Philips HX6762/43 User Manual

HealthyWhite

700 ser ies

Recha rgeab le sonic toot hbru sh

EN: User manual

RU: Руководство пользователя KZ: Пайдаланушы нұсқаулығы

English 6

Русский 16 Қазақша 29

English

Introduction

Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at

www.philips.com/welcome.

Important

Read this user manual carefully before you use the appliance and save it for future reference.

Danger

- Keep the charger away from water. Do not place or store it over or near water contained in a bathtub, washbasin, sink etc. Do not immerse the charger in water or any other liquid. After cleaning, make sure the charger is completely dry before you connect it to the mains.

Warning

- The mains cord cannot be replaced. If the mains cord is damaged, discard the charger.

- Always have the charger replaced with one of the original type in order to avoid a hazard.

- Do not use the charger outdoors or near heated surfaces.

- If the appliance is damaged in any way (brush head, toothbrush handle or charger), stop using it. This appliance contains no serviceable parts. If the appliance is damaged, contact the Consumer Care Center in your country (see chapter 'Warranty and support').

- This appliance can be used by children aged from 8 years and above and by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised.

English

Caution

- Do not clean the brush head, the handle or the charger in the dishwasher.

- If you have had oral or gum surgery in the previous 2 months, consult your dentist before you use the toothbrush.

- Consult your dentist if excessive bleeding occurs after using this toothbrush or if bleeding continues to occur after 1 week of use. Also consult your dentist if you experience discomfort or pain when you use the Philips Sonicare.

- The Philips Sonicare toothbrush complies with the safety standards for electromagnetic devices. If you have a pacemaker or other implanted device, contact your physician or the device manufacturer of the implanted device prior to use.

- If you have medical concerns, consult your doctor before you use the Philips Sonicare.

- This appliance has only been designed for cleaning teeth, gums and tongue. Do not use it for any other purpose. Stop using the appliance and contact your doctor if you experience any discomfort or pain.

- The Philips Sonicare toothbrush is a personal care device and is not intended for use on multiple patients in a dental practice or institution.

- Stop using a brush head with crushed or bent bristles. Replace the brush head every 3 months or sooner if signs of wear appear. Do not use other brush heads than the ones recommended by the manufacturer.

- If your toothpaste contains peroxide, baking soda or bicarbonate (common in whitening toothpastes), thoroughly clean the brush head with soap and water after each use. This prevents possible cracking of the plastic.

Electromagnetic fields (EMF)

This Philips appliance complies with all applicable standards and regulations regarding exposure to electromagnetic fields.

Your Philips Sonicare (Fig. 1)

1 Hygienic travel cap

English

2 Brush head 3 Interchangeable colour code ring (for select models) 4 Handle with soft grip 5 Power on/off button 6 Brushing modes 7 Charge light indicator

Deluxe charge indicator (specific types only)

Standard charge indicator (specific types only)

8 Standard charger (specific types only)

a Charger cover with brush head holder b Travel charger

9 Deluxe charger (specific types only)

a Charger cover with brush head holder b Travel charger c Charger base with cord wrap facility

Note: The content of the box may vary based on the model purchased.

Preparing for use

Changing the colour code ring (for select models)

Sonicare brush heads come with interchangeable colour code rings to identify your brush head.

To change the colour code ring: 1 Pull the colour code ring from the bottom of the brush head. (Fig.

2 Install a new ring by slipping one edge of the new ring over the

bottom of the brush head. (Fig. 3)

Attaching the brush head

1 Align the brush head so the bristles point in the same direction as

the front of the handle. (Fig. 4)

2 Firmly press the brush head down onto the metal shaft until it

stops.

English

Note: When the brush head is attached, it is normal that there is a small gap between the brush head and the handle.

Charging the appliance

1 Put the plug in the wall socket. 2 Place the handle on the charger.

The battery charge indicator next to the battery symbol flashes to indicate that the toothbrush is charging.

Battery charge indicator

The battery charge indicator shows the approximate remaining battery charge. (Fig. 5)

Deluxe charge indicator (specific types only):

Solid green: 50-100%

Flashing green: 10-49%

Flashing yellow: less than 10%

Standard charge indicator (specific types only):

Solid green: 50-100%

Flashing green: less than 50%

Note: When the battery is low, you hear 3 beeps after the completion of the brushing cycle and the battery charge indicator flashes for 30 seconds.

Note: To keep the battery fully charged, you may keep your Philips Sonicare on the charger when not in use. It takes 24 hours to charge the battery fully.

Using your Philips Sonicare

Brushing instructions

1 Wet the bristles and apply a small amount of toothpaste. 2 Place the toothbrush bristles against the teeth at a slight angle (45

degrees), pressing firmly to make the bristles reach the gumline or slightly beneath the gumline. (Fig. 6)

Note: Keep the center of the brush in contact with the teeth at all times.

English

3 Press the power on/off button to turn on the Philips Sonicare. 4 Apply light pressure to maximize Philips Sonicare’s effectiveness

and let the Philips Sonicare toothbrush do the brushing for you. Do not scrub.

5 Gently move the brush head slowly across the teeth in a small

back and forth motion so the longer bristles reach between your teeth. Continue this motion throughout the brushing cycle.

6 To clean the inside surfaces of the front teeth, tilt the brush handle

semi-upright and make several vertical overlapping brushing strokes on each tooth.

Note: To make sure you brush evenly throughout the mouth, divide your mouth into 4 sections using the Quadpacer feature (see chapter ‘Features’).

7 Begin brushing in section 1 (outside upper teeth) and brush for 30

seconds before you move to section 2 (inside upper teeth). Continue brushing in section 3 (outside lower teeth) and brush for 30 seconds before you move to section 4 (inside lower teeth) (Fig.

7).

8 After you have completed the brushing cycle, you can spend

additional time brushing the chewing surfaces of your teeth and areas where staining occurs. You can also brush your tongue, with the toothbrush turned on or off, as you prefer. (Fig. 8)

Your Philips Sonicare is safe to use on:

- Braces (brush heads wear out sooner when used on braces).

- Dental restorations (fillings, crowns, veneers). Note: When the Sonicare is used in clinical studies, the handle

should be fully charged. Deactivate the Easy-start feature and for areas where excess staining occurs, an additional 30 seconds of brushing time can be spent to assist with stain removal.

White mode brushing instructions

The Clean and White mode consists of 2 minutes of Clean mode to clean the whole mouth and an additional 30 seconds of White mode to focus on the visible front teeth.

1 Brush the first 2 minutes as explained in section 'Brushing

instructions'.

English

2 After the 2 minutes of Clean mode, the White mode starts with a

change in brushing sound and motion. This is your signal to start brushing the upper front teeth for 15 seconds.

3 At the next beep and pause, move to the bottom front teeth for

the final 15 seconds of brushing (Fig. 9).

Brushing modes

Philips Sonicare automatically starts in the default Clean mode. To select a different brushing mode:

1 Press the on/off button to toggle between modes.

The green LED indicates the selected mode.

Note: You can only switch between modes when the toothbrush is switched on.

- Clean mode: Standard mode for superior teeth cleaning.

- Sensitive mode (specific types only): Gentle yet thorough cleaning for sensitive gums and teeth.

- Clean and White mode: 2 minutes of Clean mode with an additional 30 seconds of White mode to focus on the visible front teeth.

Note: When the Sonicare is used in clinical studies, the default 2-minute Clean mode must be selected. However, in whitening/stain reduction studies, the Clean and White mode must be selected. The handle should be fully charged and the Easy-start feature deactivated.

Features

Easy-start

This Philips Sonicare comes with the Easy-start feature activated.

The Easy-start feature gently increases the power over the first 14 brushings to help you get used to the brushing with the Philips Sonicare.

Note: Each of the first 14 brushings must be at least 1 minute in length to properly advance through the Easy-start ramp-up cycle.

English

Note: When the Clean and White mode is selected, the Easy-start feature is inactive.

Activating or deactivating the Easy-start feature

1 Attach the brush head to the handle. 2 Place the handle in the plugged-in charger.

To activate Easy-start:

Press and hold the power on/off button for 2 seconds. You hear 2 beeps to indicate that the Easy-start feature has been activated.

To deactivate Easy-start:

Press and hold the power on/off button for 2 seconds. You hear 1 beep to indicate that the Easy-start feature has been deactivated.

Note: Using the Easy-start feature beyond the initial ramp-up period is not recommended and reduces Philips Sonicare effectiveness in removing plaque.

Smartimer

The Smartimer indicates that your brushing cycle is complete by automatically turning off the toothbrush at the end of the brushing cycle.

Dental professionals recommend brushing no less than 2 minutes twice a day.

If you want to pause or stop brushing during the 2-minute brushing cycle, press the on/off button. Press the on/off button again and the Smartimer picks up where you left off. The Smartimer automatically resets to the beginning of a 2-minute cycle if:

- you stop brushing for 30 seconds or longer.

- you put the handle in the charger.

Quadpacer (select models)

The Quadpacer is an interval timer that has a short beep and pause to remind you to brush the 4 sections of your mouth evenly and thoroughly. (Fig. 7)

When you use the two-minute Clean or Sensitive mode, you hear a short beep and a pause in brushing action at 30, 60 and 90 seconds.

English

When you use the Clean and White mode, you hear and feel a change in the brush head sound and motion after 2 minutes of Clean mode. Then move the brush head to the visible upper front teeth and brush them for 15 seconds. At the final beep and pause, move to the visible lower front teeth and brush them for 15 seconds. (Fig. 9)

Cord wrap facility (specific types only)

If your Sonicare type includes the deluxe charger cover and base, the travel charger is pre-installed inside the cover. If you want to shorten the mains cord, you can store excess cord in the cord wrap facility in the charger base.

1 To separate the charger cover from the charger base, press the

two grey snap bars on the charger base and pull the white charger cover upwards. (Fig. 10)

2 Wrap excess mains cord around the grey charger base as shown in

the picture. Make sure you wrap the cord on the inside of the two snap levers. (Fig. 11)

3 When you have stored the excess cord, guide the mains cord

through the small groove in the rear of the grey charger base. (Fig.

12)

4 To reattach the charger cover, press it down over the charger base

until it snaps into place.

Tip: For extra convenience during travel, you can remove the travel charger and use it without the charger cover and charger base.

Cleaning

Do not clean brush heads, the handle, the charger or the charger covers in the dishwasher.

Toothbrush handle

1 Remove the brush head and rinse the metal shaft area with warm

water. Make sure you remove any residual toothpaste (Fig. 13).

Caution: Do not push on the rubber seal on the metal shaft with sharp objects, as this may cause damage.

2 Wipe the entire surface of the handle with a damp cloth.

English

Brush head

1 Rinse the brush head and bristles after each use (Fig. 14). 2 Remove the brush head from the handle and rinse the brush head

connection with warm water at least once a week.

Charger

1 Unplug the charger before you clean it. 2 Wipe the surface of the charger with a damp cloth. Make sure you

remove any toothpaste or other residue from the charger surfaces.

Storage

If you are not going to use the Sonicare for an extended period of time, unplug the charger from the electrical outlet, clean it and store it in a cool and dry place away from direct sunlight.

Replacement

Brush head

Replace Philips Sonicare brush heads every 3 months to achieve optimal results. Use only Philips Sonicare replacement brush heads.

Recycling

- Do not throw away the product with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment.

- This product contains a built-in rechargeable battery which shall not be disposed of with normal household waste. We strongly advise you to take your product to an official collection point or a Philips service centre to have a professional remove the rechargeable battery.

- Follow your country’s rules for the separate collection of electrical and electronic products and rechargeable batteries. Correct disposal helps prevent negative consequences for the environment and human health.

+ 30 hidden pages