Philips HTL2183B/05 user manual

Always there to help you

Question?

Contact

Philips

Register your product and get support at

www.philips.com/support

HTL2183B

User manual

Contents

1 Important 2

Safety 2
Important notes for users in the U.K. 3
Care for your product 3
Care of the environment 3
Compliance 4
Help and support 4

2 Your product 5

Main unit 5
Remote control 5
Connectors 6

3 Connect 7

Placement 7
Connect audio from TV 7
Connect audio from other devices 8

4 Use your product 10

Adjust the volume 10
Choose your sound 10
Play audio through Bluetooth 10
MP3 player 11
USB storage devices 11
Auto standby 12
Set display brightness 12
Apply factory settings 12

5 Update software 12

Check software version 12
Update software via USB 12

6 Wall mount 13

7 Productspecications 14

8 Troubleshooting 15

1EN

1 Important

Read and understand all instructions before you
use your product. If damage is caused by failure
to follow instructions, the warranty does not
apply.

Safety

Riskofelectricshockorre!

• Before you make or change any
connections, make sure that all devices are
disconnected from the power outlet.

• Never expose the product and accessories
to rain or water. Never place liquid
containers, such as vases, near the product.
If liquids are spilt on or into the product,
disconnect it from the power outlet
immediately. Contact Consumer Care to
have the product checked before use.

• Never place the product and accessories

near naked ames or other heat sources,

including direct sunlight.

• Never insert objects into the ventilation
slots or other openings on the product.

• Where the mains plug or an appliance
coupler is used as the disconnect device,
the disconnect device shall remain readily
operable.

• Batteries (battery pack or batteries
installed) shall not be exposed to excessive

heat such as sunshine, re or the like.

• Disconnect the product from the power
outlet before lightning storms.

• When you disconnect the power cord,
always pull the plug, never the cable.

Riskofshortcircuitorre!

• For identication and supply ratings, see
the type plate at the back or bottom of
the product.

• Before you connect the product to the
power outlet, ensure that the power
voltage matches the value printed on the

back or bottom of the product. Never
connect the product to the power outlet if
the voltage is different.

Riskofinjuryordamagetothisproduct!

• For wall mounting, this product must be
securely attached to the wall in accordance
with the installation instructions. Use
only the supplied wall mount bracket (if
available). Improper wall mounting may
result in accident, injury or damage. If you
have any query, contact Consumer Care in
your country.

• Never place the product or any objects
on power cords or on other electrical
equipment.

• If the product is transported in
temperatures below 5°C, unpack the
product and wait until its temperature
matches room temperature before
connecting it to the power outlet.

• Parts of this product can be made of
glass. Handle with care to avoid injury and
damage.

Riskofoverheating!

• Never install this product in a conned
space. Always leave a space of at least four
inches around the product for ventilation.
Ensure curtains or other objects never
cover the ventilation slots on the product.

Riskofcontamination!

• Do not mix batteries (old and new or
carbon and alkaline, etc.).

• Danger of explosion if batteries are
incorrectly replaced. Replace only with the
same or equivalent type.

• Remove batteries if they are exhausted or
if the remote control is not to be used for
a long time.

• Batteries contain chemical substances, they
should be disposed of properly.

Riskofswallowingbatteries!

• The product/remote control may contain
a coin/button type battery, which can be
swallowed. Keep the battery out of reach
of children at all times! If swallowed, the

2 EN

battery can cause serious injury or death.
Severe internal burns can occur within two
hours of ingestion.

• If you suspect that a battery has been
swallowed or placed inside any part of the
body, seek immediate medical attention.

• When you change the batteries, always
keep all new and used batteries out of
reach of children. Ensure that the battery
compartment is completely secure after
you replace the battery.

• If the battery compar tment cannot be
completely secured, discontinue use of the
product. Keep out of reach of children and
contact the manufacturer.

This is CLASS II apparatus with double
insulation, and no protective earth provided.

Use only the power supplies listed in the user
manual.

Caution: To conform with the LVD directive
(2014/35/EU), do not detach the plug from the
power cord.

How to connect a plug

The wires in the power cord are colored as
follows: blue = neutral (N), brown = live (L).
If the colors do not correspond with the colors
on your plug, identify the terminals in your plug
as follows:

a Connect the blue wire to the terminal

marked N or colored black.

b Connect the brown wire to the terminal

marked L or colored red.

c Do not connect either wire to the earth

terminal in the plug, marked E (or e) or
colored green (or green and yellow).

Before you replace the plug cover, make sure
that the cord grip is clamped over the sheath
of the cable and not just over the two wires in
the cable.

Copyright in the U.K.

Recording and playback of material may require
consent. See Copyright Act 1956 and The
Performer’s Protection Acts 1958 to 1972.

Important notes for users in the U.K.

Mains fuse

This information applies only to products with a
UK mains plug.

This product is tted with an approved non-

molded plug. If you replace the fuse, use one
with:

• the ratings shown on the plug,

• a BS 1362 approval, and

• the ASTA approval mark.

Contact your dealer if you are not sure about
what type of fuse to use.

Care for your product

Use only microber cloth to clean the product.

Care of the environment

Disposal of your old product and battery

Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.

3EN

This symbol on a product means that the
product is covered by European Directive
2012/19/EU.

This symbol means that the product contains
batteries covered by European Directive
2013/56/EU which cannot be disposed of with
normal household waste.
Inform yourself about the local separate
collection system for electrical and electronic
products and batteries. Follow local rules and
never dispose of the product and batteries
with normal household waste. Correct disposal
of old products and batteries helps prevent
negative consequences for the environment and
human health.

Removing the disposable batteries

To remove the disposable batteries, see battery
installation section.

• watch video tutorials (available only for
selected models)

• nd answers to frequently answered
questions (FAQs)

• email us a question

• chat with our support representative.

Follow the instructions on the website to select
your language, and then enter your product
model number.
Alternatively, you can contact Consumer Care
in your country. Before you contact, note down
the model number and serial number of your

product. You can nd this information on the

back or bottom of your product.

Compliance

This product complies with the radio
interference requirements of the European
Community.
Hereby, Gibson Innovations declares that this
product is in compliance with the essential
requirements and other relevant provisions

of Directive 2014/53/EU. You can nd the

Declaration of Conformity on www.p4c.philips.
com.

Help and support

For extensive online support, visit www.philips.
com/support to:

• download the user manual and the quick
start guide

4 EN

2 Your product

b

a

c
d

f

g

h

i

e m

j

k

l

Remote control

Congratulations on your purchase, and

welcome to Philips! To fully benet from the
support that Philips offers(e.g. notication

of product software upgrade), register your
product at www.philips.com/welcome.

Main unit

This section includes an overview of the main
unit.

a

Switch this product on or to standby.

b SOURCE

Select an input source for this product.

c Volume +/-

Increase or decrease volume.

d Display panel

This section includes an overview of the
remote control.

ca b d

a (Standby-On)

Switch this product on or to standby.

b Source buttons

COAX: Switch your audio source to the

coaxial connection.
OPTICAL: Switch your audio source to
the optical connection.
AUX: Switch your audio source to the
AUX connection.

5EN