Philips NORELCO BT1100, NORELCO BT1200, NORELCO BT1300 User Manual
www.philips.com
4222.002.8616.3
Manufactured for:
Philips Consumer Lifestyle
A division of Philips Electronics
North America Corporation
P.O. Box 10313, Stamford, CT 06904
This symbol on the product’s nameplate means
it is listed by Underwriters’ Laboratories, Inc.
Norelco is a registered trademark of
Philips Electronics North America Corporation.
PHILIPS and Philips shield are registered trademarks of
Koninklijke Philips N.V.
©2017 Philips Electronics North America
Corporation. All rights reserved.
BT1100, BT1200
BT1300
IMPORTANT SAFETY
INSTRUCTIONS
When using an electric product, basic precautions should
always be followed, including the following:
Read all instructions before using this product.
DANGER
To reduce the risk of electric shock:
- Do not reach for a corded product that has fallen into water.
Unplug immediately.
- Use the product only in a dry condition. Do not use the
product while bathing or in a shower.
- Do not place or store the product where it can fall or be
pulled into a tub or sink. Do not place or drop the product
into water or other liquid.
- Always unplug this product from the electrical outlet
immediately after use, except when the product is
(re)charging.
- Unplug and remove power supply cord from the product
before cleaning.
WARNING
To reduce the risk of burns, re, electric shock,
or injury to persons:
- Close supervision is required when this product is used
by, on, or near children, or persons with limited physical,
sensory, or mental capabilities or invalids.
- Use this product only for its intended household use as
described in this manual. Do not use attachments not
recommended by Philips Electronics North America
Corporation.
- Never operate this product if it has a damaged cord or
plug, if it is not working properly, if it has been dropped or
damaged, or dropped into water. For assistance call
1-800-243-3050.
- Keep the product, power cord and any attachments away
from heated surfaces.
- Never drop or insert any object into any opening.
- Do not use the adapter in or near a power outlet that
contains an electric air freshener to prevent damage to the
adapter.
- Do not operate, charge, clean or plug in product outdoors
or where aerosol (spray) products are being used or where
oxygen is being administered.
- Always check cutters, cutting unit and combs before using
the product. Do not use the product if cutters, cutting unit or
combs are damaged, as injury may occur.
- Always attach small plug to product rst, then connect
power cord to outlet. To disconnect, push on/o slide to
„OFF“ position, then remove power cord from outlet.
- To prevent possible damage to the power cord, do not wrap
power cord around the product.
- Never put the product in direct sunlight or store at a
temperature above 140°F (60°C).
- Keep the cord dry at all times. Do not handle with wet
hands.
- Never immerse the product in water or rinse under the tap.
- This product is for use on human hair only. Do not use the
product for any other purpose.
- Always store the product, attachments and power cord in a
moisture-free area. Make sure the cord is disconnected from
the product.
- Do not attempt to open the product to remove/replace the
built-in rechargeable battery.
- Only use the power cord supplied with the product.
SAVE THESE INSTRUCTIONS
IMPORTANT: The power plug contains a transformer.
Do not cut o the power plug to replace it with another plug as
this will cause a hazardous condition.
Introduction
Congratulations on your purchase and welcome to Philips
Norelco!
To fully benet from the support that Philips Norelco oers,
register your product at www.norelco.com/register.
1 2
3
4
5
6 7 8 9
10 11
12
1
General Description (Fig. 1)
1 Cutting element
2 Detail trimmer (BT1300)
3 Handle
4 On/o switch
5 Charging light
6 Adjustable comb (1/8–9/32in./3–7mm)
7 Stubble comb (1/16in./1.5mm)
8 Short beard comb (1/8in./3mm)
9 Long beard comb (3/16in./4.5mm)
10 Power plug
11 Small plug
12 Oil
Not shown: cleaning brush
ENGLISH
Using the product
Always check the product and all accessories before you use
it. Do not use the product or any accessory if it is damaged,
as this may cause injury. Always replace a damaged part with
one of the original type.
- Use this product for its intended household use as described
in this manual.
- For hygienic reasons, the product should only be used by
one person.
- Trimming is easier when the skin and hair are dry.
- Turn o and clean the product after each use
(see‚ Cleaning‘).
Note: This product is for cordless use only.
Turning the product on and o
Push the on/o switch up to turn the product on (Fig. 6) or
down to turn the product o (Fig. 2).
Trimming with comb
Note: When you trim for the rst time, start by using the comb at
the maximum trimming length setting to familiarize yourself with
the product.
- The xed combs have 3 lengths that are indicated on
each comb.
- The adjustable comb has 5 hair length settings from
1/8–9/32 in./3–7mm in steps of 3/64 in./1mm.
- The indications on the combs correspond to the remaining
hair length after trimming.
1 Slide the comb onto the cutting element by pressing down
until it is xed into place (Fig. 5).
Note: When you slide the adjustable comb all the way
down, you have selected the 1/8 in./3mm setting. Push the
comb up to select another length setting. Each click is a step
of 3/64 in./1mm.
2 Turn on the product (Fig. 6).
3 To trim most eectively, move the product against the hair
growth direction. Make sure that the surface of the comb
always stays in contact with the skin (Fig. 7).
Trimming without comb
You can use the product without comb to:
- Dene hair lines
- Trim nape of neck
- Remove single, unwanted hairs
Note: Be careful when you are trimming without the comb as
when the product is turned on it will trim every hair it touches.
1 Push the back of the comb upwards until the comb slides
o the product (Fig. 8).
2 Turn on the product (Fig. 6).
3 Make well-controlled movements. Touch the hair/skin
lightly with the product.
- For a comfortable trim close to your skin, place the at
side of the trimming head against your skin and make
strokes against the direction of hair growth (Fig. 9).
- For contouring, hold the trimming head perpendicular
to your skin and move the product upwards or
downwards with gentle pressure (Fig. 10).
Detail trimming (BT1300 only)
You can use the detail trimmer to create ne lines and contours
around your facial style, close to the skin (Fig. 13).
1 Remove the cutting element from the handle by gently
pushing the teeth of the cutting element upwards until it
releases (Fig. 11).
2 Attach the detail trimmer onto the product making sure the
projection on the back of the detail trimmer ts exactly into
the recesses in the hair chamber (Fig. 12).
3 Turn on the product (Fig. 6).
4 Hold the detail trimmer perpendicular to the skin and move
the detail trimmer upwards or downwards with gentle
pressure (Fig. 14).
Cleaning
- Never immerse the product in water or rinse under the tap.
- Never use scouring pads, abrasive cleaning agents or
aggressive liquids such as gasoline or acetone to clean the
product.
OFF
ON
2 3 4 5
OFF
ON
6 7 8 9
10 11
2
1
12 13
2
1
1918
14 15 16
20
17
21
Charging
Charging takes approx. 10 hours. Charge the product before
you use it for the rst time and when the display indicates that
the battery is almost empty or after non-use for a long period
of time.
- Charging, recharging, or using the product at temperatures
below 40°F (4.5°C) or higher than 95°F (35°C) adversely
aects lifespan of the battery.
- Continuously recharging the product will reduce lifespan of
the battery.
- If the product is subjected to a major change in
temperature, pressure or humidity, let the product
acclimatize for 30 minutes before using.
1 Make sure the product is turned o (Fig. 2).
2 Put the small plug in the product and put the power plug in
the wall outlet (Fig. 3).
3 The charging light lights up to indicate that the product is
charging (Fig. 4).
4 After charging, remove the power plug from the wall outlet
and pull the small plug out of the product.
When the product is fully charged, it has a cordless operating
time of up to 45 minutes (BT1300/BT1200) or 30 minutes
(BT1100).
Note: An adapter plug may be necessary for cord usage in some
foreign countries. Use an attachment plug adapter of the proper
conguration for power outlet.
Optimizing the working life of the battery
- After the product has been charged for the rst time,
do not recharge the product between trimming sessions.
Continue using it until the battery is completely empty.
- Do not charge for more than 24 hours.
- Do not keep cord permanently plugged in.
- Discharge/run down the battery completely twice a year by
letting the motor run until it stops.
- If the product hasn‘t been used for a long period of time,
it must be recharged for a full 10 hours.
22
Loading...