Philips SPA5128B User Manual

5.1 Speakers
SPA5128B
User manual
General information
Safety instructions
Please read carefully the safety mark on the back side
This mark is intended to alert the user from the non isolated dangerous voltage within the
constitute a risk of electric shock to persons.
This mark is intented to alert the user for important operating and servicing instruction.
Warnings
Avoid sustained periods on high-volume use, and
do not turn the volume to maximum level while using high output signal, such as Mobile Phone or DVD, etc., as this will cause distortion and may damage the loudspeaker cones.
when not in use.
Do not open the cover or back panel to avoid
electrical shock or any other accidents. No user­serviceable parts are inside.
Only for indoor use.
Plug the system to the AC outlet with the right voltage
marked on the back panel of the Subwoofer.
The MAINS plug is used as the disconnect device, the
disconnect device shall remain readily operable.
Accessories
Item 2RCA-2RCA cable Remote control User manual
Quantity 1 1 1
The product shall not be exposed to dripping or splashing
be placed on the product.
Batteries shall not be exposed to excessive heat such as
Attention should be drawn to the environmental
aspects of battery disposal.
Care and safety information
Avoid high temperatures, moisture, water and dust
Apparatus should not be exposed to dripping or
splashing of liquid.
Do not place any source of danger on the Subwoofer,
Do not install near heat sources.
Do not block any ventilation opening
Place the apparatus in a location with adequate
ventilation to prevent internal heat build up. Allow at least 10cm (4 inches) of free space all around the apparatus for adequate ventilation.
At high volume the back cover of Subwoofer becomes
hot. Do not touch it.
Care of the cabinet
Use a soft cloth slightly moistened to clean the cabinet.
Do not use a solution containing alcohol, spirits, ammonia or abrasives.
Connections
Subwoofer back panel
Top panel operation
/VOL+
Short press
/VOL-
long time press
Short press
long time press
* AVAILABLE IF CONNECTED
VOLUME+/VOL-
VOLUME+/VOL-
1. /SOURCE
2.
1. The Speaker system is in “ ” (stand by) mode when power on, with the orange LED will light up. Please press the “ /SOURCE ” to select appropriate source. Keeping the “ /SOURCE ” key pressed for long will put it back in “ ” (stand by) mode.
2. You can toggle through the input modes by pressing the “ /SOURCE ” key. “ AU ” Denotes AUX Mode. “ USB ” Denotes USB mode. . “BT” Denotes Bluetooth Mode.
3. Vol +/- Manual control for volume. Note: keep at max position to have full control on remote.
VOLUME+/VOL-
VOLUME+/VOL-
MUTE
3. /VOL+
4. /VOL-
USB INPUT
TRACK SELECTION PREVIOUS/NEXT
VOLUME+/VOL-
PLAY/PAUSEMUTE
BT INPUT DVDAUD INPUT
TRACK SELECTION PREVIOUS/NEXT
VOLUME+/VOL-
PIAY/PAUSE
BLUETOOTH FUNCTION CAN BE DISCONNECTED
Remote controls
CENTERFRONT
SUBWOOFERREAR
6.FRONT
CENTER
* AVAILABLE IF CONNECTED
13.REAR
14.SUBWOOFER
FRONT ---- Front volume adjustment. CENTER ---- Center volume adjustment.
REAR ---- Surround volume adjustment.
SUBWOOFER ---- Bass volume adjustment.
总尺寸:660x173mm 工艺:风琴折 成品尺寸:110x86.5mm
Bluetooth Operating Instruction
1. Press SOURCE key from subwoofer’s front panel or remote control to Bluetooth mode;
2. When selected the Bluetooth mode, in display, “bt” will start blinking and hear an audio tone which indicate in Bluetooth pairing mode.
3. For pairing with mobile phone or other Bluetooth devices, search the device named “Philips SPA5128B” and pair it. Once paired, “bt” stops blinking and an audio tone will come up.
4. Press and hold “ ” for 3 seconds from remote control in order to force disconnect the Bluetooth connection.
Note: While using Bluetooth, if external call comes, then speaker system goes in mute mode in order to protect privacy of mobile phone user. Operation resumes once the call is disconnected.
成品正面: 成品背面:
SPA5128B
User manual
Troubleshooting
Warning -
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty.
below before taking the system for repair. If you are unable to remedy the problem by following hints mentioned in below table.
Problem Solution
1. No power.
2. No sound or distorted sound.
3. The remote control does not function properly.
4. Low hum or buzz sound.
drive cannot be read.
6. Slow operation of the USB
7. BT not working. Reduce the distance or device is not paired.
Check if the AC power cord is properly inserted into the AC mains socket.
Adjust the volume / select the correct source to choose the equipment that you want to hear through the system.
Reduce the distance between the remote control and the system. Replace the batteries with new ones / Point the remote control directly towards the IR sensor (located on front panel of the subwoofer) / Check that the batteries
Place the product as far away as possible from electrical devices that may be causing interference / Check power supply voltage and consult electrician.
Drive is
and play. / Take out USB drive and insert it again properly.
Warranty
This Philips 5.1 Multimedia Speaker System is warranted against any defect due to defective materials or workmanship for 12 months from the date of purchase, should a defect develop during the warranty, TPV
OF CHARGE at any of its Authorized Service Center in India.
1. Proof of purchase is not accompanied with this warranty card.
2. The warranty card is not completed immediately after purchase.
3. The apparatus is not used according to this user manual.
4. Defects are caused due to improper or reckless use.
5. Any repairs are done by unauthorized personnel.
6. The serial number is tampered with.
7. Defects due to causes beyond control like lightning, abnormal voltage, acts of God or while in transit to the purchaser’s residence.
All Consumables and parts susceptible to normal wear and tear are not covered under this warranty.
Model No.
Invoice Number
Customer’s Name and address:
Always there to help you!
Visit us at www.support.philips.com
Helpline: 1800 425 6396
Email: india.callcentre@tpv-tech.com
(10 a.m. to 9 p.m. Mondays to Saturdays & 10
a.m. to 6 p.m. on Sundays)
Product Sl. No.
Date of Purchase: / /
PIN:
Dealer Name & Stamp:
10987 11
Total system power 40W RMS
Treble speaker power 5 x5W RMS
Bass speaker power 15W RMS
Separation
SNR
Audio input socket
Audio output socket RCA cable
Power consumption
Subwoofer speaker 1 Way
Speaker size 4 inches
Impedance 2 Ohm
Frequency range 20Hz - 170Hz
Dimension (mm) W x H x D
Weight 3.15kg
>40db
>60db
RCA cable
40W
155 x 262 x 264
Satellite speaker power
Speaker size
Impedance
Frequency range
Product Dimension (mm) W x H x D
Net Weight
BT version V4.2
BT range
capacity
playability
1 Way, 5 Speakers
3 inches
2 Ohm
120Hz - 20KHz
90x 130 x 77
2.0 kg
Up to 10 meters
Up to 32GB
MP3 track
Loading...