motor panel: engine start, engine stop,
shifter, fuel gauge, hour meter

5 Navigation instruments

5.1 Instruments outside

5.2 Chartplotter outside

6 Anchor

6.1 Anchor locker

6.2 Electric windlass

7 Deck & Dinghy

7.1 Gangway (with pin)

7.2 Cockpit shower

7.3 Dinghy

7.4 Outboard

8 Bilge

8.1 Bilge pump

9 Safety Equipment

9.1 Life-jackets and life raft

10 Tipps

11 Information Sheet / Equipment

1.2

Main

panel

fuses

/ shore power

supply

If turned on, the LEDs next to the switch are shining
and indicate that the circuit is powered with 12 / 220
Volts.

- The small green LED for shore power always
needs to be checked when connected to the
jetty. If you are plugged in shore power and
the LED is not shining, the batteries are NOT
being charged and you have to check the
main fuse.

- Water heater is only working when connected
to the shore power. If not used you always
have to turn off the heater to prevent
damage to the electronics.

- All boats are equipped with a power inverter
which is usually located behind the panel or
under the chart table. If used the inverter
draws electricity from the service batteries
even if there is no electronic devices
connected. If not needed the inverter has to
be switched off in order to prevent service
batteries from getting empty.

- Voltage indicator: always make sure the
voltage does not drop below 12V

Attention! If devices are not being used always turn
off the panel switch too!
(e.g. running the bilge pump continuously, the pump
mechanism runs hot and breaks down)

1.1 Panel

While doing the check in we will
give you the basic explanations
(main important functions) of the
instruments. Panel switches are
clearly labeled.