Philips SW7700-67 operation manual

SW7700

© & ™ Lucaslm Ltd.
© Disney

1

2

8

12

11

9

10

3

4

6

5

7

empty page before TOC

English 6

简体中文

25

English

6

Introduction

Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that
Philips offers, register your product at
www.philips.com/welcome.

Please read this user manual, as it contains
information about the features of this shaver as
well as some tips to make shaving easier and more
enjoyable.

General description (Fig. 1)

1 Shaving unit with hair chamber
2 On/off button
3 Replacement reminder
4 Cleaning reminder
5 Travel lock symbol
6 Unplug for use symbol
7 Battery status indicator
8 Socket for small plug
9 Click-on precision trimmer attachment
10 Supply unit
11 Small plug
12 Pouch

Important safety information

Read this important information carefully before
you use the appliance and its accessories and
save it for future reference. The accessories
supplied may vary for different products.

English

Danger

Warning

English

- Keep the supply unit dry.

- To charge the battery, only use the detachable
supply unit (HQ8505) provided with the
appliance.

- The supply unit contains a transformer. Do not
cut off the supply unit to replace it with another
plug, as this causes a hazardous situation.

- This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning and
user maintenance shall not be made by
children without supervision.

- Always unplug the shaver before you clean it
under the tap.

- Always check the appliance before you use it.
Do not use the appliance if it is damaged, as
this may cause injury. Always replace a
damaged part with one of the original type.

- Do not open the appliance to replace the
rechargeable battery.

7

English

8

Caution

- Never immerse the cleaning system or the
charging stand in water and do not rinse it
under the tap.

- Never use water hotter than 60°C to rinse the
shaver.

- Only use this appliance for its intended purpose
as shown in the user manual.

- For hygienic reasons, the appliance should only
be used by one person.

- Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the
appliance.

- If your shaver comes with a cleaning system,
always use the original Philips cleaning fluid
(cartridge or bottle, depending on the type of
cleaning system).

- Always place the cleaning system on a stable,
level and horizontal surface to prevent leakage.

- If your cleaning system uses a cleaning
cartridge, always make sure the cartridge
compartment is closed before you use the
cleaning system to clean or charge the shaver.

- When the cleaning system is ready for use, do
not move it to prevent leakage of cleaning fluid.

- Water may drip from the socket at the bottom
of the shaver when you rinse it. This is normal
and not dangerous because all electronics are
enclosed in a sealed power unit inside the
shaver.

- Do not use the supply unit in or near wall
sockets that contain an electric air freshener to
prevent irreparable damage to the supply unit.

Electromagnetic fields (EMF)

- This Philips appliance complies with all
applicable standards and regulations regarding
exposure to electromagnetic fields.

General

- This shaver is waterproof. It is suitable for use in
the bath or shower and for cleaning under the
tap. For safety reasons, the shaver can
therefore only be used without cord.

- The supply unit is suitable for mains voltages
ranging from 100 to 240 volts.

- The supply unit transforms 100-240 volts to a
safe low voltage of less than 24 volts.

The display

Start-up sequence

When you press the on/off button for the very first
time, all display indications light up in sequence.

Charge the shaver before use.

Charging

Quick charge: When the battery is empty and you
connect the shaver to a wall socket, the lights of
the battery status indicator light up white one after
the other repeatedly. When the battery contains
enough energy for one shave, the bottom light of
the battery status indicator starts flashing white
slowly.

English

9

English

10

While the shaver continues to charge, first the
bottom light of the battery status indicator flashes
white and then lights up white continuously. Then
the second light flashes and lights up
continuously, and so on until the shaver is fully
charged.

Battery fully charged

Note: This shaver can only be used without a cord.

When the battery is fully charged, all lights of the
the battery status indicator light up white
continuously.

Note: When you press the on/off button during or
after charging, the 'unplug for use' symbol lights up
to indicate that the shaver is still connected to the
wall socket.

Note: When the battery is full, the display switches
off automatically after 30 minutes.

Battery low

When the battery is almost empty, the bottom light
of the battery status indicator flashes orange.

Remaining battery charge

The remaining battery charge is shown by the
lights of the battery charge indicator that light up
continuously.

’Unplug for use’ reminder

The ‘unplug for use’ symbol flashes to remind you
that you have to disconnect the shaver from the
wall socket before you can switch it on.

Cleaning reminder

Clean the shaver after every shave for optimal
performance (see 'Cleaning and maintenance').
When you switch off the shaver, the cleaning
reminder flashes to remind you to clean the
shaver.

Travel lock

You can lock the shaver when you are going to
travel. The travel lock prevents the shaver from
being switched on by accident (see 'Activating the
travel lock').

Replacement reminder

For maximum shaving performance, replace the
shaving heads every two years. The shaver is
equipped with a replacement reminder which
reminds you to replace the shaving heads. The
replacement reminder flashes to indicate that you
have to replace the shaving heads (see 'Replacing
the shaving heads').

Note: After replacing the shaving heads, you need
to reset the replacement reminder by pressing the
on/off button for 7 seconds.

English

11

English

12

Charging

Charge the shaver before you use it for the first
time and when the display indicates that the
battery is almost empty.

Charging takes approx. 1 hour. A fully charged
shaver has a shaving time of up to 60 minutes.

Note: You cannot use the shaver while it is
charging.

Charging with the supply unit

1 Make sure the shaver is switched off.
2 Put the small plug in the shaver and put the

supply unit in the wall socket.

The display of the shaver indicates that the
shaver is charging.

3 After charging, remove the supply unit from the

wall socket and pull the small plug out of the
shaver.

Using the shaver

Always check the shaver and all accessories
before using. Do not use the shaver or any
accessory if it is damaged, as this may cause
injury. Always replace a damaged part with one
of the original type.

This symbol indicates that the shaver can be used
in the bath or shower.

- Use this shaver for its intended household use
as described in this manual.

- For hygienic reasons, the shaver should only be
used by one person.

- Trimming is easier when the skin and hair are
dry.

Note: This shaver can only be used without a cord.

Switching the shaver on and off

1 To switch the shaver on or off, press the on/off

button once.

The replacement symbol lights up continuously
when the shaver is switched on.

Shaving

Skin adaptation period

Your first shaves may not bring you the result you
expect and your skin may even become slightly
irritated. This is normal. Your skin and beard need
time to adapt to any new shaving system. To allow
your skin to adapt to this new appliance, we advise
you to shave regularly (at least 3 times a week)
and exclusively with this appliance for a period of
3 weeks.

For the best results on skin comfort, pre-trim your
beard if you have not shaved for 3 days or longer.

Dry shaving

1 Switch the shaver on.
2 Move the shaving heads over your skin in

circular movements to catch all hairs growing in
different directions. Exert gentle pressure for a
close, comfortable shave.

Note: Do not press too hard, this can cause skin
irritation.

3 Switch off and clean the shaver after each use.

English

13

14

English

The display lights up for a few seconds to show
the battery status.

Wet shaving

For a more comfortable shave, you can also use
this shaver on a wet face with shaving foam or
shaving gel.

1 Apply some water to your skin.

2 Apply shaving foam or shaving gel to your skin.

3 Rinse the shaving unit under the tap to ensure

that the shaving unit glides smoothly over your
skin.

4 Switch the shaver on.

5 Move the shaving heads over your skin in

circular movements to catch all hairs growing in
different directions. Exert gentle pressure for a
close, comfortable shave.

Note: Do not press too hard, this can cause skin
irritation.

Note: Rinse the shaving unit regularly to ensure
that it continues to glide smoothly over your
skin.

6 Dry your face.

English

7 Switch off the shaver and clean it after each

use.

Note: Make sure that you rinse all foam or shaving
gel off the shaver.

Using the click-on attachment

Removing or attaching the click-on attachment

1 Make sure the shaver is switched off.
2 Pull the attachment straight off the shaver.

Note: Do not twist the attachment while you
pull it off the shaver.

3 Insert the lug of the attachment into the slot in

the top of the shaver. Then press down the
attachment to attach it to the shaver (‘click’).

Using the precision trimmer attachment

You can use the precision trimmer to groom your
beard, sideburns and moustache.

1 Attach the trimmer to the shaver ('click').
2 Switch on the shaver.

15