Philips HX9170/10, HX9110/02 User manual

Always here to help you / 始终如一地为您提供帮助

Question?

有疑问?

Contact Philips

请联系飞利浦

Sonicare FlexCare Platinum

Table of content

ENGLISH 4 繁體中文 23 简体中文 40

Sonicare FlexCare Platinum

ENGLISH

Introduction

Congratulations on your purchase and welcome

toPhilips!Tofullybenetfromthesupportthat

Philips offers, register your product at www.philips.com/welcome.

Important

Read this user manual carefully before you use the appliance and save it for future reference.

Danger

- Keep the charger and/or sanitiser away from water. Do not place or store it over or near water contained in a bathtub, washbasin, sink etc. Do not immerse the charger and/or sanitiser in water or any other liquid. After cleaning, make sure the charger and/or sanitiser is completely dry before you connect it to the mains.

Warning

- The mains cord cannot be replaced. If the mains cord is damaged, discard the charger and/or sanitiser.

ENGLISH 5

- Always have the charger and/or sanitiser replaced with one of the original type in order to avoid a hazard.

- Do not use the charger and/or sanitiser outdoors or near heated surfaces. Do not operate the sanitiser where aerosol (spray) products are being used or where oxygen is being administered.

- If the appliance is damaged in any way (brush head, toothbrush handle, charger and/or sanitiser), stop using it. This appliance contains no serviceable parts. If the appliance is damaged, contact the Customer Care Centre in your country (see chapter “Guarantee and support”).

- This appliance can be used by children aged from 8 years and above and by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the

ENGLISH6

appliance in a safe way and if they understand the hazards involved. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and its cord out of reach of children aged less than 8 years.

- Children shall not play with the appliance.

- Discontinue use of the sanitiser if the UV light bulb remains on when the door is open. UV light can be harmful to the human eye and skin. Keep the sanitiser out of the reach of children at all times.

Caution

- Do not clean the brush head, the handle, the charger, the charger cover and/or the sanitiser in the dishwasher.

- If you have had oral or gum surgery in the previous 2 months, consult your dentist before you use the toothbrush.

ENGLISH 7

- Consult your dentist if excessive bleeding occurs after using this toothbrush or if bleeding continues to occur after 1 week of use. Also consult your dentist if you experience discomfort or pain when you use the Sonicare.

- The Sonicare toothbrush complies with the safety standards for electromagnetic devices. If you have a pacemaker or other implanted device, contact your physician or the device manufacturer of the implanted device prior to use.

- If you have medical concerns, consult your doctor before you use the Sonicare.

- This appliance has only been designed for cleaning teeth, gums and tongue. Do not use it for any other purpose. Stop using the appliance and contact your doctor if you experience any discomfort or pain.

ENGLISH8

- The Sonicare toothbrush is a personal care device and is not intended for use on multiple patients in a dental practice or institution.

- Stop using a brush head with crushed or bent bristles. Replace the brush head every 3 months or sooner if signs of wear appear.

- Do not use other brush heads than the ones recommended by the manufacturer.

- If your toothpaste contains peroxide, baking soda or bicarbonate (common in whitening toothpastes), thoroughly clean the brush head with soap and water after each use. This prevents possible cracking of the plastic.

- Do not insert objects into the air openings of the sanitiser or block these air openings by placing it on a soft surface or in a position or location where objects will block these openings (examples of objects: magazine, tissue paper and hair.

ENGLISH 9

- The UV light bulb is hot during and immediately after the sanitising cycle. Do not touch the UV light bulb when it is hot.

- Do not operate the sanitiser without the protective screen in place to avoid contact with a hot bulb.

- If the sanitiser has been used for 3 consecutive UV clean cycles (i.e., 3 times in a row), switch it off for at least 30 minutes before ou start another UV clean cycle.

Electromagnetic elds (EMF)

This Philips appliance complies with all standards regarding electromagnetic

elds(EMF).Ifhandledproperly

and according to the instructions in this user manual, the appliance is safe to use

basedonscienticevidenceavailable

today.

ENGLISH10

General description (Fig. 1)

1 Hygienic travel cap

2 Brushheadwithuniqueidentier

3 Handle 4 Power on/off button 5 Intensity level indicator 6 Intensity level button (+ and -) 7 Brushing modes

8 Modebutton

9 Battery level indicator 10 UV sanitiser and base with integrated charger

andcordwrap(specictypesonly)

- Not shown: UV light bulb

- Not shown: Sanitiser drip tray

- Not shown: Protective screen for UV light bulb

11 Mainscordwithplug 12 Deluxecharger(specictypesonly)

13 Charger cover with brush head holders and

base with cord wrap

14 Travel charger

- Not shown: Travel case

Note: The contents of the box may vary based on the type purchased.

Preparing for use

Attaching the brush head

1 Align the front of the brush head with the

front of the handle.

2 Firmly press the brush head down onto the

metal shaft until it stops.

Note: Sonicare Platinum brush heads come with easily

identiable icons to identify your brush head.

ENGLISH 11

Charging the appliance

1 Put the plug of the charger or sanitiser in a

wall socket.

2 Place the handle on the charger.

, The ashing light of the battery level indicator

shows that the toothbrush is charging.

Note: It takes at least 24 hours to fully charge the battery.

Using the appliance

Brushing instructions

1 Wet the bristles and apply a small amount

of toothpaste.

2 Place the toothbrush bristles against the teeth

at a slight angle towards the gumline.

3 Press the power on/off button to switch on

the Sonicare.

4 Apply light pressure to maximise Sonicare’s

effectiveness and let the Sonicare toothbrush

do the brushing for you. Do not scrub.

5 Gently move the brush head slowly across

the teeth in a small back and forth motion so the longer bristles reach between your teeth. Continue this motion throughout your brushing cycle.

Note: To make sure you brush evenly throughout the mouth, divide your mouth into 4 sections using the Quadpacer feature (see chapter “Features”).

ENGLISH12



6 Brush each section for 30 seconds for a total

brushing time of 2 minutes. Start with section 1 (outside top teeth) and then brush section



2 (inside top teeth). Continue with section

3 (outside bottom teeth) and nally brush

section 4 (inside bottom teeth).

Note: After you have completed the brushing cycle, you can spend additional time brushing the chewing surfaces of your teeth and areas where staining occurs. You may also brush your tongue, with the toothbrush switched on or off, as you prefer.

The Sonicare is safe to use on:

- Braces (brush heads may wear out more quickly when used on braces)

- Dentalrestorations(llings,crowns,veneers,implants)

Brushing modes

1 Clean: The ultimate in plaque removal

(default mode).

2 White: 2 minutes to remove surface stains and

30 seconds to brighten and polish your front teeth.

3 Gum care: Combines the Clean mode with

an additional minute to gently stimulate and massage gums to improve gum health.

The Sonicare comes with the Clean mode activated.

Note: When the toothbrush is switched on, you cannot toggle between modes.

1 Before you switch on the Sonicare, press the

mode button to toggle between modes. , The selected brushing mode lights up. , Once a brushing mode has been selected,

it remains active until another brushing mode

is selected.

ENGLISH 13

Note: When the Sonicare is used in clinical studies, the default 2-minute Clean mode must be selected. The handle has to be fully charged and the Easy-start feature must be deactivated.

Intensity levels per mode

- Low:1LEDindicatorlight

- Medium:2LEDindicatorlights

- High:3LEDindicatorlights

Note: To adjust the intensity level to the next higher or lower level, you can press the + button to increase intensity or the - button to decrease intensity at any time during the brushing cycle.

Pressure Sensor

A change in vibration (and a slight change in sound) alerts you when you apply too much pressure while

brushing.Seechapter‘Features’.

Battery status (when handle is not on charger)

- 1yellowLEDindicatesalowcharge.

- 3greenLEDsindicateafullcharge.

Note: If you hear a long beep and the yellow LED of

the battery level indicator ashes, the rechargeable

battery is empty and the Sonicare switches off. Place the handle on the charger to recharge it.

Note: To keep the battery fully charged at all times, you can keep the Sonicare on the charger when you are not using it.

ENGLISH14

Features

Pressure Sensor

This Sonicare comes with the Pressure Sensor feature activated. The Pressure Sensor works in all 3 modes and at all 3 intensity levels. To deactivate or reactivate the Pressure Sensor feature:

1 Place the handle with a brush head attached on

the plugged-in charger or sanitiser.

2 Press and hold the power button and the

mode button for 2 seconds. , You hear 1 beep to indicate that the Pressure

Sensor has been deactivated.

, You hear 2 beeps to indicate that the Pressure

Sensor has been activated.

Quadpacer



- The Quadpacer is an interval timer that has a short beep and pause to remind you to brush the 4 sections of your mouth. Depending on the



brushing mode you have selected, the Quadpacer beeps at different intervals during the brushing cycle. The Quadpacer works in all 3 modes and at all 3 intensity levels.

The Quadpacer feature on this Sonicare has been activated. To deactivate or reactivate the Quadpacer feature:

1 Place the handle with a brush head attached on

the plugged-in charger or sanitiser.

ENGLISH 15

2 Press and hold the mode button for 2 seconds.

, You hear 1 beep to indicate that the Quadpacer

has been deactivated.

, You hear 2 beeps to indicate that the Quadpacer

has been activated.

Smartimer

The Smartimer indicates that your brushing cycle is complete when it automatically switches off the toothbrush at the end of the brushing cycle. Dentists recommend brushing at least 2 minutes, twice a day.

Easy-start

TheEasy-startfeaturegentlyincreasespowerover therst14brushingstoletyougetusedtobrushing withtheSonicare.TheEasy-startfeatureonlyworks

in the Clean mode and at the High intensity level.

ThisSonicarecomeswiththeEasy-startfeature deactivated.ToactivateordeactivatetheEasy-start

feature:

1 Attach your brush head to the handle.

2 Place the handle on the plugged-in charger

or sanitiser.

3 Activate or deactivate Easy-start:

, To activate Easy-start: Press and hold the power

on/off button for 2 seconds. You hear 2 beeps

to indicate that the Easy-start feature has been activated.

, To deactivate Easy-start: Press and hold the

power on/off button for 2 seconds. You hear

1 beep to indicate that the Easy-start feature has been deactivated.

ENGLISH16

Note: Each of the rst 14 brushings must be at least 1 minute in length to properly move through the Easy-

start ramp-up cycle.

Note: Using the Easy-start feature beyond the initial ramp-up period is not recommended and reduces Sonicare’s effectiveness in removing plaque.

Cord wrap on charger (specic types only)

If your Sonicare includes the charger cover and base,



the travel charger is pre-installed inside the cover.

1 To separate the charger cover from the

charger base, press the two gray snap bars on



the charger base and pull the white charger

cover upwards.

2 Wrap excess mains cord around the gray

charger base as shown in the picture. Be sure to wrap the cord on the inside of the two

snap levers. Guide the cord through the small groove in the back of the charger base.

3 To reattach the charger cover, press it down

over the charger base until it snaps into place.

Tip: For extra convenience during travel, you can remove the travel charger and use it without the charger cover and charger base.

ENGLISH 17

Sanitising (specic types only)

- With the UV sanitiser you can clean your brush head after every use.

Unplug the sanitiser, discontinue use and call Consumer Care if:

- The UV light bulb remains on when the door is open.

- The window is broken or missing from the sanitiser.

- The sanitiser gives off smoke or a burning smell while it is operating.

Note: UV light can be harmful to the human eye and skin. The Sanitiser should be kept out of reach of children at all times.

1 After brushing, rinse the brush head and shake

off excess water.

Do not place the travel cap on the brush head

during sanitisation.

2 Place your nger in the door recess on top

of the sanitiser and pull open the door.

3 Place the brush head on one of the 2 pegs

in the sanitiser with the bristles facing the light bulb.

Note: Only clean Sonicare snap-on brush heads in the sanitiser.

Note: Do not clean Sonicare for Kids brush heads in the sanitiser.

4 Put the plug in a wall socket.

5 Close the door and press the green power

on/off button once to select the UV clean cycle.

ENGLISH18

Note: You can only switch on the sanitiser if the door is properly closed.

Note: The sanitiser stops if you open the door during the sanitising cycle.

Note: The sanitiser operates for 10 minutes and then

automatically switches off.

, The sanitiser is in operation when the

light glows through the window.

Cleaning

Do not clean the brush head, handle, travel charger, charger cover and the UV sanitiser in the

dishwasher.

Toothbrush handle

1 Remove the brush head and rinse the metal

shaft area with warm water.

Do not push on the rubber seal on the metal shaft with sharp objects, as this may cause damage.

2 Use a damp cloth to wipe the entire surface of

the handle.

Brush head

Rinse the brush head and bristles after each use.

2 Remove the brush head from the handle and

rinse the brush head connection at least once a week with warm water.

+ 40 hidden pages