Headphones
3000 Series
TAT3 21 7
User manual
Register your product and get support at
www.philips.com/support
Contents
1 Important safety instructions 2
Hearing safety 2
General information 2
2 Your True wireless earpieces 3
What's in the box 3
Other devices 3
Overview of your True wireless
earpieces 4
3 Get started 5
Charge the battery 5
How to wear 6
Pair the earpieces with your
Bluetooth device for the rst time 6
Pair the earpieces with another
Bluetooth device 7
4 Use your earpieces 8
Connect the earpieces to your
Bluetooth device 8
Power on/o 8
Manage your calls and music 8
Voice Assistant 9
Earpieces/charging case LED
indicator status 9
5 Reset the earpieces 10
6 Technical data 10
7 Notice 11
Declaration of conformity 11
Disposal of your old product
and battery 11
Remove the integrated battery 11
Compliance with EMF 12
Environmental information 12
Notice of compliance 12
8 Trademarks 14
9 Frequently asked questions 15
1 Important
General information
safety
instructions
Hearing safety
Danger
To avoid hearing damage, limit the time you
use headphones at high volume and set the
volume to a safe level. The louder the
volume, the shorter the safe listening time is.
Be sure to observe the following
guidelines when using your headphones.
• Listen at reasonable volumes for
reasonable periods of time.
• Be careful not to adjust the volume
continuously upwards as your
hearing adapts.
• Do not turn up the volume so high
that you can't hear what's around
you.
• You should use caution or
temporarily discontinue use in
potentially hazardous situations.
• Excessive sound pressure from
earpieces and headphones can
cause hearing loss.
• Using headphones with both ears
covered while driving is not
recommended and may be illegal in
some areas.
• For your safety, avoid distractions
from music or phone calls while in
trac or other potentially dangerous
environments.
2 EN
To avoid damage or malfunction:
Caution
Do not expose headphones to excessive heat.
Do not drop your headphones.
Headphones shall not be exposed to dripping
or splashing. (Refer to the IP rating of specic
product)
Do not allow your headphones to be
submerged in water.
Do not charge your headphones when the
connector or socket is wet.
Do not use any cleaning agents containing
alcohol, ammonia, benzene, or abrasives.
If cleaning is required, use a soft cloth, if
necessary dampened with a minimum amount
of water or diluted mild soap, to clean the
product.
The integrated battery shall not be exposed to
excessive heat such as sunshine, re or the like.
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type.
To achieve the specic IP rating, the charging
slot cover must be closed.
Disposal of a battery into re or a hot oven, or
mechanically crushing or cutting a battery, can
result in an explosion.
Leaving a battery in an extremely high
temperature surrounding environment can
result in an explosion or the leakage of
ammable liquid or gas.
A battery subjected to extremely low air
pressure may result in an explosion or the
leakage of ammable liquid or gas.
Operating and storage temperatures
and humidity
• Store in a place where the
temperature is between -20°C (-4°F)
and 50°C (122 °F) with up to 90%
relative humidity.
• Operate in a place where the
temperature is between 0°C (32°F)
and 45°C (113 °F) with up to 90%
relative humidity.
• Battery life may be shorter in high or
low temperature conditions.
• Replacement of a battery with an
incorrect type risks severely
damaging the headphones and the
battery (for example, in the case of
some lithium battery types).
2 Your True
wireless
earpieces
Congratulations on your purchase, and
welcome to Philips! To fully benet
from the support that Philips oers,
register your product at
www.philips.com/support.
With these Philips True wireless
earpieces you can:
• Enjoy convenient wireless
handsfree calls
• Enjoy and control music wirelessly
• Switch between calls and music
What's in the box
USB-C charging cable (for charging only)
Headphones
Series
CTN
Quick start guide
Global Warranty
Safety leaet
Philips True wireless earpieces
Philips TAT3217
Silicone ear tip covers x 3 pairs
Other devices
A mobile phone or device (e.g. notebook,
tablet, Bluetooth adapters, MP3 players
etc) which supports Bluetooth and is
compatible with the earpieces.
EN 3
Overview of your True
wireless earpieces
3
1
2
3
4
5
6
7
1
Multi-function touch (MFT)
2
LED indicator (earpieces)
3
Microphone
4
LED indicator (BT pairing and
reset)
5
Bluetooth pair button
6
LED indicator (battery state or
charging state)
7
USB-C charging slot
4 EN
3 Get started
Note
Tip
Tip
Charge the battery
Before you use your headphones, place them
in the charging case and charge the battery
for 2 hours for optimum battery capacity and
lifetime.
Use only the original USB-C charging cable to
avoid any damage.
Finish your call before charging. Connecting
the earpieces to charge will power them o.
Charging case
Plug one end of the USB-C cable into
the charging case and the other end
into the power source.
Earpiece
Take out the earpieces and remove the
insulation labels.
Put the earpieces back into the
charging case and close the lid.
• The earpieces start charging and the
blue LED light goes on
• When the earpieces are fully
charged, the blue light will go o
Normally, a full charge takes 2 hours (for the
earpieces or charging case) by USB cable.
The charging case serves as a portable backup
battery for charging the earpieces. When the
charging case is fully charged, it will fully
recharge the earpieces 3 times.
EN 5
Loading...