Always there to help you
Question?
Contact
Philips
Register your product and get support at
www.philips.com/support
Quick start guide
HTL1193B
HTL1193B_79_QSG_V1.0.indd 1 5/19/2015 4:27:52 PM
HTL1193B_79_QSG_V1.0.indd 2 5/19/2015 4:27:52 PM
Important
Read and understand all instructions before you use your product. If damage is caused by failure to follow instructions, the warranty does not apply.
Help and support
For extensive online support, visit www.philips.com/support to:
• download the user manual and the quick start guide
• watch video tutorials (available only for selected models)
• nd answers to frequently answered questions (FAQs)
• email us a question
• chat with our support representative.
Follow the instructions on the website to select your language, and then
enter your product model number.
Alternatively, you can contact Consumer Care in your country. Before you
contact, note down the model number and serial number of your prod-
uct. You can nd this information on the back or bottom of your product.
Safety
Risk of electric shock or re!
• Before you make or change any connections, make sure that all
devices are disconnected from the power outlet.
• Never expose the product and accessories to rain or water. Never
place liquid containers, such as vases, near the product. If liquids are
spilt on or into the product, disconnect it from the power outlet
immediately. Contact Consumer Care to have the product checked
before use.
• Never place the product and accessories near naked ames or other
heat sources, including direct sunlight.
• Never insert objects into the ventilation slots or other openings on
the product.
• Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
• Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, re or the like.
• Disconnect the product from the power outlet before lightning
storms.
• When you disconnect the power cord, always pull the plug, never
the cable.
Risk of short circuit or re!
• For identication and supply ratings, see the type plate at the back or
bottom of the product.
• Before you connect the product to the power outlet, ensure that the
power voltage matches the value printed on the back or bottom of
the product. Never connect the product to the power outlet if the
voltage is different.
Risk of injury or damage to this product!
• To prevent injury, this product must be securely attached to the
oor/wall in accordance with the installation instructions.
• Never place the product or any objects on power cords or on other
electrical equipment.
• If the product is transported in temperatures below 5°C, unpack the
product and wait until its temperature matches room temperature
before connecting it to the power outlet.
• Parts of this product can be made of glass. Handle with care to avoid
injury and damage.
1
HTL1193B_79_QSG_V1.0.indd 1 5/19/2015 4:27:52 PM
Power Cord
Quick start guide
Risk of overheating!
• Never install this product in a conned space. Always leave a space
of at least four inches around the product for ventilation. Ensure
curtains or other objects never cover the ventilation slots on the
product.
Risk of contamination!
• Do not mix batteries (old and new or carbon and alkaine, etc.).
• Danger of explosion if batteries are incorrectly replaced. Replace
only with the same or equivalent type.
• Remove batteries if they are exhausted or if the remote control is
not to be used for a long time.
• Batteries contain chemical substances, they should be disposed of
properly.
Risk of swallowing batteries!
• The product/remote control may contain a coin/button type battery,
which can be swallowed. Keep the battery out of reach of children at
all times! If swallowed, the battery can cause serious injury or death.
Severe internal burns can occur within two hours of ingestion.
• If you suspect that a battery has been swallowed or placed inside
any part of the body, seek immediate medical attention.
• When you change the batteries, always keep all new and used batteries out of reach of children. Ensure that the battery compartment
is completely secure after you replace the battery.
• If the battery compar tment cannot be completely secured, discontinue use of the product. Keep out of reach of children and contact
the manufacturer.
This is CLASS II apparatus with double insulation, and no protective earth
provided.
Care for your product
Use only microber cloth to clean the product.
Care of the environment
Disposal of your old product
Your product is designed and manufactured with high quality materials
and components, which can be recycled and reused.
Do not throw away the product with the normal household waste at the
end of its life, but hand it in at an ofcial collection point or recycling. By
doing this, you help to preserve the environment.
2
HTL1193B_79_QSG_V1.0.indd 2 5/19/2015 4:27:54 PM
Before using your product, read all accompanying safety
information
Quick start guide
Power Cord
3
HTL1193B_79_QSG_V1.0.indd 3 5/19/2015 4:27:54 PM
1
~200mm/7.9”
~50mm/2.0”
2
2x 2x
3.0-3.5mm/0.12”-0.14”
4mm/
0.16”
>25mm/0.98”
1
Position this product
4
HTL1193B_79_QSG_V1.0.indd 4 5/19/2015 4:27:56 PM
Loading...