Philips HX6733-90 User Manual

Quick start guide

Review IMPORTANT SAFEGUARD section of your
user manual prior to the first use.

Before
you start

Contents:

HealthyWhite brushing modes and brush heads:

1

Your Sonicare HealthyWhite is set to Clean mode. Push the on/off button to toggle between modes.
A green LED indicates the selected mode.

Modes:

Clean mode: Standard mode for complete cleaning.
Sensitive mode: Gentle, yet thorough cleaning for sensitive gums and teeth.
Clean and White mode: 2 minutes of Clean mode with an additional 30 seconds of White mode to focus on

your visible front teeth.

Brush heads:

DiamondClean brush head: Diamond shaped bristles provide exceptional cleaning and whiter teeth.

Questions? Call Philips Consumer Care at 1-800-682-7664

2 Sonicare HealthyWhite handles
2 DiamondClean brush heads (Standard)
1 UV Sanitizer with integrated charger,
cord wrap and brush head storage
1 Multi-voltage, compact travel charger
2 Travel cases

Charge for 2 hours

clean

sensitive

Clean

and

White

minimum

On/Off

Modes

Brushing instructions:

2

Before turning your Sonicare on, wet the bristles and apply a small amount of toothpaste.

Place bristles against your teeth at a slight angle towards the gumline. Press the on/off button.

Hold the handle with a light grip and gently move the brush head slowly across the teeth in
a small back and forth motion so the longer bristles reach between your teeth. Continue this
motion throughout your brushing cycle.

You may experience a slight tickling/tingling sensation when using your Sonicare toothbrush for
the first time. As you become accustomed to brushing with Sonicare, this sensation will diminish.

UV Sanitizer:

3

The UV sanitizer uses a specially designed UV light bulb to eliminate
germs on your brush head.

After brushing, rin

Place the brush head(s) on the peg(s) located inside the UV sanitizer.
Make sure bristles face the UV light bulb. Do not place the travel cap
on the brush head during sanitization.

Close the door and press the green power on/off button once to
select the UV clean cycle.

The sanitizer is in operation when the blue light glows through the
window. When the sanitizing cycle is complete, the sanitizer
automatically shuts off.

se the brush head and shake off excess water.

4235 020 53831