Philips KWR112401A User Manual

Philips Home Control

Manual of KWR112401/01B

Confidential	©Philips Home Control,	Page 1 of 8
	2011

Philips Home Control

FCC Statement

FCC Part 15.19

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference and

(2)this device must accept any interference received, including interference that may cause undesired operation.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

No special accessory is required to enable the equipment to comply with the emission limits.

Confidential	©Philips Home Control,	Page 2 of 8
	2011

KWR112401/01B

Table of Contents

1. INTRODUCTION		4
1.1	GENERAL DESCRIPTION	4
1.2	FREQUENCY SYNTHESIS AND MODULATION	4
1.3	RF INTERFACE	4
1.4	ANTENNA DIVERSITY	4

2.	RADIO INFORMATION			5
	2.1	APPLICABLE FREQUENCY RANGE		5
3.	RF EVALUATION APPLICATION OPERATING MANUAL			6
4.	RF TESTING			7
	4.1	SET UP PROCEDURE FOR TX MODES		7
	4.1.1 Select +0dBm output power level			7
	4.1.2		Select RF4CE channel	7
	4.1.3		Select RF port/antenna	7
	4.1.4 Turn TX on, un modulated CW			7
	4.1.5 Turn TX on, modulated CW			7
	4.2	SET UP PROCEDURE FOR RX MODE		7
	4.2.1		Select RF4CE channel	8
	4.2.2		Turn RX on	8
	4.2.3 Antenna Diversity and Antenna Selection			8

Status :Draft	Page 3 of 8
Philips Home Control		Company Restricted