Page 1
Quick start guide
MCM119
What’s in the Box?
You should find these items upon opening the box.
FM Antenna MW Antenna Remote Control
1
Quick Start Guide
User Manual
Quick Start Guide
2
User Manual
USB Cable
DB Cable
Pull out the plastic
protective sheet
before use.
Page 2
1
Connect the main set to the left speaker with
the supplied DB cable.
2
Connect the right speaker to the left speaker.
3
Connect the MW and FM antennas.
4
Connect the power cable on the back of the
left speaker.
Tip
See the User Manual for how to
connect other equipment to this
system.
Speaker
(right)
2
MW
antenna
1
3
DB cable
FM wire
antenna
Speaker
(left)
SPEAKER(4
©)
DB15 CONNECTOR
4
RIGHT
TO MAIN
AC MAINS ~
AC power cord
Page 3
Setting the clock
IMPORTANT!
– To set clock in the Eco Power mode, press and hold STANDBY-ON/ECO
POWER
2
on the set for 3 seconds or more to switch to normal standby mode
first before proceeding with the procedures below.
1
In standby mode, press and hold DISPLAY/CLOCK on the remote
control for more than 3 seconds.
2
Press VOLUME +/- (VOL+/- on the remote) repeatedly to select
clock mode.
3
Press VOLUME +/- (VOL+/- on the remote) repeatedly to set the
hour.
4
Press VOLUME +/- (VOL+/- on the remote) repeatedly to set the
minute.
5
Press DISPLAY/CLOCK again to store the setting.
C
Enjoy
Playing a disc
1
Press OPEN•CLOSEç to open the disc tray and load in a disc,
then press the same button again to close the disc tray.
➜ Make sure the label side of the disc is facing up.
2
Press ÉÅ to start playback.
3
To stop playback, press 9.
Page 4
C
Enjoy
Programming and tuning to
radio stations
1
Press TUNER to select the tuner source.
2
Press PROGRAM for more than two seconds to program all
available stations in order of waveband.
3
Press í or ë until the desired preset station is displayed.
Playing a USB mass storage device
With the Hi-Fi system, you can use USB flash memory (USB 2.0 or USB1.1), USB flash players (USB 2.0 or
USB1.1), memory cards (requires an additional card reader to work with this Hi-Fi system).
1
Insert the USB device’s USB plug into the socket on the set.
2
Press SOURCE once or more to select USB (or USB on the remote control).
3
Play the USB’s audio files as you do with the albums/tracks on a CD,
Tip
Detailed playback features and additional functions are described in the
accompany owner's manual.
C Royal Philips Electronics N.V. 2007
All rights reserved.
http://www.philips.com
Printed in China PDCC-JS/JW-0716
Loading...