Philips SCF255-33 User Manual

EN
ES
FR
EN
ES
FR
Express Bottle and Baby Food Warmer Calentador de Biberones y Comida para
Bebé Express Chauffe-biberon/chauffe-repas Express
Trademarks owned by the Philips Group. © 2008 Koninklijke Philips Electronics N.V.All Rights Reserved.
Las marcas son propiedad del Philips Group. © 2008 Koninklijke Philips Electronics N.V.Todos los Derechos Reservados.
Les marques de commerce sont la propriété du Groupe Philips. © 2008 Koninklijke Philips Electronics N.V.Tous droits réservés.
Call TOLL-FREE: 1.800.54.AVENT
Llame gratuítamente: 1.800.54.AVENT
Appelez SANS FRAIS : 1.800.54.AVENT
42133 5435 151
Please read through these instructions carefully before using your Philips AVENT Express Bottle and Baby Food Warmer for the first time. Please retain for future reference. These instructions are also available on our website.
The Express Warmer allows you to warm all AVENT Feeding Bottles and Magic Cups, as well as baby food jars safely and quickly.
The speed at which the Express Warmer heats the milk or food will depend on the size of the bottle or container and the starting temperature of the milk or food (e.g. room temperature 70 °F or out of fridge 40 °F). The guide at the end of this section gives an indication of the time you can expect the warmer to take. Always test
the temperature of food before feeding to your baby.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed including the following:
1. Read all instructions.
2. Pre-heating of this unit is not necessary.
3. Do not touch hot surfaces. Use handles or knobs.
4. To protect against electrical shock do not immerse cord, plugs or appliance in water or other liquid.
5. Close supervision is necessary when any appliance is used by or near children.
6. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts.
7. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner. For assistance call 1-800-54-AVENT (1-800-542-8368).
8. The use of accessory attachments not recommended by the appliance manufacturer may cause injuries.
EN
3
Philips AVENT Express Bottle and Baby Food Warmer
Contents
a) Basket b) On/Off Switch c) Bottle Warmer Body d) Dial e) Weaning spoon
a
b
=
=
c
2
1
d
3
e
Contenu
a) Panier b) Bouton marche/arrêt c) Cuve d) Cadran e) Cuillère
Contenido
a) Cesta azul b) Interruptor de encendido y apagado c) Cuerpo del Calentador d) Control de Temperatura e) Cuchara
ENPhilips AVENT Express Bottle and Baby Food WarmerEN
54
9. Do not use outdoors. 10 Do not let cord hang over edge of
table or counter, or touch hot surfaces.
11. Do not place on or near a hot gas or electric burner, or in a heated oven.
12. Extreme caution must be used when moving an appliance containing hot oil or other hot liquids.
13. Do not use appliance for other than intended use.
14. When in use the warmer contains hot water.
15. Before plugging in the warmer for the first time, ensure the voltage is compatible with your electrical supply by checking the label on the base of the unit.
16. Always place bottle into warmer before adding water.
17. Ensure water has been added before switching the unit on.
18. When the food has reached the required temperature, remove immediately. If left in the warmer, the temperature of the food will continue to increase.
19. The Express Warmer is fitted with a non-rewireable molded plug. The mains supply cord of the appliance CANNOT be replaced. If the cord is damaged, the appliance should be discarded.
20. This product is manufactured to comply with the Radio Interference Requirements and the EEC Directive 89⁄336⁄EEC.
21. A short power cord has been provided to prevent the risk of it becoming entangled or being tripped over.
22. Extension cords may be used if care is exercised in their use.
23. If an extension cord is used, its electrical rating must be as great as the rating of the appliance and not draped over the edge of the table top where it could be pulled by children or tripped over. The extension cord should be a grounded type 3 wire cord.
24. Failure to follow de-scaling instructions may cause irreparable damage.
25. There are no serviceable parts inside the Express Warmer. Do not attempt to open, service or repair the Express Warmer yourself. For assistance call 1-800-54-AVENT (1-800-542-8368).
SAVE THESE INSTRUCTIONS
Instructions for use
For AVENT Airflex Natural Feeding Bottles
1. Ensure basket is in place inside the warmer.
2. Place the assembled, filled bottle in the warmer with the dome cap removed.
3. For 4oz ⁄ 125ml bottles, fill the warmer with water to just above the level of milk in the bottle.
4. For larger bottles, fill the warmer to 15mm (1⁄2 inch) below the rim of the warmer.
5. Never let the water level rise above the neck of the bottle or spill over the edge of the warmer.
6. Plug the unit into an electrical outlet and click the switch to the ON position (I), the neon light will illuminate. Turn the dial to setting 3.
7. When the bottle has been in the warmer for the appropriate time (See guide), the light will flash on and off intermittently to indicate that the water surrounding the bottle is being kept at a constant temperature.
8. Remove immediately. Replace the dome cap. Shake the bottle and test the temperature of the liquid by sprinkling a few drops onto the back of your hand. Please ensure the lid of the container is tightly secured prior to shaking.
9. If the food is not ready, replace the bottle in the warmer. TAKE CARE NOT TO OVERHEAT. The water surrounding the bottle will be kept at a constant temperature but the temperature of the food will continue to increase. If the food is too hot, allow to cool. Always test temperature before feeding.
10. Once the bottle has reached the correct temperature and has been removed from the unit, switch off warmer (O) and unplug from the electrical outlet.
Note: The basket can be removed when heating the AVENT Magic Cup and other makes of bottles.
For the AVENT Tempo Natural Feeding Nurser
1. Ensure basket is in place inside the warmer.
2. Place the assembled, filled Tempo Nurser in the warmer with the dome cap removed.
3. Fill the warmer with water to the level of milk in the bottle liner.
4. Plug the unit into an electrical outlet and click the switch to the ON position (I). The neon light will illuminate. Turn the dial to setting 2 and continue as 7–10 above.
Note: When using Tempo liners please ensure that you choose the correct settings as using a higher selection may cause liners to burst.
Philips AVENT Express Bottle and Baby Food Warmer
Loading...
+ 7 hidden pages