Philips HX6100, HX6150, HX6902, HX6910, HX6911 Service Manual

HX6100, HX6150, HX6902,

Sonic toothbrush

HX6910, HX6911, HX6912,
HX6930, HX6932, HX6933,
HX6942, HX6952, HX6982

Philips Domestic Appliance and Personal Care

Service Manual

PRODUCT INFORMATION

Sanitizing

With the UV sanitizer you can clean your brush head after every
use. After brushing, rinse the brush head and shake off excess
water. To open the sanitizer door, press the door release button.
Place the brush head on one of the two pegs in the sanitizer so
that the bristles are directly facing the light bulb. Close the door
and press the green power on/off button once to start the UV
clean cycle. It runs for 10 minutes then automatically shuts off.
The sanitizer is in operation when the blue light glows through
the Philips logo and the UV clean LED flashes slowly.
Note: The sanitizer stops if the door is opened during operation.

Easy-start

The brushing power will gently increase to full power over the
first 14 brushings.
The Easy-start feature is active if you hear 2 beeps immediately
after turning on your toothbrush.
Once you reach the optimal brushing power, after the 14
brushing, you will no longer hear the double beep at the
beginning of the brushing routine.
Easy-start can also be switched off. To deactivate and to
reactivate the Easy-start feature, see directions for use.

Smartimer

Automatically sets the brushing time to 2 minutes.
After these 2 minutes the product switches off automatically.
If you wish to pause, or stop brushing during the 2- minute
cycle, press the on/off button. When you press the on/off button
again, the Smartimer will pick up where you left off.

Published by Philips Consumer Lifestyle Printed in the Netherlands © Copyright Reserved Subject to modification

th

11/08

Programmable brushing modes

The programmable brushing allow you to customize the

brushing action. There are three different brushing modes.
Clean mode is the standard mode for superior teeth cleaning.
Sensitive mode

sensitive gums and teeth.
Massage mode provides gentle gum stimulation. .

Programmable brushing routines

The programmable brushing modes and routines allow you to

customize the length of brushing time. Choose 1, 2(factory

default) or 3 minute time intervals.

The 1-minute Go Care
every 15 seconds.
The 2-minute Clean brushing routine has Quadpacer beeps
every 30 seconds.
The 3-minute Max Care

every 45 seconds.
Note: The Quadpacer feature cannot be deactivated on the Go
Care and Max Care brushing routines.

Quadpacer

The Quadpacer feature ensures that you brush all four sections
of your mouth evenly and thoroughly. You will hear a short
beep and notice a brief pause in brushing action. This is the
signal to move to the next section of your mouth. To deactivate
and to reactivate the Quadpacer feature, see directions for use.

provides gentle, yet thorough cleaning for

brushing routine has Quadpacer beeps

brushing routine has Quadpacer beeps

HX6100, HX6150, HX6902,
HX6910, HX6911, HX6912,
HX6930, HX6932, HX6933,
HX6942, HX6952, HX6982

Deluxe recharge gauge

Indicates amount of charge left in battery
3 green LEDs: 75-100%
2 green LEDs: 50-74%
1 green LED: 25-49%
1 flashing yellow LED: less than 25%
If the battery charge of your Sonicare is low, you will hear 3

beeps at the end of the brushing cycle and the charge indicator
LED flashes yellow for 30 seconds.

When the handle is placed in the charger, the green charge

indicator LEDs will blink in the above patterns indicating the
level of charge.

Reminder bristles

Reminder bristles are introduced to remind the consumer to
replace their BHs at the recommended replace me nt t ime.
The color of the reminder bristles wears out as you use the
brush head and starts fading from the tip downward. When the
reminder bristles have faded half way it is time to replace the
brush head.

SAFETY INFORMATION

- Consult your physician prior to using Sonicare if you have
medical concerns.

- Sonicare has been tested and is compliant with safety standards
for electromagnetic devices.

- Do not place or store the charger or sanitizer where it can fall or
be pulled into a bathtub, sink or toilet.

- Discontinue use of the sanitizer if the UV light bulb remains on
when the door is open. UV light can be harmful to the human
eye and skin. This device should be kept out of reach of
children at all times.

- The UV light bulb is hot during and immediately after the
sanitizing cycle. Do not touch the UV light when it is hot.

- DO NOT plug the charger into an outlet with incorrect voltage.
This product is designed to operate within a range of 100 to 240

volts. Voltage converters and plug adapters DO NOT guarantee
voltage compatibility. Never force the plug into an outlet.

TECHNICAL INFORMATION

Toothbrush Handle

- Voltage : 4.05 Volts d.c. at full charge

- Power consumption : 2 watts

- Charging time : Empty-to-full: 24 hours

- Operating time : Full-to-empty: 40 minutes

- Battery type : Lithium Ion

Travel Charger

- Voltage / Frequency : 100-240V, 50 - 60 Hz

- Power consumption :

UV Sanitizer / Charger

- Voltage / Frequency : 100-240V, 50 - 60 Hz

- Power consumption : 1.0 watts @ 100V / 1.4 watts @
240V (Charge Mode Only)

5.8 watts @ 100V / 6.5 watts @
240V (UV and Charge Mode)

0.4 watts @ 100V / 1.4 watts @ 240V

11/08

2-4