Micro Hi-Fi System
MCM1006
/51/55/93/77
CONTENTS
Technical specification and version variation .........................1-1..1-2
Service measurement setup..........................................................1-3
Service aids .................................................................................1-4
Instructions on CD playability ...............................................2-1.. 2-2
Block diagram................................................................................3-1
Wiring diagram ..............................................................................4-1
Circuit diagram...................................................................... .5-1..5-5
Layout diagram.......................................................................6-1..6-4.
Exploded view diagram .................................................................7-1
©
Copyright 2012 Philips Consumer Electronics B.V. Eindhoven,The Netherlands
All rights reserved. No part of this publication may be reproduced, stored in a retrieval
system or transmitted, in any form or by any means, electronic, mechanical, photocopying,
or otherwise without the prior permission of Philips.
Published by GD 1201 Service Audio Subject to modification
Version 1.3
3141 785 37183
PCBs location
1-1
Display board
VERSION VARIATION
Type /Versions:
Board in used:
USB BOARD
DISPLAY BOARD
MAIN BOARD
Features
RDS
VOLTAGE SELECTOR
ECO STANDBY - DARK
Service policy
Type /Versions:
Feature diffrence
USB BOARD
/51/55/93/77
LATAM/APMEA
Main board
MCM1006
M/C
M/C
M/C
MCM1006
/51/55/93
* TIPS : C -- Component Lever Repair.
M -- Module Lever Repair
-- Used
Unit in Master carton: N/A
Weight (excluding packing and batteries): 2.05 kg
Units in Dealer carton: 1 set
Dimensions with Boxes 532 x 242 x 200mm (LxWxH)
Dimensions without Boxes: 532x242x200
Weight (including packing): 2.35kg
DC operation / Backup Buffer
( DEMO mode " OFF " ) , NOM. A, INPUT
DC operation / Backup Buffer
R20 (UM1 / D-cell) x 6 (9V normal, 6.3V limit)
GENERAL PART 1 - GENERAL SPECICFICATION
Refer to the section of Version Overview
@ 1/8 Prated , NOM. A, INPUT
: - 10 Dregree till + 50 Degree
RADIATION / IMMUNITY requirments ( EMC )
Refer to the section of Version Overview
CDSM with Tuner , CD, USB
GENERAL PART 1 - TECHNAICAL SPECICFICATION
( *1 ) Electrical parameters are to be measuremend at specker terminals across 6 Ohm load ( pure resistor )
with rated input signal in AUX mode; with DBB OFF
Left / Right : 4 Ohms at 125Hz to 16KHz
2.5 mW +/-0.3mW ,
at R Load = 32 ohm @ max volume, 0dB, 1kHz CD
: .2W, 1 Channels (Lim: -1dB)
-6 dB track (Audio Disc 1 ,Trk 35
( At 500mW Output in flat Mode)
-6 dB track (Copy from Audio Disc 1 ,Trk 35)
FM 67.5KHZ,AM80% Modulation(Limit :-6db)
Line Out ( Left / Right )
-6 dB track (Audio Disc 1 ,Trk 35
Input Sensitity ( ± dB ) rated ouput power at 1 kHz
Line Output Voltage ( *1 )
Residual Noise ( Volume Minium )
OUTPUT stage Protection : Yes Temperature : YES Shorcircuit : Yes
2 x 2W matching LOUDSPEAKER of 2 x 4R. One INPUT SOURCE
Standby Mode Indicator : LCD display off
( At Cold Condition with 10% THD )
OUTPUT POWER ( * 1 ) At THD = 10% , 1KHz sinewave
: 2W, 1 Channels (Lim: -1dB)
CLOCK / CD SPECICFICATION
- Refer to Philips USB direct user requirement
spec.
Channel Unbalance (250 to 10k Hz)
Frequency Response(±3dB)
(@ volume max - 20dB and DBB off mode)
: 100Hz~10kHz
Signal to Noise Ratio(A-weighted)
8+/- 2 dB at AUX 500mV, 1kHz
Search tuning sensitivity
Search tuning sensitivity
Noise Limited Sensitivity 26 dB
Distortion ( RF 1mV, Frq Dev.75 kHz )
Distortion ( RF 50mV, m=80% )
Refer to version overview
Search tuning stop accuracy
RF >= 1V/m
RF >= a26 to 1V/m
Refer to version overview
Refer to version overview
FM S/N Ratio(A weighted) Mono input
80dBf
Search Tuning Stop Accuracy RF:
91~120dBf
R/F:31~91dBf
FM Channel Seprantion -400/1K/5K
MEASUREMENT SETUP
Tuner FM
1-3
Bandpass
LF Voltmeter
e.g. PM2534
RF Generator
e.g. PM5326
DUT
250Hz-15kHz
e.g. 7122 707 48001
Ri=50:
S/N and distortion meter
e.g. Sound Technology ST1700B
Use a bandpass filter to eliminate hum (50Hz, 100Hz) and disturbance from the pilottone (19kHz, 38kHz).
Tuner AM (MW,LW)
RF Generator
e.g. PM5326
Ri=50:
DUT
Frame aerial
e.g. 7122 707 89001
Bandpass
250Hz-15kHz
e.g. 7122 707 48001
LF Voltmeter
e.g. PM2534
S/N and distortion meter
e.g. Sound Technology ST1700B
To avoid atmospheric interference all AM-measurements have to be carried out in a Faraday´s cage.
Use a bandpass filter (or at least a high pass filter with 250Hz) to eliminate hum (50Hz, 100Hz).
CD
Use Audio Signal Disc
(replaces test disc 3)
DUT
L
R
SBC429 4822 397 30184
S/N and distortion meter
e.g. Sound Technology ST1700B
LEVEL METER
e.g. Sennheiser UPM550
-
Recorder
Use Universal Test Cassette CrO2 SBC419 4822 397 30069
or Universal Test Cassette
LF Generator
e.g. PM5110
Fe SBC420 4822 397 30071
DUT
L
R
S/N and distortion met
e.g. Sound Technology ST170
LEVEL METER
e.g. Sennheiser UPM550
with FF-filter