Philips HTR5204, HTS5710H-31 User Manual

1
Connect
COAXIAL
DIGITAL OUT
CVBS OUT
S-VIDEO OUT
AUDIO
ANTENNA-IN
TV-OUT
TO TV
EXT1
TO VCR/SAT
EXT2
P
B
P
R
Y
R
L
TO VCR
TO TV
A
Connecting Recorder and TV
A Unplug the existing antenna cable from your TV and
connect it to the ANTENNA IN socket on the recorder.
z If you have a Cable Box or Satellite Receiver,
connect a scart cable from the EXT2-TO VCR/ SAT scart socket on the recorder to the SCART
(TO VCR) socket on the Cable Box/Satellite Receiver.
Note The antenna connection may not be required,
depending on the capabilities of your Cable Box / Satellite Receiver. Refer to its user manual for more information.
B Connect an RF antenna cable (supplied) from the
TV-OUT socket on the recorder to the Antenna In socket on the TV.
C Connect a scart cable (supplied) from the
EXT1-TO TV scart socket on the recorder to the SCART socket on your TV.
D Plug in the power cable from the recorder to an AC
power outlet.
Note Refer to the accompanying User Manual for
other possible connections.
AM/
12 mm
A
B
C
A
Connect the various coloured plugs from the speakers and subwoofer to the same coloured sockets on the AV Receiver.
B Connect the FM antenna to the inner pin of the
FM 75  socket. Extend the antenna for optimum reception.
C Unfold the AM/MW loop antenna and fix the claw
into the slot. Push the tabs and insert the wires into the AM/MW sockets.
Note Keep the antennas away from the electronic
devices to prevent unwanted interference.
D Plug in the power cable from the AV Receiver to an
AC power outlet.
2
Set up
COAXIAL DIGITAL OUT
CVBS OUT
S-VIDEO OUT
VIDEO OUT AUDIO OUT
AUDIO
ANTENNA-IN
TV-OUT
TO TV
EXT1
TO VCR/SAT
EXT2
MAINS
P
B
P
R
Y
R
L
AM/
COAXIAL
DIGITAL OUT
AUDIO OUT
AUDIO
P
B
P
R
Y
R
L
A
This connection enables you to hear the recorder playback from the AV Receiver. It supports multi­channel surround sound output.
z
Connect the coaxial cable (supplied) between the
COAXIAL OUT socket on the recorder and COAXIAL IN socket on the AV Receiver.
B
Connecting Speakers and radio
antennas to AV Receiver
C
Connecting Recorder and AV Receiver
Antenna
Television ( rear)
Philips Recorder (rear)
Philips AV Receiver (rear)
Philips Recorder (rear)
A
Finding the viewing channel
A Press 2 STANDBY-ON on the recorder. B Turn on the TV.
You should see the installation menu.
Dansk
Français
Italiano Nederlands
Norsk
Español
Deutsch
Menu Language
English
Please select your language. Denes the languages of all on-screen menu displays.
C In case you don’t see the recorder’s setting menu,
press the Channel Down button on the TVs remote control repeatedly (or AV, SELECT, ° button) until you see the menu. This is the correct viewing channel for the recorder.
B
Start initial installation
Use the recorder’s remote control and follow the on­screen instructions to complete the installation.
A Select the desired menu language, your country and
the TV shape.
Note Press OK or the Green button on the
remote control to go to the next screen.
B Press OK to start automatic analogue channel
search.
Previous Skip
Channel search
Start Auto search
C Once complete, press the Green button to
continue.
D Enter the correct time in the entry field, press OK
followed by the Green button to continue. Proceed the same for date entry.
E To continue with the GUIDE Plus+ installation,
press the Green button.
z
Otherwise, press the Red button to skip.
3
Enjoy
Cable TV/
Satellite Receiver
About the Time Shift Buffer (TSB)
Once you turn on the recorder, the selected TV programme will be stored in a temporary hard disk storage called Time Shift Buffer ‘TSB’. The ‘TSB’ can store up to 6 hours of programmes temporarily.
Press INFO to display the Time Shift video bar.
Notes:
- The contents in the time shift video bar will be
cleared when you press STANDBY ON (2).
- The blue LED on the recorder will be lit up when the Time Shift Buffer is active or when you playback a recording from the hard disk drive.
Watch TV – Pause live TV
Your Philips Recorder allows you to control the TV programme. You can PAUSE it as if you were in control of the live broadcast.
A Turn on your recorder to the live TV mode and
press P +/- to select a TV programme.
z
To hear recorder playback from the AV Receiver,
turn on the AV Receiver. If no sound, press SOURCE repeatedly to change the input source mode for the AV Receiver to ‘COAX IN’.
B Press PAUSE LIVE TV to suspend it. C Press PAUSE LIVE TV
again to continue.
D To return to live broadcast, press LIVE TV.
About the internal hard disk drive
This recorder’s hard disk drive can be used as a Media Jukebox, allowing you to store and playback your TV programmes, videos, music and photos  les.
Press HOME on the remote control to access your contents stored in the { Hard Disk }.
Current time of playback
Selected clips for recording
Programmes stored in the ‘TSB’
Start time of the programme
Present time
SOURCE
HOME
LIVE TV
TIMER
PAUSE LIVE TV
GUIDE Plus+
C
Install the GUIDE Plus+ system
z
Follow the on-screen instructions to select your
language, country and enter the postal code of your area.
Note If no or wrong postal code is entered, it will
cause no GUIDE Plus+ (EPG) service information.
D
Load the TV listing data
A Press TIMER (GUIDE Plus+)
to exit GUIDE Plus+ system. Leave the recorder in ‘standby’ mode and turn ‘on’ the set-top box overnight to collect the TV listing data, this may take up to 24 hours.
Note If you tune to your Host Channel before going
to ‘standby’ mode, this recorder will start downloading the TV listings data immediately.
B Check the { Editor } screen the next day to ensure
the source and programme numbers are matching for all channels.
F
Turn on the AV Receiver and  ne­tune the speakers
A Press 2 STANDBY-ON on the AV Receiver.
z
If you cannot hear the playback from the recorder,
press SOURCE on the AV Receiver repeatedly until ‘COAX IN’ appears on the display panel.
To adjust or  ne-tune the speaker settings
B Press and hold PROGRAM on the AV Receiver for
more than five seconds.
C Press .or > to toggle between ‘CENTER
DELAY’, ‘REAR DELAY’, ‘TEST TONE’ and ‘EXIT’ setting options.
D Press PROGRAM to select an option. E Rotate the VOL control to scroll through the
various delay time options, then press PROGRAM to confirm your setting.
z
Repeat steps 3~5 for other settings options.
F To exit the speaker setting mode, press .or >
until ‘EXIT’ appears.
SUBWOOFER
FRONT
RIGHT
FRONT
LEFT
REAR
RIGHT
REAR
LEFT
FRONT CENTRE
Philips AV Receiver (rear)
FM antenna
AM/MW loop
antenna
22:04:30
Now
3
Enjoy
Hard Disk / DVD Recorder & Digital AV Receiver
HTS5710H
Record to hard disk
Record current TV programme
A
A Press REC to start recording. It can record up to
6 hours.
Note To set the recording time length, press REC
repeatedly to extend the recording time in 30-minute increments, up to 6 hours.
B To stop the recording before the scheduled time,
press STOP.
Mark a speci c content in the Time
B
Shift Buffer for recording
21:00
Cancel Rec.
A Press left or right to search for the scene
where you want to record.
B Press REC
Note Pressing the Red button will cancel the
C Press right to search for the scene to end the
recording, then press STOP.
Note The title will be marked in red and the
to start recording from here.
recording.
recording will only take effect when you turn off the recorder.
23:30
22:13
HDD LIST
REC
More Info
TIMER
GUIDE Plus+
Using the GUIDE Plus+ system
C
Make sure that the GUIDE Plus+ TV listing data download is completed.
A Press TIMER (GUIDE Plus+).
It shows the list of TV programmes that are currently broadcast and the next 8 days of TV programmes.
Record
B Press down to select a TV channel.
Notes
– To see an overview of all the available channels,
press the Yellow button on the remote control.
– To go directly to the previous day’s or the next
day’s TV listing, press í/ë.
– To scroll up or down a page, press P +/-.
C Press left or  right to select a TV programme. D Press the Red
the highlighted programme for recording.
Note You can store up to 25 programmes for
recording.
Copy TV programmes or  les
Copy TV programmes from hard
A
INFO
HOME
STOP
disk
A Insert a recordable DVD into the recorder. B Press HDD LIST on the remote control. C Select a title to copy and press the Green button
on the remote control for { Copy }.
D The making disc copy information appears. Press
the Green button again to start copying.
Note It is not possible to copy the TV recordings to
USB device.
button on the remote control to set
Channels Home
Copy  les from USB
B
You can only copy the data  les (MP3, WMA, DivX and JPEG) from your USB device to the recorder’s hard disk drive or recordable DVD.
A Insert your USB device to the USB port at the front
panel of the recorder.
B Press HOME and select { USB }. C Use   keys to reach the file you want to
copy.
D Press the Green button for { Copy }.
Target for copy. Choose destination for copy.
To Hard Disk
To Disc
E Select the destination for copying and press OK.
Note If select { To Disc }, insert an empty
recordable DVD into the recorder.
F Press OK again to start copying.
Copy  les from Disc
C
Copy prohibited contents cannot be copied to this recorder.
A Insert a CD/DVD into the recorder. B Press HOME and select { Disc Tray }. C Use   keys to reach the title/file you want
to copy.
D Press the Green button for { Copy }.
Target for copy. Choose destination for copy.
To Hard Disk
To USB
E Select the destination for copying and press OK.
Note Only data  les are able to copy to USB device.
F Press OK again to start copying.
Need help?
User Manual
See the user manual that came with your Philips Recorder or AV Receiver
Online
Register your product and get support at www.philips.com/welcome
Start playback
Playback from hard disk
A
A Press HOME.
Source Content
Hard Disk
Disc Tray
USB
B Select { Hard Disk } and press right. C Select the contents type and press right. D Use     keys to reach the title/file you want
to play and press u to start playback.
Playback from disc
B
A Hold down STOP until the disc tray opens. Load a
disc and close the disc tray.
B Press HOME and select { Disc Tray }. C Use     keys to reach the title/file you want
to play and press u to start playback.
Playback from USB device
C
A Insert the USB device to the USB port. B Press HOME and select { USB }. C Use     keys to reach the contents list. D Select the contents type and press right. E Select a data file
press u to start playback.
Recordings
Video les
Music
Photo
(MP3, WMA, DivX and JPEG)
2007 © Koninklijke Philips N.V. All rights reserved. 12 NC 3139 245 28092 www.philips.com
and
Quick Start Guide
Connect
1
Set up
2
Enjoy
3
What’s in the box?
HTR5204DVDR3570H
VOL
SOURCE
PHONES MP3 LINE-IN
HTR5204
User
Manual
MP3 LINE-IN
cable
1 centre, 2 front, 2 rear speakers
and subwoofer
Audio cable
FM wire antenna
Hard Disk/ DVD Recorder
DVDR3570H
User
Manual
RF antenna cable
(connect between
recorder and TV)
Scart cable
STANDBY-ONSURROUND SOUND TREBLE BASS PROGRAM
Remote Control
(connect between
recorder and receiver)
TUNING
Digital AV Receiver
PAUSE LIVE TV
SUBTITLE
AUDIO
INFO SELECT EDITSCART
and 2 batteries
Coaxial cable
Power cable
AM/MW
loop antenna
Loading...