Philips ID9370 User Manual
ID9370_IFU_EN_US.book Page 6 Tuesday, February 13, 2007 12:48 PM
ID9370_IFU_EN_US.book Page 7 Tuesday, February 13, 2007 12:48 PM
Contents
3 Safety information
8Important Information
8For your safety
8Need Help?
9 Configure your ID9370
9 Install battery
10 Language
10 Registration
11 What’s in the box?
12 Your ID9370
12 Overview of the handset
14 Install
15 Call
17 Personal Settings
22 Advanced Settings
23 Games
25 Troubleshooting
27 Information
29 Index
EN
7
ID9370_IFU_EN_US.book Page 8 Tuesday, February 13, 2007 12:48 PM
EN
Important Information
For your safety
This equipment is not designed to make emergency calls in the event of a power failure.
Alternative arrangements should be made for access to emergency calls.
To avoid damage or malfunction:
- Do not allow the product to come into contact with liquid.
- Do not open it as you could be exposed to high voltages.
- Never use any battery type other than the one supplied.
- Do not hold the handset too close to your ear when the phone is ringing or when
activating the loudspeaker as it may damage your hearing.
- Do not expose the phone to excessive heat caused by heating equipment or direct
sunlight.
- Do not drop your phone or allow objects to fall on your phone.
- Do not use any cleaning agents containing alcohol, ammonia, benzene, or abrasives as these
may harm the set.
- Active mobile phones in the vicinity may cause interference.
About operating and storage temperatures:
- Operate in a place where temperature is always between 0 and 35º C (32 to 95º F).
- Store in a place where temperature is always between -20 and 45º C (-4 to 113º F).
- Battery life may be shortened in low temperature conditions.
Need Help?
For more information on troubleshooting:
Troubleshooting: page 25
Please refer to the following website for more information on Philips web support:
Online Support
www.philips.com/support
8
ID9370_IFU_EN_US.book Page 9 Tuesday, February 13, 2007 12:48 PM
Configure your ID9370
Install battery
Your ID9370 is supplied with 2 rechargeable batteries allowing approximately up to 12 hours of
talk-time and up to 150 hours stand-by time. Before using the handset, the batteries have to be
installed and fully charged.
1. Use the coin or screwdriver to unlock the battery cover.
screw
charger contact plate
Bottom View
2. Place the batteries as indicated and replace the cover.
3. Lock the battery cover.
screw
charger contact plate
anticlockwise
Unlock
clockwise
Lock
EN
Bottom View
Please use a coin or screwdriver that is the right shape and size for the screw that is used.
Otherwise you may damage the screw when tightening it.
9
ID9370_IFU_EN_US.book Page 10 Tuesday, February 13, 2007 12:48 PM
EN
Configure your ID9370
Language
Your ID9370 can support different display languages.
To change the language
1. Press mMENU, scroll : to Personal Set and press mSELECT, scroll : to Lan-
guage and press
2. Scroll
A validation tone is emitted and the screen returns to previous menu.
mSELECT.
: to your desired language and press mSELECT to confirm.
Registration
The procedures described below are the procedures that you will find in your ID9370 handset.
The procedures may vary according to the handset you want to register. In this case, please
refer to the manufacturer of the additional handset.
Additional handsets must be registered to the base unit before you can use them. Up to 6
handsets can be registered to one base station.
The Master PIN is required before you can register or unregister handsets. The default
PIN is 0000.
Register your ID937
After charging it for a few minutes, the word WELCOME appears on a blue screen. Next, the
idle screen appears. Follow these steps to register your handset:
1. In idle mode, the message “Press Base page key for 3 secs. Press and hold
prompted on the screen. Follow the screen instructions to start registration.
2. Enter PIN will be displayed on your screen. Enter the default Master PIN number - 0000.
3. Press
mOK to confirm your registration.
All the handset keys (except the m key) are deactivated until the above registration
process is completed.
m” will be
10
ID9370_IFU_EN_US.book Page 11 Tuesday, February 13, 2007 12:48 PM
What’s in the box?
The following accessories are included:
Handset 2 AAA rechargeable
Splitter
Power supply for
base station
User Guide Warranty card
NiMH batteries
EN
11
ID9370_IFU_EN_US.book Page 12 Tuesday, February 13, 2007 12:48 PM
EN
Your ID9370
Overview of the handset
Event LED
(top of the handset)
LCD Screen
Left Soft key
Talk key
Keypad lock key /
Format key
Loudspeaker key
Up/Down Navigation
keys
Earpiece
Right Soft
key
Hang-up key
Alphanumeric keypad
Case key / Pause
key /
Intercom key
12
Microphone
ID9370_IFU_EN_US.book Page 13 Tuesday, February 13, 2007 12:48 PM
Your ID9370
Handset keys
Press To
m
>
r
e
u
d
c
v
#
F
*WARNING Handsfree activation can suddenly increase the volume in the earpiece to a
very high level. Make sure the handset is not too close to your ear.
Enter the main menu from stand-by mode.
Select the function displayed on the handset screen directly above it.
Activate mute function during a call.
Switch on the backlight.
Go to redial list from stand-by mode.
Select the function displayed on the handset screen directly above it.
Initiate a second call, consult phonebook, call transfer or activate/deactivate
HD Sound mode during a call.
Switch on the backlight.
Answer an incoming external or internal call.
Insert R for operator services when on the line.
Hang up a call.
Return to stand-by mode.
Long press in stand-by mode to switch off the handset, short press to switch
on the handset again.
Access call log from stand-by mode.
Scroll up a menu list or go to the previous phonebook or call log record.
Increase earpiece volume during a call.
Go to the previous character in editing mode.
Access phonebook from stand-by mode.
Scroll down a menu list or go to the next phonebook or call log record.
Decrease earpiece volume during a call.
Go to the next character in editing mode.
Initiate an internal call in idle mode.
Short press to initiate an internal call during a call or switch call between an
internal and external call.
Long press to initiate a conference call with an external call and another
internal call.
Answer an incoming call in handsfree mode.
Activate and deactivate the loudspeaker* during a call.
Dial # in stand-by mode.
Long press to mute the ringer in stand-by mode.
Long press to insert a pause in dialling mode.
Long press to switch between upper and lower case in editing mode.
Dial * in stand-by mode.
Long press to activate and deactivate keypad lock.
Change the display format when viewing a 7-, 10- or 11-digit call log record
(with numbers starting with the digit 1).
EN
13
Loading...