Philips ID9650B/12, ID965 Quick Start Manual
What is in the box
EN
Welcome to Philips
Register your product at www.philips.com/welcome
Quick Start Guide
ID965
Power supply
for the handset
charger
Note
In some countries, you have to connect the line adaptor to the line cord, then plug the line
•
cord to the line socket.
In multi-handset packs, there are additional handsets and chargers with power supply units.
•
Caution
Use only the supplied batteries and adaptor
•
Charging cradle Handset
User Manual
Guarantee
Quick start guide
© 2009 Koninklijke Philips Electronics N.V. All rights reserved.
Reproduction in whole or in part is prohibited without
the written consent of the copyright owner.
Trademarks are the proper ty of Koninklijke
Philips Electronics N.V. or their
respective owners.
Printed in China
0168
ID965H_12_EN_QSG_V4.0
Welcome
EN
1 2
Charge
Enjoy
Online help:
www.philips.com/support
Install the handset
The batteries are pre-installed in the handset. Follow
1
the direction of the arrow printed on the bat tery tape
and pull it off from the battery door before charging.
Place the handset on the charging cradle to charge the
2
handset.
Charge the bat teries for 24 hours before r st use.
Note
For more information on the batter y icon status, see the
User Manual.
Ensure the handset and base station are powered on and
linked before you can charge the handset.
Congure your phone (if necessary)
Set the date and time.
1
The phone is now ready to use.
»
Make a call
Press 1 and dial the phone number; or
Dial the phone number and press
2
dial out the call.
Answer a call
When the phone rings, press
1
answer the call.
Adjust the earpiece volume
Press
1
or to adjust the volume
during a call.
Set the handset’s ringtone
You can select from 20 ringtones.
menu
Press
1
Select
2
TONES]
[SELECT]
Select a ring tone, then press
3
to conrm.
»
.
[PERSONAL SET]
[RING TONES]
>
to conrm.
The setting is saved.
[HANDSET
>
, then press
[SELECT]
to
or to
ECO mode
Troubleshooting
[ECO]
The
power of the handset and base station.
1
2
3
Note
mode reduces the transmission
Press menu.
[ADVANCED SET]
Select
[SELECT]
press
Select the new setting, then press
[SELECT]
The setting is saved.
»
[ECO]
»
standby mode.
When the
the connection range between the
handset and the base station can be
reduced.
to conrm.
to conrm.
is displayed instead of in
[ECO]
[ECO]
>
mode is activated,
, then
No dialing tone
Check your phone connections.
•
The handset is out of range. Move it closer to the base station.
The signal icon ashes
The handset is out of range. Move it closer to the base station.
•
If the handset displays [UNREGISTERED], register the handset.
The caller ID does not display
The service is not activated. Check with your service provider.
•
The caller’s information is withheld or unavailable.
For more information, see the User Manual.
Loading...