Philips PSA410/10, PSA410/00, PSA410/05 User Manual
1
2
3
4
5
6
7
8
10
11
12
14
15
16
9
13
NNaammee ooff PPaarrttss
1
LLCCDD ddiissppllaayy
Dynamically displays menu, options and track information
2 22;; Press and hold to power on; press briefly to play / pause
3
−− // ++
Volume control, press --to decrease; press ++to increase
4
ffmm
switches radio on / off.
5
mmooddee
Selects playback options; press and hold
mmooddee
for 3 seconds
6 55 Skips and searches backward tracks; (FM) tunes to stations
7 11 MP3 / WMA-CD only: selects the previous album / skip backward
8 99 Stops music
9
HHeeaaddpphhoonneess jjaacckk
Connects headphones or waistband remote control
0
OOppeenn
Opens the CD lid
! 22 MP3 / WMA-CD only: selects the next album / skip forward
@ 66 Skips and searches forward tracks; (FM) tunes to stations
#
44..55VV DDCC jjaacckk
Charging socket
$
ddbbbb
Switches the bass enhancement on and off
% Switches strobe light on and off
^
hhoolldd..ooffff
Locks / unlocks all buttons on the set
1
PPoowweerr ssuuppppllyy
You can use the following batteries with this CD-player:
> PHILIPS rechargeable batteries, HF18/07/68
IInnsseerrttiinngg rreecchhaarrggeeaabbllee bbaatttteerriieess
1
Press and lift to open the CD lid.
2
Open the battery compartment (inside the CD player).
3 Insert batteries with correct polarity.
Remove batteries if the player is not going to be used for a long time.
Batteries contain chemical substances, so they should be
disposed of properly.
CChhaarrggiinngg
1
Insert the rechargeable battery.
2
Connect the power adapter to the 4.5V DC jack of the player and then to the wall outlet.
Recharging stops after battery is full or when you start playback.
3
When the battery is fully recharged,
BBAATTTT FFUULLLL
appears in the display.
The approximate power level of your batteries is shown on the display.
TIP
> It is normal for the batteries to become warm during recharging.
> If the batteries become too warm, recharging will be interrupted for
approximately 30 minutes.
> To ensure proper recharging on board, take care that contacts are clean.
> Recharging already charged or half-charged batteries will shorten their lifetime.
We therefore recommend that you let the rechargeable battery run till it is
completely empty before you recharge it.
> To avoid a short circuit, do not let the battery touch any metal object.
> If the battery becomes empty soon after recharging, then either its contacts
are dirty or it has reached the end of its lifetime.
✔
2
x2
Use only the AY4103 adapter (4.5 V/ 300 mA direct current, positive pole to the center pin).
Any other product may damage the player.
1 Make sure the local voltage corresponds to the AC/ DC
adapter’s voltage.
2 Connect the AC/ DC adapter to the charging socket of the player and to the wall outlet.
AACC// DDCC AAddaapptteerr
TIP
Always disconnect the adapter when you are not using it.
✔
3
BBaatttteerryy ppllaayyttiimmee
Average playing time of 2 rechargable batteries under normal conditions:
Audio CD MP3/ WMA FM Tuner
Power Saving mode 20 hr 30 hr 30 hr
PPllaayyiinngg aa CCDD
With this set you can play
> all pre-recorded audio CDs (CDDA)
> all finalized audio CDRs and CDRWs
> WMA/MP3-CDs (CD-ROMs with WMA/MP3 files)
1
Press and lift to open the CD lid.
2 Insert a disc, printed side up, by pressing gently on the disc´s center
so that it fits onto the hub. Close the lid by pressing it down.
3 Press and hold 22;; briefly to start playback.
4 Press 22;; briefly to interrupt playback.
➜The time where playback was interrupted blinks.
To resume playback press 22;; briefly again.
5 Press 99 to stop playback.
6 Press and hold 99 2-3 seconds to seconds again to switch
off the CD player.
7 To remove the disc, hold it by its edge and press the hub
gently while lifting the disc.
TIP
> After pressing 22;; it may take some time until the first MP3/WMA track is played.
> By default, playback begins from the exact point when last switched off.
> If a CD-Recordable (CD-R) or a CD-Rewritable (CD-RW) is not recorded
properly,
UUnnffiinnaalliizzeedd CCDD
is displayed, indicating that the CD has not been
finalized. In that case, use
FINALIZE
on your CD recorder to complete the record-
ing.
> When playing a CD, please note that it can take 3-5 seconds after
pressing 22;; for sound reproduction to start.
> Playback will stop if you open the CD lid.
> While the CD is paused, the elapsed play time flashes in the display.
✔
4
Loading...