Philips MCM118, MCM118B User Manual [es]

Micro Hi-Fi System

MCM118 MCM118B

Important notes for users in the U.K.

Mains plug

This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows:

1 Remove fuse cover and fuse.

2 Fix new fuse which should be a BS1362 3 Amp,

A.S.T.A. or BSI approved type.

3 Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 3 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 3 Amp.

Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere.

How to connect a plug

The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L).

¶ As these colour s may not correspond with the

colour markings identifying the terminals in your plug, proceed as follows: – Connect the blue wire to the terminal marked N or coloured black. – Connect the brown wire to the terminal marked L or coloured red. – Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow).

Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires.

Recording and playback of material may require consent. See Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972.

Italia

DICHIARAZIONE DI CONFORMITA’

Si dichiara che l’apparecchio MCM118 Philips risponde alle prescrizioni dell’ar t. 2 comma 1 del D.M. 28 Agosto 1995 n. 548.

Fatto a Eindhoven

Philips Consumer Electronics

Philips, Glaslaan 2

5616 JB Eindhoven, The Netherlands

Norge

Typeskilt finnes på apparatens underside.

Observer: Nettbryteren er sekundert innkoplet. Den innebygde netdelen er derfor ikke frakoplet nettet så lenge apparatet er tilsluttet nettkontakten.

For å redusere faren for brann eller elektrisk støt, skal apparatet ikke utsettes for regn eller fuktighet.

CAUTION

Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.

VAROITUS

Muiden kuin tässä esitettyjen toimintojen säädön tai asetusten muutto saattaa altistaa vaaralliselle säteilylle tai muille vaarallisille toiminnoille.

STANDBY-ON

SOURCE VOLUME

BAND

PROG/CLOCK

MC 118 MICRO SYSTEM

TUNING

AUX-IN

Advarsel: Usynlig laserstråling ved åbning når sikkerhedsafbrydere er ude af funktion. Undgå utsættelse for stråling.

Bemærk: Netafbryderen er sekundært indkoblet og ofbryder ikke strømmen fra nettet. Den indbyggede netdel er derfor tilsluttet til lysnettet så længe netstikket sidder i stikkontakten.

Klass 1 laseraparat Varning! Om apparaten används på annat sätt än i denna bruksanvisning specificerats, kan användaren utsättas för osynlig laserstrålning, som överskrider gränsen för laserklass 1.

Observera! Stömbrytaren är sekundärt kopplad och bryter inte strömmen från nätet. Den inbyggda nätdelen är därför ansluten till elnätet så länge stickproppen sitter i vägguttaget.

Luokan 1 laserlaite

Varoitus! Laitteen käyttäminen muulla kuin tässä käyttöohjeessa mainitulla tavalla saattaa altistaa käyttäjän turvallisuusluokan 1 ylittävälle näkymättömälle lasersäteilylle.

Oikeus muutoksiin varataan. Laite ei saa olla alttiina tippu-ja roiskevedelle.

Huom. Toiminnanvalitsin on kytketty toisiopuolelle, eikä se kytke laitetta irti sähköverkosta. Sisäänrakennettu verkkoosa on kytkettynä sähköverkkoon aina silloin, kun pistoke on pistorasiassa.

Hearing Safety

Listen at a moderate volume.

• Using headphones at a high volume can impair your hearing. This product can produce sounds in decibel ranges that may cause hearing loss for a normal person, even for exposure less than a minute. The higher decibel ranges are offered for those that may have already experienced some hearing loss.

• Sound can be deceiving. Over time your hearing "comfort level" adapts to higher volumes of sound. So after prolonged listening, what sounds "normal" can actually be loud and harmful to your hearing. To guard against this, set your volume to a safe level before your hearing adapts and leave it there.

To establish a safe volume level:

• Set your volume control at a low setting.

• Slowly increase the sound until you can hear it comfortably and clearly, without distortion.

Listen for reasonable periods of time:

• Prolonged exposure to sound, even at normally "safe" levels, can also cause hearing loss.

• Be sure to use your equipment reasonably and take appropriate breaks.

Be sure to observe the following guidelines when using your headphones.

• Listen at reasonable volumes for reasonable periods of time.

• Be careful not to adjust the volume as your hearing adapts.

• Do not turn up the volume so high that you can't hear what's around you.

• You should use caution or temporarily discontinue use in potentially hazardous situations.

• Do not use headphones while operating a motorized vehicle, cycling, skateboarding, etc.; it may create a traffic hazard and is illegal in many areas.

Index

English ------------------------------------------------ 6

Français -------------------------------------------- 18

Español --------------------------------------------- 30

Deutsch --------------------------------------------- 42

Nederlands ---------------------------------------- 54

Italiano ---------------------------------------------- 66

English

Français

EspañolDeutschNederlandsItalianoSvenskaDanskSuomi

Svenska --------------------------------------------- 78

Dansk ----------------------------------------------- 90

Suomi --------------------------------------------- 102

Português ---------------------------------------- 114

Eλληνικά ----------------------------------------- 126

Português

Eλληνικά

Contenido

Español

Información General

Información medioambiental ........................... 31

Accesorios incluido ........................................... 31

Información de seguridad ................................. 31

Preparativos

Conexiones posteriores ............................ 32–33

Antes de utilizar el control remoto ............... 33

Colocación de la pila (litio CR2032) en el

control remoto ................................................... 33

Controles

Controles del sistema y mando a

distancia ................................................................ 34

Funciones básicas

Para activar el sistema ....................................... 35

Espera automática para el ahorro de

energía .................................................................. 35

Ajustes de volumen y de sonido ..................... 35

Funcionamiento de CD

Reproducción de un CD .................................. 36

Selección de una pista ....................................... 36

Búsqueda de un pasaje dentro de una pista .... 36

Los modos de reproducción: SHUFFLE y

REPEAT ................................................................. 37

Programación de pistas ..................................... 37

Revisión del programa ...................................... 37

Borrado de un programa.................................. 37

Otra conexión

Escucha de una fuente externa ....................... 37

Mantenimiento ...................................... 37

Reloj/Temporizador

Ajuste del reloj ................................................... 39

Ajuste del temporizador .................................. 39

Activación y desactivación de TIMER

(temporizador) ................................................... 39

Activación y desactivación de la función

SLEEP .................................................................... 39

Especificaciones ..................................... 40

Resolución de problemas ............. 41

Recepción de radio

Sintonización de emisoras de radio ............... 37

+ 11 hidden pages